Panasonic AWPH400P - HIGH PERFORMANCE P/T Support and Manuals
Get Help and Manuals for this Panasonic item
View All Support Options Below
Free Panasonic AWPH400P manuals!
Problems with Panasonic AWPH400P?
Ask a Question
Free Panasonic AWPH400P manuals!
Problems with Panasonic AWPH400P?
Ask a Question
Popular Panasonic AWPH400P Manual Pages
AWPH400 User Guide - Page 2
... compliance follow the attached installation instructions and do not make any unauthorized modifications.
Models AW-RP400, AW-RC400 only
Note:
The rating plate (serial number plate) is operated in accordance with the limits for a class A digital device, pursuant to correct the interference at their own expense. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. CAUTION:
TO REDUCE...
AWPH400 User Guide - Page 4
...6 Accessories 6 Precautions for use 6 Installation precautions 7 Parts and their function 8 Installation 12
$ Assembling the pan/tilt head 12 $ Setting the mounting direction switch 14 $ Setting the PCB switches 15 $ Installing the pan/tilt head 16 $ Mounting the camera 17 $ Attaching the wire 18 Replacing the consumable parts 19 Specifications 20
AW-RC400 Cable Compensation Unit 38...
AWPH400 User Guide - Page 6
...positions can be performed at the end of its service life, ask a specialized contractor to dispose of it...settings for tally 1 Wire mounting screws (with the general household garbage. For the procedure to remove the battery, refer to the section on replacing the battery in accordance with a total weight of the removed battery in "Replacing the consumable parts" (page 19).
Replace...
AWPH400 User Guide - Page 7
...by its rotating part. Doing so may give rise to malfunctioning.
≥ Leave a clearance of at least 3.3 ft (1 meter) from around the monitor when installing the unit.
≥ When mounting the camera on the unit,... when the pan/tilt head swivels, and set off-balance by hand. AW-PH400
Installation precautions
Indoor Pan/Tilt Head AW-PH400
≥ Do not install the unit on any of its sides....
AWPH400 User Guide - Page 9
..., M5 flat washers (3 of each provided as accessories) These parts are used to secure the camera mounting base to the rotary arm.
6 Tally lamp (accessory)...set to ON, the unit's power is connected to this base.
: Pan/tilt head mounting holes These four holes are used when installing the pan/tilt head.
; Bottom panel
< PROMPTER connector The prompter is turned on this connector. Parts...
AWPH400 User Guide - Page 10
...connecting cable.
Indoor Pan/Tilt Head AW-PH400
Parts and their function
= Guide pin Use this connector when using the cable ...camera. Connect this to be used to the CONTROL OUT TO PAN/TILT connector on the AW-PB504 SDI card or other card installed in which have been cablecompensated for the connecting cable. Depending on the functions of the cables described in "Cable specifications...
AWPH400 User Guide - Page 15
... sure to ask your dealer to install the unit.)
$ Setting the PCB switches
The switches on the CONNECTOR PCB will need to be set in accordance with the signals to be transmitted and the equipment to be connected to the pan/tilt head. (The switches are set to support analog/SDI at the factory.)
≥...
AWPH400 User Guide - Page 16
... head (pan/tilt head, camera and lens cable). ≥ Install the pan/tilt head in malfunctioning.
16 Doing so may result in such a way that the equipment and cable attached to proceed as instructed. Indoor Pan/Tilt Head AW-PH400
Installation (Be sure to ask your dealer to install the unit.)
$ Installing the pan/tilt head...
AWPH400 User Guide - Page 20
... cable and lens of the AW-RP400. Specifications are approximate. Indoor Pan/Tilt Head AW-PH400
Specifications
Supply voltage:
AC 120 V, 60 Hz
Power consumption: 145 W
1 indicates safety information. The tilt range is limited to 190 degrees by the initial setting of camera to change the AW-RP400 setting. To move beyond 190 degrees, change...
AWPH400 User Guide - Page 22
... AW-RP400 cannot be used to control the model AW-PH300, AW-PH300A, AW-PH350, AW... of the pan/tilt head system must be set Rack-mounting adaptors 2 Mounting screws (M4!8 mm...cameras mounted on the pan/tilt heads can be controlled at the same time.
≥ By installing... an additional control panel, two of the five units in the pan/tilt head system can be controlled at the end of its service...
AWPH400 User Guide - Page 23
...setting the OPERATE switch on the master control panel as well are set to [ON]. NOTE
≥ The centering of the connected control panel sounds, and the CALL button lamp lights.
23 It goes off . Parts...an additional AW-RP400 control panel is installed and used, it is set to [OFF], the power supply from the connected pan/tilt heads to the cameras is enabled. If no additional AW-...
AWPH400 User Guide - Page 24
...The lens is tilted; Pan/Tilt Control Panel AW-RP400
Parts and their function
7 IRIS [AUTO/MANU/LOCK] button Use...the WV-CB700A remote control box is locked at the manually adjusted setting. LOCK: The lens iris is connected to MANU. PAN... FOCUS indicator The position of the LCD panel.
24 AUTO: The cameras automatically adjust the lens iris in the currently selected pan/tilt head ...
AWPH400 User Guide - Page 32
... other device.
≥ Do not eject the SD memory card, turn off the power or set regardless of the cameras can be repeated automatically. when STOP is selected, the presets from using it with a personal computer, digital camera or other unit as well. The buzzer sounds when the CALL button has been pressed or...
AWPH400 User Guide - Page 38
...500 meters (when the BELDEN 8281 connecting cable or its service life, ask a specialized contractor to dispose of these ... connected between this AW-RC400 cable compensation unit and the camera is input, the monitor selection will not be controlled....181;s advance function for the sync signals in order to provide easy support for a system (another cable compensation unit is required) in order...
AWPH400 User Guide - Page 59
... LENS I/F2 connector on pan/tilt head. Ensure that their lengths are approximate. Connect to the ZOOM/FOCUS connector on the camera. Cable specifications
59
When an IASD, WASD or VASD lens (digital drive) made by Canon is used . Cable length: At least 500 mm or so
Connector: HR10A-10J-12P made by...
Panasonic AWPH400P Reviews
We have not received any reviews for Panasonic yet.