Garmin GT30-TH Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GT30-TH manuals!
Problems with Garmin GT30-TH?
Ask a Question
Free Garmin GT30-TH manuals!
Problems with Garmin GT30-TH?
Ask a Question
Popular Garmin GT30-TH Manual Pages
Installation Instructions - Page 1
...-01774-02_0B You are responsible for the software update instructions to appear, the device must install the Garmin® transducer according to your boat, you experience difficulty during the installation, contact Garmin Product Support. If you must be installed by completing our online registration today. • Go to your Garmin sonar device.
The device returns to the engine...
Installation Instructions - Page 2
...transducer stem (Drilling the Transducer Stem Hole and the Anti-Rotation Bolt Holes in a Cored Fiberglass Hull) and you must drill the hole for the deadrise angle of the specific... on the table so the cutting guide rests against water seepage. 1 Select...
Cored Fiberglass Boat Hull Installation Instructions
Thru-Hull Transducer in .).
2
The hole must not be installed with an angle finder,...
Installation Instructions - Page 3
... set thoroughly. 8 While holding a 25 mm (1 in a Cored Hull without a Fairing Block If the deadrise angle of your transducer. 1 Trim the included transducer ...installing the transducer in .) bit plumb, drill the anti-rotation bolt holes through the mounting hole. Failure to do so could result in the device rotating while the boat is recommended that two installers complete these instructions...
Installation Instructions - Page 4
... hull at the stem hole location.
The holes must be perpendicular to the sides of the transducer plate Á that two installers complete these instructions when you must drill the hole for the transducer stem, and you are installed on the outside of the exterior hull to ensure smooth water flow over the pilot...
Installation Instructions - Page 5
...-rotation bolts with at the base of the anti-rotation bolts and transducer stem . Á
3 Seat the transducer housing firmly within the fairing block Â
recess.
4 Apply marine sealant to the face of the fairing block that two installers complete these instructions if you can mount the device without surface irregularities or
obstructions...
Installation Instructions - Page 6
... and anti-rotation bolts.
4 From inside the boat.
1 Secure the bushings to the anti-rotation bolts and
À
Á
transducer stem .
Â
Metal Boat Hull Installation Instructions
Thru-Hull Transducer in a Metal Hull with a Fairing Block If the deadrise angle of your mounting location exceeds 5°, you are using a fairing block to mount the...
Installation Instructions - Page 7
.... 9 Sand and clean the area around the holes.
3 Apply marine sealant to the base of the transducer stem Ã
and anti-rotation bolts, and the side of the isolation plate that two installers complete these instructions if you must use the included isolation plate.
1 Secure the bushings to the anti-rotation bolts .
À...
Installation Instructions - Page 8
... detergent. 2 If the fouling is necessary to carry the sonar signal, the transducer must be used without the express permission of Garmin.
© 2014-2015 Garmin Ltd. Item
À Á Â Ã
Description Chartplotter Sounder Power Source Y-cable
Maintenance
Testing the Installation
NOTICE You should apply a water-based anti-fouling paint to the hull...
Garmin GT30-TH Reviews
We have not received any reviews for Garmin yet.