Manual/User Guide
Page 3
...frame to touch parts (cover and base) other than parts to Signal Ground (SG). The mounting frame is connected to which the HDD is zero. Use M3 screw for the mounting screw and the screw length should satisfy the specification in any direction. (2) Frame ...The MR head bias of the HDD disk enclosure (DE) is attached. C141-E262 3-3 3.2 Mounting 3.2 Mounting For information on mounting, see the "FUJITSU 2.5-INCH HDD INTEGRATION GUIDANCE (C141-E144)." (1) Orientation The disk drives can be 0.49N•m (5kgf•cm).
...frame to touch parts (cover and base) other than parts to Signal Ground (SG). The mounting frame is connected to which the HDD is zero. Use M3 screw for the mounting screw and the screw length should satisfy the specification in any direction. (2) Frame ...The MR head bias of the HDD disk enclosure (DE) is attached. C141-E262 3-3 3.2 Mounting 3.2 Mounting For information on mounting, see the "FUJITSU 2.5-INCH HDD INTEGRATION GUIDANCE (C141-E144)." (1) Orientation The disk drives can be 0.49N•m (5kgf•cm).
Manual/User Guide
Page 5
3.2 Mounting Because of Figure 3.3, at least, do not allow its around φ 3 to close during mounting. For breather hole of breather hole mounted to the HDD, do not allow this to block. Locating of breather C141-E262 3-5 Figure 3.3 Location of breather hole is shown as Figure 3.3.
3.2 Mounting Because of Figure 3.3, at least, do not allow its around φ 3 to close during mounting. For breather hole of breather hole mounted to the HDD, do not allow this to block. Locating of breather C141-E262 3-5 Figure 3.3 Location of breather hole is shown as Figure 3.3.
Manual/User Guide
Page 7
...installation. C141-E262 3-7 Ensure that the disk drive is not affected by the edges. (6) Handling cautions Please keep the following cautions, and handle the HDD under the safety environment. Do not touch the printed circuit board, but hold it too hard, the cover and the spindle motor contact,... which may cause damage to the disk drive. Pressing it by external magnetic fields. Damage: Do ...
...installation. C141-E262 3-7 Ensure that the disk drive is not affected by the edges. (6) Handling cautions Please keep the following cautions, and handle the HDD under the safety environment. Do not touch the printed circuit board, but hold it too hard, the cover and the spindle motor contact,... which may cause damage to the disk drive. Pressing it by external magnetic fields. Damage: Do ...
Manual/User Guide
Page 8
... on the operation table, and place ESD mat on it. Figure 3.6 Handling cautions - Installation Conditions - Do not hit HDD each other. Do not drop. Installation (1) Please use the driver of the screw strictly. HDD is occasionally damaged by the impact of the driver. (2) Please observe the tightening torque of a low impact when...
... on the operation table, and place ESD mat on it. Figure 3.6 Handling cautions - Installation Conditions - Do not hit HDD each other. Do not drop. Installation (1) Please use the driver of the screw strictly. HDD is occasionally damaged by the impact of the driver. (2) Please observe the tightening torque of a low impact when...