NEC PN7501 Support and Manuals
Popular NEC PN7501 Manual Pages
MultiSync 50/70/90 User's Manual - Page 3
... the PN7501, PN7701 and N9901␣ color monitors so ...try to avoid any problems.
Canadian Department of ... device, pursuant to part 15 of other cables...installed and used in compliance with Canadian Safety
Regulations according to C.S.A. 22.2 #950. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. FCC Information 1. This equipment has been tested and found to comply with the instructions...
MultiSync 50/70/90 User's Manual - Page 4
...w w w.nectech.com/productregistration
Your new NEC Technologies MultiSync® monitor box* should contain the following:
• MultiSync Monitor with tilt/swivel base MultiSync 50, 70 or 90
• Power Cord • Captive Signal Cable • User's Manual
M NEC MultiSync Series
50/u7l0ti/S9yn0c User's Manual
®®
pwrwopdrwour.cdentugreceicYstgtoteoieuscnrhtlcr.iyaancoonteuimoar...
MultiSync 50/70/90 User's Manual - Page 5
... adapter (not included) to the monitor connector on the monitor (Figure D.1) and the computer. NOTE: To obtain the MultiSync Macintosh cable adapter, call
NEC Technologies at (800) 820-1230. 4. Attach the 15-pin mini D-SUB end of
this User's Manual. 5. NOTE: If you have any problems, please refer to the Troubleshooting section of the captive signal cable...
MultiSync 50/70/90 User's Manual - Page 7
... decreases the curvature of your display. Adjusts the image brightness in relation to the factory setting.
The Geometry controls allow you to adjust the curvature or angle of the sides of ... the screen to the left or right). Blue Color Contrast: Adjust the blue contrast of the monitor function
as the bottom.
Controls
OSM™ (On-Screen Manager) control buttons on the front ...
MultiSync 50/70/90 User's Manual - Page 8
...elapse
between uses of the screen colors, focus and convergence.
Select EXIT in five languages.
This color setting is demagnetized. Note: If no buttons are 3 background colors (blue, black, and white). When...: Eliminates the buildup of stray magnetic fields that alter the correct scan of the electron beams and affect the purity of the Degauss Control. Caution: Please allow a minimum...
MultiSync 50/70/90 User's Manual - Page 9
... facing the east to dangerous shock hazards or other heat sources. There are no user serviceable parts inside and opening or removing covers may create strong magnetic fields. • If possible, position the monitor so that heat can be installed close to a power outlet which may expose you to minimize the effects of the...
MultiSync 50/70/90 User's Manual - Page 10
... Santa Monica,
California 90406.
8
15500251.wpc
10
5/7/99, 12:54 PM Adjust the monitor tilt so that the top of Visual Display Terminal Workstations - Ergonomics
To realize the maximum ergonomics...18 inches.
• Rest your eyes periodically by focusing on setting up a healthy work environment, call NEC
at (800) 820-1230, NEC FastFacts™ information at a 90° angle to windows and...
MultiSync 50/70/90 User's Manual - Page 11
...only
Active Display Area (Factory Setting) Active Display Area (Full ...Specifications
Monitor Specifications
Picture Tube
Diagonal: Viewable Image Size:
Radius:
Input Signal
Video: Sync:
Display Colors
Analog input:
Synchronization Range
Horizontal: Vertical:
Resolutions Supported...support
800 x 600 @ 55 to 109 Hz
all modes listed.
832 x 624 @ 55 to 103 Hz
1024 x 768 @ 55 to 85 Hz NEC...
MultiSync 50/70/90 User's Manual - Page 12
... phosphor, multi-layered, anti-static screen coating, semi-tint screen, Invar Shadow Mask and OptiClear® screen. Monitor Specifications
Picture Tube
Diagonal: Viewable Image Size:
Radius:
Input Signal
Video: Sync:
Display Colors
Analog input:
Synchronization Range
Horizontal: Vertical:
Resolutions Supported
Resolution based on display card used , and does not include border area.
MultiSync 50/70/90 User's Manual - Page 13
... screen coating, semi-tint screen, Invar Shadow Mask and OptiClear® screen surface. TTL Level Horizontal sync. Monitor Specifications
Picture Tube
Diagonal: Viewable Image Size:
Radius:
Input Signal
Video: Sync:
Display Colors
Analog input:
Synchronization Range
Horizontal: Vertical:
Resolutions Supported
Resolution based on display card used , and does not include border area.
MultiSync 50/70/90 User's Manual - Page 14
..., allowing the correct electron beam (red, green, blue) to change the color settings on but not in most resolutions, significantly expanding image size.
AccuColor® Control System: Allows you to use on the inner surface of vision and compliance with the Windows®95/98 operating system facilitates setup and installation by NEC Technologies, Inc...
MultiSync 50/70/90 User's Manual - Page 15
... position and power cord should be causing electrical interference away from the monitor.
• See inside cover of User's Manual for FCC information. Display image is fuzzy or color looks blotchy
•...connection or
make sure the display card is Macintosh compatible and that may be connected. Troubleshooting
No picture
• Display card should be completely seated in its slot. • ...
MultiSync 50/70/90 User's Manual - Page 16
...://www.nec.com/drivers/graphic.htm
Then download the file NECMSINF.ZIP
• FastFacts™ Information (800) 366-0476
INFORMATION
DESCRIPTION
DOCUMENT #
MultiSync® 50/70/90 monitors Detailed monitor information
757701
Glossary
Definition of terms related to functions, features and installation of the MultiSync monitor
900203
More Information
Names and addresses of other groups...
MultiSync 50/70/90 User's Manual - Page 17
... the instructions contained in the User's Manual. This warranty is warranted in the U.S.A. This warranty only covers Product distribution in accordance with many systems, specific functional implementation by NECTECH to be covered under this warranty. Proof of Purchase will be required by calling 1-800-632-4662. It shall be your nearest authorized NECTECH service facility...
MultiSync 50/70/90 User's Manual - Page 36
...-5000
Type of Product:
Computer Monitor
Equipment Classification: Class B Peripheral
Models:
PN7501, PN7701 and N9901
We hereby declare that may cause undesired operation. MultiSync is prohibited. and of any product or service.
15500251.wpc
36
Part No. 15500251 Printed in China
5/7/99, 12:54 PM AccuColor, OptiClear and ErgoDesign are trademarks of NEC Technologies, Inc. registered...
NEC PN7501 Reviews
Do you have an experience with the NEC PN7501 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for NEC yet.
Earn 750 points for your review!