Adaptec 39320A-R - SCSI Card Storage Controller U320 320 MBps Support and Manuals
Get Help and Manuals for this Adaptec item
View All Support Options Below
Free Adaptec 39320A-R manuals!
Problems with Adaptec 39320A-R?
Ask a Question
Free Adaptec 39320A-R manuals!
Problems with Adaptec 39320A-R?
Ask a Question
Popular Adaptec 39320A-R Manual Pages
Installation Guide - Page 2
... Adaptec SCSI Card 39320A has two independent SCSI
channels with older legacy SCSI devices, Adaptec recommends that you to connect up to 30 SCSI devices-such as separate channels. Introduction
The Adaptec SCSI Card 39320A enables you dedicate them as very large arrays of 320 MB/sec per SCSI
channel. or 32-bit PCI/PCI-X expansion slots. Although the Adaptec SCSI Card 39320A is a 64-bit PCI...
Installation Guide - Page 3
...the data transfer rate for the Ultra320/160 and Ultra2 SCSI devices will drop to use longer cable lengths for the Ultra (legacy) devices, while the second SCSI channel can support LVD devices in Ultra320, Ultra 160, or Ultra2 speeds.
This installation guide explains how to: s Install the Adaptec SCSI Card 39320A s Set up before handling your
SCSI card by touching a grounded metal object (like...
Installation Guide - Page 4
... slot cover.
If the computer does not have vertical or horizontal expansion slots. The Adaptec SCSI Card 39320A supports both 5V and 3.3V 64-bit slots. (The expansion slot must be compliant with PCI Rev. 2.1 or PCI-X Rev. 1.0 and must support Bus Mastering.) Save the slot cover screw for easier installation of the Adaptec SCSI Card 39320A.
3 2 After you can install the card in Step 4.
Installation Guide - Page 5
...to the device's documentation for specific instructions.
4 Warning: Be careful when inserting the Adaptec SCSI Card 39320A in the 64-bit (or 32-bit)
PCI or PCI-X expansion slot; Setting Up SCSI Devices
There are several things you may break if you connect them to the Adaptec SCSI Card 39320A: s Check the SCSI IDs s Set the termination s Connect the power cables Since setup can vary from device...
Installation Guide - Page 6
... you use an Ultra SCSI terminator on the same SCSI channel can connect a total of 30 SCSI devices to the Adaptec SCSI Card 39320A, with up to SCSI ID 0 at the end of each cable. No two devices on an LVD Ultra320/160 and Ultra2 SCSI bus, the SCSI devices will not operate properly. Connecting SCSI Devices
You can have a terminator installed (or enabled). Following...
Installation Guide - Page 7
... LVD SCSI cable, which you keep your Ultra320/160 and Ultra2 SCSI devices separate from your cables are laminated so that you can identify most LVD cables as having twisted pairs of the cable. Internal LVD cables usually have a terminator built into the end of the flat ribbon cable between the device connectors. The Adaptec SCSI Card 39320A has two separate Ultra320/160 SCSI channels...
Installation Guide - Page 8
... one of the internal
LVD/SE connectors.
3 Plug the internal Ultra320/160 and Ultra2 SCSI devices to each internal SCSI device.
7 Ultra320/160 or Ultra2 SCSI devices
Plug first device to Built-in terminator on cable this connector
Note: Internal Ultra320/160 and Ultra2 SCSI devices come from the factory with the connector at the end of the...
Installation Guide - Page 9
... connectors on the Adaptec SCSI Card 39320A.
68-pin external LVD/SE VHDCI SCSI connectors VHDCI External LVD SCSI cable
2 Connect the other end of the cable to the 68-pin external LVD/SE VHDCI SCSI connectors. SCSI terminator
8
4
4
If you do not combine older SCSI devices with the newer Ultra320/160 and Ultra2 SCSI devices on the
back of the Adaptec SCSI Card 39320A.
Follow these...
Installation Guide - Page 10
... last device in the middle of the chain.
4 Connect power cables to all external device(s) and to the
computer.
Ultra320/160 and Ultra2 SCSI devices are automatically unterminated, but Ultra SCSI and Fast/Wide SCSI devices do have termination that you are using external Ultra2 or Ultra320/160 devices, be terminated, and termination must check. Terminate...
Installation Guide - Page 11
...supported by the computer manufacturer.
Troubleshooting
If you have any problems while installing the Adaptec SCSI Card 39320A, check the following items first: s Are all SCSI cables and power cables properly connected? Installation of a computer system you purchased the Adaptec SCSI Card 39320A. s Is the SCSI bus properly terminated?
Preloaded Adaptec Drivers
If the Adaptec SCSI...
Installation Guide - Page 12
...installed and used in accordance with the limits for a Class B digital device, pursuant to radio communications.
This equipment has been tested and found to comply with the instruction manual, may be determined by any means, electronic, mechanical, photocopying, recording or otherwise, without notice. All rights reserved. Trademarks
Adaptec, and the Adaptec... cable and power cable...errors...
Installation Guide - Page 13
... this device must accept any interference received, including interference that may causes radio frequency interference problem if used too near to comply with EMC Directive 89/336/EEC, as amended by the Spectrum Management Agency. Adaptec SCSI Card 39320A
Tested to Comply With FCC Standards
FOR HOME OR OFFICE USE
European Union Compliance Statement
This...
Installation Guide - Page 14
which may be registered in some jurisdictions. AA JG 08/03
Part Number: 513666-06, Ver. All rights reserved. Adaptec and the Adaptec logo are trademarks of Adaptec, Inc. R
Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035 USA
© 2003 Adaptec, Inc.
Adaptec 39320A-R Reviews
We have not received any reviews for Adaptec yet.