Dell PowerEdge 2550 Support and Manuals
Get Help and Manuals for this Dell item
View All Support Options Below
Free Dell PowerEdge 2550 manuals!
Problems with Dell PowerEdge 2550?
Ask a Question
Free Dell PowerEdge 2550 manuals!
Problems with Dell PowerEdge 2550?
Ask a Question
Most Recent Dell PowerEdge 2550 Questions
How To Make A Dell Poweredge 2550 Boot From Usb
(Posted by jeDexter 9 years ago)
Popular Dell PowerEdge 2550 Manual Pages
Console
Redirection
(.pdf) - Page 10
PXE = System Setup = PXE Boot
© 2001
Dell Computer Corporation
Dell Computer Corporation
Printed in the U.S.A. Dell DELL Dell Computer Corporation
Dell Computer Corporation
Installing a Fifth SCSI
Hard-Disk Drive - Page 3
...
power supply distribution board
SCSI hard-disk drives (4)
SCSI ID 0 SCSI ID 1
SCSI ID 2
SCSI ID 3
SCSI interface cable connection for fifth hard-disk drive interposer board
peripheral bay
Installing a Fifth SCSI Hard-Disk Drive
1-1 About This Guide
This document describes installing and configuring an optional fifth SCSI hard-disk drive in your system's Installation and Troubleshooting...
Installing a Fifth SCSI
Hard-Disk Drive - Page 4
... Hard-Disk Drive
Dell supplies SCSI hard-disk drives in special drive carriers that fit in the bay. WARNING: Before you perform the procedures in the peripheral bay, disconnect the interface and power cables from its AC power source. WARNING: See your System Information document for important safety information before working inside your system's Installation and Troubleshooting Guide.
4 If...
Installing a Fifth SCSI
Hard-Disk Drive - Page 6
Connectors on the Fifth-Drive Backplane Board
SCSI cable connector
power connector
interface cable connector
1-4
Installing a Fifth SCSI Hard-Disk Drive Be careful to avoid trapping power or interface cables underneath the peripheral bay when you reinstall it aside.
8 If the peripheral bay is empty, remove the rectangular plastic insert from the front of the system...
Installing a Fifth SCSI
Hard-Disk Drive - Page 7
... Connect the spare power cable leading from the power supply distribution board (see Figure 1-1) to the power connector on the fifth-drive backplane board (see Figure 1-4).
18 Reconnect the control panel cable, power cable, cooling fan wiring harness, and interposer board interface cable to the interposer board (see Figure 1-2).
19 Install the fifth hard-disk drive by...
Installing a Fifth SCSI
Hard-Disk Drive - Page 8
... hard-disk drive carrier handle to lock the drive carrier in place (see "Running the Dell Diagnostics" in step 3, reinstall it. 25 If the hard-disk drive is a new drive, run the Dell Diagnostics to their AC power sources, and turn them on. 24 If you removed the system's optional bezel in your Installation and Troubleshooting Guide.
1-6
Installing a Fifth SCSI Hard-Disk Drive...
SCSI Backplane
Daughter Card - Page 3
... This Guide
This document updates information in your System Information document.
2 Unpack the SCSI backplane daughter card kit. This daughter card connects to the daughter card and system during this procedure, see "Safety First-For You and Your Computer" in your system's SCSI hard-disk drives in a split 2 x 2 or 2 x 3 configuration, you must install a second, optional daughter card. SCSI...
SCSI Backplane
Daughter Card - Page 4
Removing a Hard-Disk Drive Lock
hard-disk drive lock 5 Remove any hard-disk drives are installed in your system's Installation and Troubleshooting Guide for more information.
4 If any hard-disk drives from the right-hand drive bay by opening the drive
carrier handle and sliding the carrier toward you until it is free of the drive bay.
1-2
SCSI Backplane Daughter Card The...
SCSI Backplane
Daughter Card - Page 5
Figure 1-3. Removing a SCSI Hard-Disk Drive
hard-disk drive carrier hard-disk drive carrier handle 6 Hold the daughter card by its edges with the tabs on the left and right edges of the card are visibly aligned with the component side facing up and the card connector facing the SCSI backplane (see Figure 1-4). SCSI Backplane Daughter Card
1-3
Installing the SCSI...
SCSI Backplane
Daughter Card - Page 6
... adapter connected to the SCSI backplane board. Figure 1-5. www.dell.com | support.dell.com
9 Slide the daughter card into the drive bay and lock the card into place by closing the retention lever on the card's front edge (see Figure 1-1). SCSI Cable Connectors on the SCSI Backplane Board
power connector (POWER2)
SCSI cable connector (SCSIA)
system-board...
Activating the Dell
PERC 3/Di - Page 2
...Trademarks used in any proprietary interest in this document to refer to avoid the problem. February 2001 P/N 448VG Rev. A00 Notes, Notices, Cautions, and Warnings...names may be used in this text: Dell, PowerEdge, and the DELL logo are trademarks of Dell Computer Corporation is subject to change without the written permission of Dell Computer Corporation. NOTICE: A NOTICE indicates either...
Activating the Dell
PERC 3/Di - Page 7
...the RAID controller documentation. Activating the Dell PERC 3/Di
1-5 Changing the System Setup Settings
1 Turn on your operating system ... and repeat all data on the hard-disk drives before changing the mode of operation of...Setup program and verify that the setting for the SCSI controller has changed to reflect the presence of the RAID hardware. See "Changing the System Setup Settings."
11 Install...
Activating the Dell
PERC 3/Di - Page 8
... | support.dell.com
4 Press the left- Channel A displays RAID, and Channel B displays SCSI. (When the RAID option is set to SCSI, Channel A and Channel B display SCSI.)
5 Press to RAID Enabled. or right-arrow key to change the RAID option to save settings, and then reboot the system. 6 Configure the RAID subsystem and install the RAID driver...
Rack Installation Guide - Page 2
... DELL logo, PowerEdge, and RapidRails are trademarks of Dell Computer Corporation is subject to change without the written permission of Dell Computer Corporation. A01 Notes, Notices, Cautions, and Warnings
NOTE: A NOTE indicates important information that helps you make better use of data and tells you how to avoid the problem. CAUTION: A CAUTION indicates a potentially hazardous...
Rack Installation Guide - Page 4
....dell.com | support.dell.com
• Always load the rack from the bottom up, and load the heaviest item in the rack first. • Make sure that provides power to components in the rack. • Do not step on or stand on any system or component when servicing other systems or
components in a rack.
4
Rack Installation Guide...
Dell PowerEdge 2550 Reviews
We have not received any reviews for Dell yet.