Garmin GT51M-THP Support and Manuals
Get Help and Manuals for this Garmin item
View All Support Options Below
Free Garmin GT51M-THP manuals!
Problems with Garmin GT51M-THP?
Ask a Question
Free Garmin GT51M-THP manuals!
Problems with Garmin GT51M-THP?
Ask a Question
Popular Garmin GT51M-THP Manual Pages
Installation Instructions - Page 1
... you must copy the software update to www.garmin.com/support for product warnings and other important information. Contacting Garmin Product Support • Go to a memory card. 1 Insert a memory card into
the card slot. NOTE: If the memory card is removed before the card is not complete. Thru-Hull Transducer
Installation Instructions
Important Safety Information
WARNING See the...
Installation Instructions - Page 2
...install the transducer.
Cored Fiberglass Boat Hull Installation Instructions
Thru-Hull Transducer in a Cored Hull with an angle finder, a protractor, or a digital level. Drilling the Transducer...) water for the deadrise angle of the specific point on the shape of the hull. ...Position the fairing block on the table so the cutting guide rests against water seepage. 1 Select a mounting location...
Installation Instructions - Page 3
... recommended that two installers complete these instructions if you can mount the device without a fairing block. Apply marine sealant around the base of the stem and À
anti-rotation bolts on your transducer,
À remove them. 2 Apply marine sealant at least one of the fairing block and exterior hull to set thoroughly. 8 While holding...
Installation Instructions - Page 4
... the nuts to prevent damaging the hull.
1 Apply marine sealant to the base of the anti-rotation bolts and transducer stem , and to the sides of the transducer plate Á that two installers complete these instructions, with a Fairing Block It is recommended that does not have a cored fiberglass hull. 1 Select a mounting location without a Fairing...
Installation Instructions - Page 5
... hole.
7 From inside the hull, slide the backing block onto the transducer stem and seat it firmly against the inner hull.
NOTE: When installing a transducer in .) spade bit plumb, drill the
transducer stem hole from outside the hull. You should follow these instructions, with one positioned outside of the fairing block and exterior hull to...
Installation Instructions - Page 6
... and anti-rotation bolts.
4 From inside the boat.
1 Secure the bushings to the anti-rotation bolts and
À
Á
transducer stem .
Â
Metal Boat Hull Installation Instructions
Thru-Hull Transducer in a Metal Hull You should use slip-joint pliers or a crescent wrench
to secure the included 35 mm hull nut , 26 mm nylon
Ã...
Installation Instructions - Page 7
... bolts.
5 Drill a 3 mm (1/8 in.) pilot hole through the hull at least one of the isolation plate that two installers complete these instructions if you can connect a pair of transducers to the sounder. 1 Connect each transducer cable into one of the split cable
ends of the exterior hull to the water surface.
8 Remove the template...
Installation Instructions - Page 8
...
www.garmin.com/support Anti-...transducer.
NOTE: Never apply ketone-based anti-fouling paint to
remove growth. 3 Wipe the device dry. Because water is severe, use a scouring pad or putty knife to your vessel, because ketones attack many types of Garmin Ltd.
Item
À Á Â Ã
Description Chartplotter Sounder Power Source Y-cable
Maintenance
Testing the Installation...
Garmin GT51M-THP Reviews
We have not received any reviews for Garmin yet.