Samsung HLS5687W Support Question
Samsung HLS5687W Support Question
Find answers below for this question about Samsung HLS5687W - 56" Rear Projection TV.Need a Samsung HLS5687W manual? We have 2 online manuals for this item!
Question posted by apentz222 on April 26th, 2012
Samsung Tv Cycles On And Off
My Samsung tv wont stay on. It turns on, picture comes up then 20 seconds later it shuts off then turns itself back on. It just keeps cycling on and off. Anybody know what this could be?
Current Answers
Answer #1: Posted by TVDan on April 26th, 2012 5:21 PM
TVDan
Member since:
August 8th, 2011 Points: 4,732,000
Member since:
August 8th, 2011 Points: 4,732,000
Normally this is an indication that you have a bad lamp. After it gets worse it will fail to light and you will get the blinking indicators. The blinking indicators is what happens when the microprocessor has not received the signal from the optical engine that "the lamp is lit and all is well". There are many things that need to happen before the lamp will start up. The power supply must develop all the needed voltages required by all the rest of the circuits, the cooling fans must be running at the correct speeds, the lamp door switch must be closed (interlock switch), The Color Wheel must be able to spin at the 1800 RPM and lock in sync with the video signal, the ballast circuit must be able to develop the 5000 volts to start-up the mercury vapor lamp, and the lamp needs to be in good working condition to light up. There should be no weird noises pointing to the fact that a fan or the color wheels motor bearings are starting to go bad.
The normal failures are the lamp and the color wheel. Unfortunately there is NO way to test a lamp (unless it's exploded or has a hole in it). I have seen nearly 100 lamps come into my shop that has failed in less than a month, and many that didn't last one full day. These lamp you buy off the web are many times factory seconds. I have had some customers send back a lamp two, three, and four times before they got one that lasted through the warranty. Our shop only buys from the manufacturer.
When you turn on this DLP HDTV the fans will start up first and then the color wheel will spin-up. If the color wheel doesn't get up to the 1800 RPM and maintain that speed then the lamp will not get to enable pulse. unfortunately after three attempts the set will shut down and the indicators will blink telling the customer to change the lamp, and of course after the customer does it, the problem remains the same. The microprocessor is located in the signal cluster and all it knows is that the lamp didn't light up correctly, so it gives the change lamp LED indicator blink
TV Dan
Related Samsung HLS5687W Manual Pages
Open Source Guide (ENGLISH) - Page 1
...modification are distributed under the Freetype Project. and give any free program is...satisfy both it and "any later version", you indicate your freedom ... FOR COPYING, DISTRIBUTION AND MODIFICATION
0. keep intact all derivatives of our free software... open sources, contact Samsung via Email (vdswmanager@samsung. THE ENTIRE RISK ...conditions of this License, they know you do not excuse you...
User Manual (ENGLISH) - Page 1
Owner's Instructions
HL-S5087W HL-S5687W HL-S6187W
Register your product at www.samsung.com/global/register
User Manual (ENGLISH) - Page 2
...Television Services
• Digital Picture Quality DTV programs are transmitted in widescreen and are always broadcast in widescreen, and offer much higher picture...11172-3 or ISO/IEC 13818-3.
© 2006 Samsung Electronics Co., Ltd. Many HDTV programs are granted...The first is Standard Definition Television (SDTV) and the second is a new way of our current analog TV programs, while the 480p ...
User Manual (ENGLISH) - Page 4
...11 Side Panel Jacks ...11 Rear Panel Jacks ...12 Remote Control...13
Connections 16
Connecting VHF and UHF Antennas 16 Antennas with 75-ohm Round Leads 16
Connecting Cable TV 17 Cable without a Cable ... 24 Connecting a Digital Audio System 25 Connecting to an Analog Amplifier 26
Operation 28
Turning the TV On and Off 28 Dynamic Menus and On-Screen Displays 28 Navigating Menus by Using the...
User Manual (ENGLISH) - Page 5
... Messages) Analog 95 Viewing Closed Captions (On-Screen Text Messages) Digital 97
PC Display 100
Using Your TV as a Computer (PC) Display 100 Adjusting the Picture Quality 103 Changing the Picture Position 104 Adjusting the Picture Quality and Position Automatically 105 Changing the Picture Size (PC Mode 106 Viewing the Current Resolution 107 Initializing the...
User Manual (ENGLISH) - Page 10
The picture will automatically be turned on in about 30 seconds for the TV to warm up, so normal brightness may be defective. Auto Timer ON/OFF has been set and the set is too high, the power will shut off . Check if the ventilation hole on the rear of the set is Off
STAND BY/TEMP...
User Manual (ENGLISH) - Page 12
... IN Connect to the DVI audio output jack of a device with HDMI output.
Your New Wide TV
Rear Panel Jacks
ΠVIDEO/AUDIO INPUT jacks Connect video/audio signals from external sources, such as VCR ...an S-VHS VCR or DVD player. (Refer to pages 19, 20, and 24)
ˇ VIDEO/AUDIO OUTPUT jacks Sends video/audio signals from the TV to an external source, such as a DVI connection with separate ...
User Manual (ENGLISH) - Page 13
... function enables you to view and play photo (JPEG) and audio files (MP3) from the TV. STILL Press to pause the current screen. (Refer to the previous channel.
20. RESET If your personal, customized picture settings.) (Refer to page 56)
14. SRS Activates TruSurround. (Refer to page 72)
NOTES
• The Color buttons are...
User Manual (ENGLISH) - Page 16
Connections
Connecting VHF and UHF Antennas
If you do not have a cable system, you will need to connect an antenna to your TV.
English - 16 Antennas with 75-ohm Round Leads
If your antenna looks like this:
it has 75-ohm round leads.
1 Plug the antenna lead into the ANT 2 IN (AIR) on the rear panel of your TV.
User Manual (ENGLISH) - Page 17
... cable without a Cable Box
1 Plug the incoming cable into the ANT 1 IN (CABLE) on the rear panel of your TV. Cable without a Cable box, and cable with a Cable Box that descrambles some or all channels.
Connecting Cable TV
You can connect different cable systems to the ANTENNA OUT terminal on your Cable box...
User Manual (ENGLISH) - Page 18
...to tune your Set-Top Box to the Cable box's output channel, which you can buy from your Samsung dealer or any electronics store).
1 Find and disconnect the cable that is usually channel 3 or 4.)
...is connected to the ANTENNA IN terminal of the RF (A/B) switch and the ANT 1 IN (CABLE) on the TV.
Set the A/B switch to the "B" position to view scrambled channels. (When you set the A/B switch to...
User Manual (ENGLISH) - Page 19
... an S-Video cable.
• Please be sure to match the color coded input terminals and cable jacks.
• Connecting Video/Audio cables from the TV onto the VCR. TV Rear Panel
2
3
4
Stereo VCR
English - 19 Connecting a VCR
Connecting a VCR to the Video or S-Video/Audio jack
1 Connect a video cable between the VIDEO IN...
User Manual (ENGLISH) - Page 20
... between the VIDEO IN (or S-VIDEO IN) jack on the TV and the VIDEO (or S-VIDEO) output jack on the Camcorder....a VCR.
1 Locate the A/V output jacks on the camcorder. You can use your TV. If you need to connect a set of two cables.
3 Connect a set of...jacks on the TV and the AUDIO output jacks on the camcorder. Connections
Connecting a Camcorder
The side panel jacks on your TV make it ...
User Manual (ENGLISH) - Page 21
... of audio cables between the HDMI IN 2 (or HDMI IN 1/DVI IN) jack on the TV and the HDMI OUT jack on your TV make it easy to connect a DVD player to your TV. Incoming
Cable or
Antenna
1
TV Rear Panel
DVD Player
Incoming
Cable or
Antenna
2
1
DVD Player English - 21 Connecting a DVD Player
The...
User Manual (ENGLISH) - Page 22
...and Video Jacks
1 Connect a video cable between the VIDEO IN (1 or 2) jack on the TV and the VIDEO OUT jack on the DVD player.
2 Connect a set of audio cables between the AUDIO IN (1 ...or 2) jacks on the TV and the AUDIO OUT jacks on the DVD player.
TV Rear Panel
Incoming Cable or Antenna
1
2
DVD Player
English - 22 Connections
Connecting to match...
User Manual (ENGLISH) - Page 82
...8224; Color Weakness
Setup
Enter
NOTES
• Game Mode is not available in TV mode.
• If the picture is poor when external device is connected to select "Game Mode", then press the... game console such as PlayStationTM or XboxTM, you display the TV menu in Game Mode, the screen shakes slightly. If Game Mode is On
• Picture Mode is activated. English - 82
Restrictions on .
1 ...
User Manual (ENGLISH) - Page 105
...or † button to the incoming video signal. Adjusting the Picture Quality and Position Automatically
This feature allows the TV to self-adjust to select "Auto Adjustment", then press the ..."PC", then press the ENTER button. The picture quality and position are adjusted automatically.
1 Press the SOURCE button to original view a few seconds later. The values of fine, coarse and position ...
User Manual (ENGLISH) - Page 125
... the replacement Lamp is the same type. • After replacing the lamp, align the lamp cover with the groove and secure the screws. • The TV will not turn on if the lamp cover is not correctly closed (as this will need a 5.91-Inch screwdriver and a pair of gloves.
1 Unplug...
User Manual (ENGLISH) - Page 128
.... do not place the TV on a soft surface, such as
vacuum cleaners. • Keep the ventilation openings clear; Liquids that may have formed inside of the TV set face down, it ... TV near or on top of the different television systems that create magnetic fields, such as cloth or
paper. • Place the TV in the TV channel frequencies.
Appendix
Cleaning and Maintaining Your TV
...
User Manual (ENGLISH) - Page 129
Specifications
Model
HL-S5087W
HL-S5687W
HL-S6187W
Dimensions (W x D x H)
45.43 x 15.63 x 32.30 inches 50.87 x 16.34 x 35.67 ...inches 55.31 x 17.64 x 38.62 inches
1154 x 397 x 820.5 mm
1292 x 415 x 906 mm
1405 x 448 x 981 mm
Weight
30.3 Kg / 66.8 lbs
33.3 Kg / 73.41 lbs
36 Kg / 79.37 lbs
TV...
Samsung Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
General Support
... the Power Light blinks continuously and the screen doesn't go on when you turn on or turns off , and then on. Move the mouse or press a key on the remote, and cycle through the sources. The Power Light On My LCD TV Is Blinking And The Screen Won't Go On. Press the Source button... -
Using Anynet+ With A Home Theater SAMSUNG
...; Optical out on the rear of our home theaters and TVs with the Anynet+ logo.) HDMI connections on the rear of the Anynet+ Television (LN40750) connections on the rear of the Anynet+ Home Theater (HT-AS720ST) connections on the rear of the Anynet+ television (LN40A750) in this explanation, the connections are the... -
General Support
...charging, the amber indicator will stay on the device will be ... within 60 seconds, the blue indicator turns to regular blinking once very 2 seconds automatically. &...sound effect to more of the device. Rear Mic-in pairing mode. AVRCP Frequency ...harmful interference to radio or television reception, which the receiver is... or an experienced radio/TV techniciaion for compliance could void...
Similar Questions
Samsung Hln617w - 61' Rear Projection Tv, Does Not Power Up.......?
The TV has a new lamp because the old one overheated and blew. Now with the new lamp it does'nt powe...
The TV has a new lamp because the old one overheated and blew. Now with the new lamp it does'nt powe...
(Posted by nathankanawyer 3 years ago)
My Tv Wont Stay On
my tv will turn on and play for a few minutes then no picture but have audio. After a Few seconds th...
my tv will turn on and play for a few minutes then no picture but have audio. After a Few seconds th...
(Posted by stewartrikki2 6 years ago)
Where Is Fan No. 2 Located In A Samsung Dlp Rear Projection Tv
(Posted by sccmlta 9 years ago)
Samsung Hls5687wx- 56' Rear Projection Tv
Where do you find the fan #2 in the tv
Where do you find the fan #2 in the tv
(Posted by sturmpaula 11 years ago)
Samsung Hl-s5687w Dlp Tv Problem
I turn the tv on and sound is there picture is white and when I change source there are black pencil...
I turn the tv on and sound is there picture is white and when I change source there are black pencil...
(Posted by verticaltech03 11 years ago)