Dell S6000 Support and Manuals
Get Help and Manuals for this Dell item
Dell S6000 Videos
Checking Out the Dell S6000 Switch at VMworld
Duration: 3:18
Total Views: 185
Duration: 3:18
Total Views: 185
How to design, configure and deploy an Active Fabric with Dell S6000 switches
Duration: 18:35
Total Views: 469
Duration: 18:35
Total Views: 469
Introduction to the Dell S6000 Layer 2 Gateway for VMware NSX
Duration: 8:36
Total Views: 3,100
Duration: 8:36
Total Views: 3,100
Dell Networking S6000: EST Tag
Duration: :14
Total Views: 37
Duration: :14
Total Views: 37
Popular Dell S6000 Manual Pages
FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 84
...code 2.8.1.1 and newer, while older boot codes are displayed as "Present". Stack Info -- Power Supplies --
Modified output: Boot Flash field will display code level for S-Series switches
Usage Figure shows the output from the show system stack...
--
Figure shows the output from the show system stack-unit command output to support Piece Part ID (PPID). Introduced on the Z9000. Module Info...
FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 944
...Usage See the FTOS Configuration Guide for specific interoperability limitations regarding the S-Tag TPID.
vlan-stack trunk
z S6000 Specify a Layer 2 port or port channel as a trunk port to the Stackable VLAN network. Defaults Not configured. Introduced on Z9000. Starting with the VLAN-Stack trunk port can transparently tunnel, in a service provider environment, customer-originated...
FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 964
...dell.com | support.dell.com
Table B-1. hard reset... alarm: problem with power entry module %s
NONE NONE NONE
NONE NONE NONE NONE NONE NONE SUPPLY
964 |...Error Messages (continued)
Message ID
Trap Type
CHM_CARD_DOWN
ENVMON
%CHMGR-1-CARD_SHUTDOWN: %sLine card %d down - %s %CHMGR-2-CARD_DOWN: %sLine card %d down
CHM_MAJ_SFM_DOWN_CLR
ENVMON
%CHMGR-5-MAJOR_SFM_CLR: Major alarm cleared: Switch...
FTOS 9.0(2.0) Command Line Reference Guide for the System - Page 966
www.dell.com | support.dell.com
Table B-1. Cpu5SecUsage (%d)
CHM_MEM_THRESHOLD
ENVMON
NONE
%CHMGR-5-MEM_THRESHOLD: Memory %s ...MemUsage (%d)
CHM_MEM_THRESHOLD_CLR
ENVMON
NONE
%CHMGR-5-MEM_THRESHOLD_CLR: Memory %s usage drops below threshold. SNMP Traps and Error Messages (continued)
Message ID
Trap Type
Trap Option
%CHMGR-5-CPU_THRESHOLD_CLR: Cpu %s usage drops below threshold....
FTOS 9.0(2.0) Configuration Guide for the System - Page 68
... abort the boot process. www.dell.com | support.dell.com
Recovering from a Forgotten Enable Password on the S4810 and S6000
If you forget the enable password on the S6000:
Step 1 2 3
4 5
6
Task
Command Syntax
Command Mode
Log onto the system via console.
reset
uBoot
Configure a new enable password. copy running -config to abort the boot process. Power-cycle the chassis by the...
FTOS 9.0(2.0) Configuration Guide for the System - Page 157
... (the default is supported. e.g. Configuration Information
The software supports BGPv4 as well as reflector will advertise routes learned from one client to ignore such errors. • Multiple BPG process instances are not supported. Dell Force10 recommends using options to another client. F10BgpM2NlriOpaqueType and f10BgpM2NlriOpaquePointer fields are set to a relatively higher...
FTOS 9.0(2.0) Configuration Guide for the System - Page 218
... 2.0 provides simplified auto-configuration options for a user-configured time (DHCP timeout).
Supports TFTP, FTP, HTTP, USB, and flash. Overview
On a new factory-loaded switch, the switch boots up in the local flash. New configurations require that the Management IP and Management Interface be configured manually.
Supported on S55 and S60. This mode is set with the reload-type...
FTOS 9.0(2.0) Configuration Guide for the System - Page 262
... stack-unit 0 level0 verbose no ]: yes FTOS#May 9 13:11:31: %S6000:0 %DIAGAGT-6-DA_DIAG_STARTED: Starting diags on the peer side - advisable to shut directly connected ports Warning - I2c Access Test PASS Test 13.010 - View offline diagnostics with Diags [confirm yes/no -reboot Warning - I2c Access Test PASS Test 13.005 - www.dell.com | support.dell...
FTOS 9.0(2.0) Configuration Guide for the System - Page 414
... behavior. www.dell.com | support.dell.com
Table 20-3 lists the range for a temporary stop sending traffic. MTU Range
Transmission Media Ethernet
MTU Range (in bytes)
594-12000 = link MTU 576-9234 = IP MTU
Ethernet Pause Frames
s Ethernet Pause Frames is set (tx on platforms s Threshold Settings are stored in data transmission. The only configuration applicable to...
FTOS 9.0(2.0) Configuration Guide for the System - Page 742
www.dell.com | support.dell.com
No specific show accounting Active accounted actions on tty2, User admin Priv 1
Task ID 1, EXEC Accounting record, 00:00:39 Elapsed, service=shell Active accounted actions on the Dell Networking system) or AAA for login authentication. You can specify the security protocol or mechanism for terminal lines • Configure AAA Authentication login methods &#...
FTOS 9.0(2.0) Configuration Guide for the System - Page 744
... the default list is not set up TACACS as the default list of methods when a user logs in.
• method-list-name-Character string used to different terminal lines.
www.dell.com | support.dell.com
To view the configuration, use the following command in .
• method1 [... CONFIGURATION To establish host address and password.
722 | Security This method does...
FTOS 9.0(2.0) Configuration Guide for the System - Page 757
...use the following list includes the configuration task for TACACS+
The following command in the FTOS Command Line Reference Guide.
Security | 735 Configuration Task List for TACACS+ functions:... the user's name and password are sent for authentication to troubleshoot problems.
TACACS+
FTOS supports Terminal Access Controller Access Control System (TACACS+ client, including support for ...
FTOS 9.0(2.0) Configuration Guide for the System - Page 764
... by Password
Authenticate an SSH client by prompting for the RSA authentication. • ssh-peer-stack-unit: Open an SSH connection to the peer stack-unit. RSA
Authentication : disabled.
742 | Security done. SSH supports three methods of authentication: • SSH Authentication by default.
Figure 41-8. www.dell.com | support.dell.com
• show crypto: Display the public part of...
FTOS 9.0(2.0) Configuration Guide for the System - Page 871
... peers to avoid potential problems if the VLT peers are configured as described in Rapid Spanning Tree Protocol (RSTP). Figure 50-2.
The secondary VLT switch tunnels the BPDUs that both sides of a primary VLT switch failure, the secondary switch starts sending BPDUs with the primary switch. In case of the VLTi are physically connected and treated as...
FTOS 9.0(2.0) Configuration Guide for the System - Page 890
... configuration on the port channels.
Depending on both units.
868 | Virtual Link Trunking (VLT) A syslog error message and an SNMP trap are generated. Follow correct upgrade ...error message and an SNMP trap are generated.
A syslog error message and an SNMP trap are generated. www.dell.com | support.dell.com
Troubleshooting VLT
Use the following information to help troubleshoot...
Dell S6000 Reviews
We have not received any reviews for Dell yet.