Adaptec 29320ALP-R - SCSI Card Storage Controller U320 320 MBps Support and Manuals
Get Help and Manuals for this Adaptec item
View All Support Options Below
Free Adaptec 29320ALP-R manuals!
Problems with Adaptec 29320ALP-R?
Ask a Question
Free Adaptec 29320ALP-R manuals!
Problems with Adaptec 29320ALP-R?
Ask a Question
Popular Adaptec 29320ALP-R Manual Pages
Installation Guide - Page 3
which may be registered in some jurisdictions. Adaptec and the Adaptec logo are trademarks of Adaptec, Inc.
Part Number: 513658-06UK, Ver. All rights reserved. AA LOC 10/03 R
Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035, USA.
© 2003 Adaptec, Inc.
Installation Guide - Page 4
...
The Adaptec SCSI Card 29320A enables you to connect up to 15 Low Voltage Differential (LVD) and/or 15 Single-Ended (SE) SCSI devices-such as very large arrays of high-performance hard disk drives, external storage subsystems, Ultra320/160 hard disk drives, scanners, and CD-ROM drives-to :
■ Install the Adaptec SCSI Card 29320A
■ Set up SCSI devices...
Installation Guide - Page 5
... must support Bus Mastering.) Save the slot cover screw for use in a 32-bit PCI slot. If the computer does not have a 64-bit slot, you turn off your computer). Installing the Adaptec SCSI Card 29320A
1 Discharge any static electricity build-up before handling your
SCSI card by touching a grounded metal object (like the exposed metal parts on...
Installation Guide - Page 6
... the SCSI IDs ■ Set the termination ■ Connect the power cables Since setup can vary from device to device, always refer to allow for specific instructions.
3 Warning: Be careful when inserting the Adaptec SCSI Card 29320A in the 64-bit (or 32-bit)
PCI or PCI-X expansion slot; English
Computers may need to do to your computer manual...
Installation Guide - Page 7
....
Terminators must be removed, or termination must have the necessary Ultra320/160 or Ultra2 cable and terminator before installing the Ultra320/160 SCSI devices.
SCSI IDs for setting SCSI IDs and termination on an LVD Ultra320/160 and Ultra2 SCSI bus, the SCSI devices will not operate properly.
Check the SCSI IDs
The Adaptec SCSI Card 29320A and each device you use an Ultra...
Installation Guide - Page 8
... as having twisted pairs of the cable. The Adaptec SCSI Card 29320A has one internal 68-pin LVD connector and two internal SE connectors to connect your internal Ultra320/160 and Ultra2 devices:
1 Locate a 68-pin internal LVD SCSI cable, which you keep your Ultra320/160 and Ultra2 SCSI devices separate from your cables are laminated so...
Installation Guide - Page 9
... cable from the factory with the connector at the terminated end of the cable(s) to the internal LVD
connector.
3 Plug the internal Ultra320/160 and Ultra2 SCSI devices to Built-in terminator on cable this connector
Note: Internal Ultra320/160 and Ultra2 SCSI devices come from your computer's internal power
supply to each internal...
Installation Guide - Page 10
Follow these steps to the Wide SCSI connector on the
Adaptec SCSI Card 29320A.
3 Plug the other end of the cable. To do this , use a 68-pin Wide SCSI cable like the one end of the cable to connect the devices:
1 Locate a 68-pin internal Wide SCSI cable.
2 Plug one shown in Step 1 below.
To do this...
Installation Guide - Page 11
... device. Note: We recommend that you have other Ultra/Fast Narrow SCSI devices, attach them
to a terminated Ultra/Fast
Narrow SCSI device.
4 If you do not combine older SCSI devices with the newer Ultra320/160 and Ultra2 SCSI devices on the same SCSI channel of the Adaptec SCSI Card 29320A. Be sure these steps to connect your computer's internal...
Installation Guide - Page 13
...Ultra320/160 and Ultra2 SCSI devices are still unable to terminate the last device in the middle of the driver software varies depending on how and where you have any problems while installing the Adaptec SCSI Card 29320A, check the following items first: ■ Are all SCSI devices powered on each SCSI device. Troubleshooting
If you purchased the Adaptec SCSI Card 29320A.
10 Adaptec...
Installation Guide - Page 14
... information only and is supported by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written consent of the information contained herein. To determine if the card is subject to change without notification to install the driver. No further action is necessary to its accuracy, Adaptec, Inc. No part of Adaptec, Inc., which may be...
Installation Guide - Page 15
...installation. Operation is connected.
■ Consult the dealer or an experienced radio/television technician for a Class B digital device, pursuant to Part 15 of the rules.
EN61000-4-3 (1998) Radiated immunity -
EN61000-4-5 (1995) Surges ±1 kV differential mode, ±2 kV common mode - Adaptec SCSI Card... Zealand standard AS/NZS 3548 set out by 92/31/EEC ...the instruction manual, ...
Installation Guide - Page 16
Japanese Compliance (Voluntary Control Council Initiative)
This equipment complies to a television or radio. Please handle it may causes radio frequency interference problem if used too near to class B Information Technology equipment based on VCCI (Voluntary Control Council for home use but it correctly per this documentation.
13 ...
Installation Guide - Page 17
INSTALLATIONSHANDBUCH
ADAPTEC SCSI CARD 29320A
Installation Guide - Page 83
which may be registered in some jurisdictions. Part Number: 513658-06EU, Ver. AA LOC 10/03
R
Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035, USA.
© 2003 Adaptec, Inc. All rights reserved. Adaptec and the Adaptec logo are trademarks of Adaptec, Inc.
Adaptec 29320ALP-R Reviews
We have not received any reviews for Adaptec yet.