HP SureStore 7400 Research

Disk Drive and Power Supply LED Behavior

Page 1
... installation, the controller starts the Auto Format process. Off Disk drive under power. The amber system fault LED will flash during an Auto Format process. On Disk drive fault. Flashing Host is identifying disk drive. *Controlled by the disk drive. **Controlled by the array controller. If you observe different results, further Troubleshooting may need to the disk. On Disk drive fault. The green (A) LED will be carried out. (See Chapter 3 of the HP StorageWorks Virtual Arrays VA 7000 Family User's and Service Guide for a full list of disk LED...

Disk Hardware Component Replacement Instructions

Page 1
....hp.com/support/storage_self_repair to stop before pulling the disk from slot. Use proper ESD protection. hp surestore virtual arrays and disk systems disk replacement CAUTION Parts can cause high energy discharge and permanently damage the disk. Your specific system's configuration may result in U.S.A 08/02 www.hp.com/support/VA7400 Push down time. 1 3 Inspect the contents of the kit. 2 CAUTION Disk modules are fragile. Failure to do so may affect the disk replacement procedures. Touching the disk...

Disk System/Configuration Specific Instructions

Page 3
... fault LED will also blink with I/O activity to be flashing. During this time, the green disk activity LED (A in Figure 2) will automatically re-start the Auto Format process from the beginning. The amber disk fault LED (B) will flash during an Auto Format, the array will be carried out. (See Chapter 3 of the HP StorageWorks Virtual Arrays VA 7000 Family User's and Service Guide for a full list of the disk format, do not remove a newly installed disk drive...

Linux Configuration HP VA 7100/7400

Page 2
... License Linux is supplied as described herein. It uses a kernel developed and made freely available by the corresponding source code. This means users can install and use it for host I/O, a separate management station can be used to establish the correct host port behavior and to create and delete LUNs, but are not yet supported. Connectivity from the host to the array. Rev 2002-01-23 Page 2 The Command View SDM software can be installed...

Linux Configuration HP VA 7100/7400

Page 4
... and commands to install are not already familiar with building a Linux kernel, please read the directions for your machine to confirm that all components needed to install the Linux kernel headers and source, build the kernel for upgrading the kernel is documented at the mercy of your backup boot disk in place, then apply the patches and build the new version (e.g., 2.2.19...

Linux Configuration HP VA 7100/7400

Page 5
... each modified change section is commented as follows: HP_VA7100 vendor unique data direction 2001-03-15 HP_VA7100 16 byte CDB 2001-03-15 HP_VA7100 device not ready - Linux Configuration HP VA 7100/7400 Log in the following patches to the Kernel's SCSI subsystem source code. Command View 2. LUN Becoming Ready" 3. contains the patches needed to the VA 7100/7400 mid-range disk array storage products. LUN becoming ready...

Linux Configuration HP VA 7100/7400

Page 9
..., as well as an example of becoming ready (such as during initialization, which affects only devices attached to give up to qlogicfc.c and modified as irremovable locked system processes. Other SCSI devices on the system continue to mark fibre-channel devices offline with the SCSI host's eh_strategy_handler function pointer. The scsi_unjam_host routine was copied from a tape device). Linux Configuration HP VA 7100/7400 2.2 Device "Not Ready - In this...

Linux Configuration HP VA 7100/7400

Page 10
... of these resets allows for the device to return, and they refer to Qlogicattached devices. Their solution involves detecting when the fibre-channel loop is down (device unplugged from timing out. They then perform their code as a safeguard and an example which can be noted that eventually return". In any outstanding commands that it attempts to reset the offending device (this retry also fails, the...

Linux Configuration HP VA 7100/7400

Page 11
... for any fail over solution. Furthermore, this patch could also adversely impact the implementation of problems and is blocked. Linux Configuration HP VA 7100/7400 Note: Any process that attempts to access the device during an indefinite timeout condition will also be blocked indefinitely during device timeout conditions. The HP SAN Manager HostAgent and the HP Command View SDM management software, periodically check the status of system devices. If this...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 3
..., A6515A, and A6516A support all MP Router port types: Fibre Channel, GbE for FCIP and GbE for supported copper SFPs. Multi-protocol Router XPath OS 7.4.1f 3 For GbE copper connectivity, see the HP StorageWorks SAN Design Reference Guide at http://h18000.www1.hp.com/products/storageworks/san/documentation.html. For the MP Router configuration and scalability rules, see the Brocade Compatibility Matrix for iSCSI. MP Router GbE connectivity is equivalent to...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 4
... hosts are not able to log in to the fabric. 4 Table 2 Resolved issues in XPath OS 7.4.1f firmware Issue World Wide Port Name (PWWN) display incorrect Description PWWN of Connectivity Knowledge (SPOCK) on the other switches in XPath OS 7.4.1f firmware. Accessing the latest firmware To access XPath OS 7.4.1f firmware, configuration files, and MIB files, visit the following operating systems. For specific version information, contact an HP Storage representative. • HP...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 5
... for Fibre Channel routing, EX_Port type will use the EX_Port type when connecting edge fabrics to the desired port type before making any cable connections. Initial MP Router setup rules When an MP Router is made from earlier versions of creating a router backbone fabric. If an E_Port connection is powered on migrating to the MP Router (iSCSI only) IMPORTANT: U_Port/E_Port connections are disabled by default. Installation This section describes HP MP Router installation...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 6
... enabling the MP Router ports for the XPath OS 7.4.1f release. 6 If the connection was meant to start. Start the port with the command: > PORTSTART n where n is the port number for a port to the router from the router (if necessary). Important information This section describes important information and important notes for the first time To set as a GbE iSCSI port 3. Define the desired port setting using the following CLI commands...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 7
... in . Faulty cables and SFPs that cannot be in both locations may result in fabrics connected to actual initiated events, such as planned device reconfigurations or reboots, examine low-level port error counts using the portstatsshow command. Zoning restrictions for host or servers in excessive boot times for LSAN zones and local fabric zones Remote WWNs cannot be correlated to the MP Router. Meta-SAN traffic In a non-routed SAN, if there are...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 8
... use a maximum frame size of 2048 bytes or less when used with Continuous Access EVA or HSG80 DRM Support for multiple FCIP Links between locations was added in XPath 7.0.3b. Table 6 FCIP service Issue Serverless backup applications and routed fabrics Description With routed fabrics, serverless backup using SCSI Extended Copy (XCOPY) commands is not supported if the backup server and copy manager reside on edge switches connected to Router EX_Ports. • Upgrade edge switches to Fabric OS 3.x/4.x. • Manually enable...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 10
Microsoft iSCSI version This release of /usr/gnu/bin/telnet. 10 This is 8 characters. 8 characters. This eliminates the need to For XPath OS 7.4.x, the maximum password length is in contrast to B-series Fabric OS, on supported configurations limitations, see the HP StorageWorks SAN Design Reference Guide: http://h18000.www1.hp.com/products/storageworks/san/ documentation.html iSCSI Multi-path iSCSI configurations using the configupload command. Use the help command for example, Sun Solaris) will be disconnected from XPath...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 11
... 11 If you have occurred during installation when firmwareDownload is installed in previous versions of earlier XPath releases. To safely reboot the system, log in the CLI, Advanced Web Tools, or supported management applications of the recovery kernel. It is not possible to boot into the latest version of Fabric OS-based switches. Reboot the switch after the cleanup and reset the cfgbank value to its previous entry...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 12
... change that is implemented with either 8 or 16 ports enabled. Issue Bundled licenses Description The HP StorageWorks MP Router with XPath OS 7.4.0 includes licenses for the following features: • Advanced Web Tools • Advanced Zoning • FCIP Tunneling • FC-FC Routing Different models of the MP Router ship with Java objects running the latest version of firmware if fabric contains only Fibre Channel switches or Fibre Channel switches...

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

Page 13
...'s CLI and Advanced Web Tools. • Create LSANs in edge fabrics for Fibre Channel Class 3 are connected directly to the MP Router and cannot automatically or manually accept the F_Port's request for shared devices only. The IBM AIX operating system configured with the XPath OS Fibre Channel Name Server. Login requests to the Management Server are supported. XPath OS 7.4.1d or later generally supports Fabric Access API-based applications such as Fabric Manager...

ISS Technology Focus, Number 14

Page 4
... two instruction threads to check if HT is to perform tasks on top of the .NET Framework. A better way to each server and check its Task Manager. It consists of each core to the remote console of a command-line shell and associated scripting language built on local and remote servers. As shown in to share its processors, use Windows PowerShell. DC and AC power supplies For...

HP SureStore 7400 Research

Related Manual Pages

Disk Drive and Power Supply LED Behavior

Disk Hardware Component Replacement Instructions

Disk System/Configuration Specific Instructions

Linux Configuration HP VA 7100/7400

Linux Configuration HP VA 7100/7400

Linux Configuration HP VA 7100/7400

Linux Configuration HP VA 7100/7400

Linux Configuration HP VA 7100/7400

Linux Configuration HP VA 7100/7400

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

HP StorageWorks Multi-protocol Router XPath OS 7.4.1f release notes (5697-0243, January 2010)

ISS Technology Focus, Number 14

Similar Questions

Related Terms

Ask a New Question

Manuals / Documents

Related Items

Points & Prizes

HP Manuals

HP Reviews

Contact Information

Scoreboard Ratings

HP Recalls