Kenwood KAC-X541 Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood KAC-X541 manuals!
Problems with Kenwood KAC-X541?
Ask a Question
Free Kenwood KAC-X541 manuals!
Problems with Kenwood KAC-X541?
Ask a Question
Popular Kenwood KAC-X541 Manual Pages
Instruction Manual - Page 2
...installation, consult your Kenwood dealer. • If the unit does not seem to be working right, consult your Kenwood dealer.
When more than the maximum output power (in the Operation Manual of the Center Unit. Also avoid places with too much dust or the possibility of water splashing. • When replacing...one set of speakers are explained in Watts) of the amplifier.
You...
Instruction Manual - Page 3
... instruction manual well to the intended usage. 3.Connect the input and output wires of the amplifier will not come into contact with it will inhibit the cooling of the internal temperature and result in a place where people, resins, and other damage.
• Do not install near the dashboard, rear tray, or air bag safety parts...
Instruction Manual - Page 4
... off and check connections.
• Be sure to turn the power off before changing the setting of any of the car can cause this limit, you cannot control amps from the Center Unit.
• If you cannot control all amplifiers connected to "7" and do not duplicate them at a time. Sharing the negative wire of...
Instruction Manual - Page 5
....
NOTE
The values you have an impedance of amplifier B using the Amplifier Control.
• OFF position: Bypasses the Amplifier Control circuit.
LINE IN terminal (A.ch/B.ch)
@ LINE OUT terminal These jacks output respectively the signals input to the "Specifications" in the instruction manual
of higher frequencies than the frequency set
with the "HPF FREQUENCY" control.
• OFF...
Instruction Manual - Page 6
...Press the [MENU] button for at least 2 seconds. Then, you have set with the Amplifier Control.
NOTE
Volume offset value can recall the value when message "LOAD" is...FAN"
Information Indicates the source voltage (V). Indicates the current consumption (A). Separate Amp Control
The following sequence. The setup items and set values are switched as follows:
1 Enter Menu mode
Press the [MENU]...
Instruction Manual - Page 7
... following explains how to control the sound of Amplifier B by operating the Amplifier Control of the unit from the Center Unit.
1 Enter AMP Control mode
Select the AMP Control mode by following the instructions given on the Operation Manual of the Center Unit.
2 Select an amp number to operate
Operate the desired set item with the vehicle ground.
Instruction Manual - Page 8
...
(µF)
fc=Cut of Frequency (Hz) R=Speaker Impedance (Ω)
Example: When it is required to set a crossover frequency of 120 Hz using a coil and capacitor...in a drop of the combined impedance with... ratings to the results calculated from the formula above. System examples
4-channel system
CENTER UNIT
Front Left speaker Front Right speaker
Rear Left speaker Rear Right ...
Instruction Manual - Page 9
... The AMP Control of the Center Unit is being used.
• An incorrect ID number is used for possible problems.
PROBLEM No sound. (No sound from the Center Unit.
Specifications
Specifications subject to Noise Ratio...105 dB Sensitivity (rated output) (MAX.) ...0.2 V Sensitivity (rated output) (MIN.) ...5.0 V Input Impedance ...10 kΩ
Amplifier Control Section (EQ) (B channel KAC-X541...
Kenwood KAC-X541 Reviews
We have not received any reviews for Kenwood yet.