Garmin GT51M-TH Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GT51M-TH manuals!
Problems with Garmin GT51M-TH?
Ask a Question
Free Garmin GT51M-TH manuals!
Problems with Garmin GT51M-TH?
Ask a Question
Popular Garmin GT51M-TH Manual Pages
Installation Instructions - Page 1
...> Finish. May 2015
Printed in accordance with the installation. NOTICE When drilling or cutting, always check what is complete. 5 Remove the memory card. Thru-Hull Transducer
Installation Instructions
Important Safety Information
WARNING See the Important Safety and Product Information guide in the product box for the software update instructions to appear, the device must be fully booted...
Installation Instructions - Page 2
... at the location where you plan to install the transducer. The wood becomes a cutting guide for increased sonar accuracy. NOTE: The maximum cutting angle of the fairing block is necessary to mount the transducer. Cored Fiberglass Boat Hull Installation Instructions
Thru-Hull Transducer in a Cored Hull with displacement hulls , the transducer should
be
mounted
approximately
1/3
aft
of...
Installation Instructions - Page 3
.... You should follow these instructions, with one positioned outside the hull. The holes must contact the hull.
5 Apply marine sealant to the face of the backing block that two installers complete these instructions if you are not using a fairing block or isolator plate to prevent damaging the hull. 1 If the anti-rotation bolts are installed on the transducer.
3
Installation Instructions - Page 4
...vessel.
2 From outside the hull, insert the transducer through the hull. Do not over -tightening the nuts to prevent damaging the hull.
1 Apply marine sealant to the base of the anti-rotation bolts and transducer stem , and to the transducer
Ä
Å
stem.
Non-cored/Fiberglass Boat Hull Installation Instructions
Thru-Hull Transducer in a Non-cored/Fiberglass Hull with at the stem...
Installation Instructions - Page 5
....
7 From inside the hull, slide the backing block onto the transducer stem and seat it firmly against the inner hull. NOTE: When installing a transducer in .) bit plumb, drill the anti-rotation bolt holes from outside of the stem and
À anti-rotation bolts on the outside the hull. You should follow these instructions if you can mount...
Installation Instructions - Page 6
... or a crescent wrench to secure the included M8 nuts and 8 mm nylon washers to the anti-rotation bolts and
À
Á
transducer stem .
Â
Metal Boat Hull Installation Instructions
Thru-Hull Transducer in a Metal Hull with a 13 mm (1/2 in.) bit plumb, drill the anti-rotation bolt holes through the ull at the base of the anti-rotation...
Installation Instructions - Page 7
... transducer. 1 Trim the included transducer template. 2 Check whether the mounting location has an irregular surface
or nearby obstructions. 3 Select an option:
• If the mounting surface has no irregularities or obstructions, make sure the template fits the mounting location on all other installation instructions.
NOTE: Apply enough marine sealant on the outside of the hull...
Installation Instructions - Page 8
...
Testing the Installation
NOTICE You should apply a water-based anti-fouling paint to the hull of your vessel every six months. or its subsidiaries
www.garmin.com/support Garmin® and the Garmin logo are ...plastic and could damage or destroy your transducer.
Anti-Fouling Paint To prevent corrosion on metal hulls and to work properly.
These trademarks may not be in ...
Garmin GT51M-TH Reviews
We have not received any reviews for Garmin yet.