Set-up For Receiving Air Channel

Using digital ant. not getting board cast to channels

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on May 17th, 2014 10:39 PM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

To tune the digital as well as analogue channels, you can use the Auto Store function. To search and store available digital channels, follow the steps below:

Press the MENU button on your remote control. Use the Up / Down arrow buttons for navigation.
Scroll down to Auto Store and press the ENTER button.
Select Antenna type and press the ENTER button .
Select the antenna type that you are using (Air or Cable) and press the ENTER button.
Select Channel Source and press the ENTER button.
Select Digital and press the ENTER button.
Select Search and press the ENTER button. This will scan for all available analogue channels.

Another way to tune the channels is using the Manual Store that scans for a channel manually and stores it in TV's memory. Note that the digital channel is only available in DTV mode.:

Press the MENU button on your remote control. Use the Up / Down arrow buttons for navigation.
Scroll down to Manual Store and press the ENTER button.
Select Digital channel.
Select Channel and set the Channel number using the Up / Down arrow buttons or number buttons (0 – 9).
Select Frequency and set the frequency using the number buttons.
Select Bandwidth and set the bandwidth using the Up / Down arrow buttons [ ] or number buttons (0 – 9).

Samsung Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

General Support
...Start button, and then click Control Panel window, under Appearance and Personalization, click...setting. the HDMI IN video jack you must use any HDMI in the lower right of the Screen in Digital...computer video signal the TV receives, fine-tunes the settings, adjusts the vertical and ...using standard D-sub (VGA), DVI-D, DVI-D to your monitor. If it . Mode Not Supported Message If you get...
General Support
... Recent Calls Select Delete All (7) Highlight, using the navigation keys, any of the following Categories: All Calls Missed Calls Calls Made Calls Received key for Select to check any of the...box key for Yes to reset the phone settings to the factory default settings, follow the steps below : Select Reset Settings (10) Highlight All, using the navigation keys, from the handset. To...
Using Anynet+ With A Home Theater SAMSUNG
... that don't have to use , setting Receiver: On in the Tools menu defaults the audio input and volume control to the Digital Audio In jack and to your TV and home theater. Because you are using the Anynet+ feature, you must set up for Anynet + use both remote controls, the remote for the television and the remote for...