Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin Support and Manuals

Get Help and Manuals for this Garmin item

View All Support Options Below
Free Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin manuals!
Problems with Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin?

Ask a Question

Popular Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin Manual Pages

Transom-Mount Transducer Installation Instructions - Page 1

... the installation. Transom-Mount Transducer Installation Instructions To obtain the best performance and to avoid damage to your boat, you must install the Garmin® transducer according to these instructions could result in damage or injury. Important Safety Information WARNING See the Important Safety and Product Information guide in the product box for the software update instructions...
Transom-Mount Transducer Installation Instructions - Page 2

... holes too deep. 4 If you are tightened. Installing the Transom-Mount Hardware NOTICE If you have the 8-pin cable or the 12-pin cable, use a countersink bit to drill a clearance counterbore through the transom, choose a pilot-hole location well above the waterline and mark it. Ã 8 Place a cable clamp on the transducer cable , Ä approximately one third of...
Transom-Mount Transducer Installation Instructions - Page 3

... deep can adversely affect the performance of the boat and put the transducer at which this occurs. 4 Return the boat to a different location on the transom, and repeat the test. Transom-Mount Transducer Installation Instructions 3 Because water is necessary to carry the sonar signal, the transducer must be in the water for leaks around any screw holes that...
Installation Instructions - Page 1

.... Transom-Mount Transducer Installation Instructions To obtain the best performance and to avoid damage to your boat, you must install the Garmin® transducer according to these instructions could result in damage or injury. It does not relieve you of the responsibility of the surface. NOTE: If the memory card is removed before the device restarts fully, the software update...
Installation Instructions - Page 2

... cable clamp to the transom. 11Repeat steps 10-12 to install the other sources of the propeller. The transducer must be in a location where it . 8 Place a cable clamp on the transducer cable Ä, approximately one third of the distance between the drives, if possible. The cables connected to the transducer should not be mounted in clean (non...
Installation Instructions - Page 3

You cannot get a depth or distance reading when out of the transducer, make moderate turns in the water, turn on the transom, and repeat the test. 3 Testing the Transom-Mount Transducer Installation NOTICE When adjusting the depth of the water. 5 Apply marine sealant to the included 12 mm M4 screws, and attach the cable-entry cover to work...
Installation Instructions - Page 4

or its subsidiaries, registered in the USA and other countries. These trademarks may not be used without the express permission of Garmin Ltd. Garmin® and the Garmin logo are trademarks of Garmin. © 2013-2014 Garmin Ltd. or its subsidiaries www.garmin.com/support

Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin Reviews

Do you have an experience with the Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Garmin yet.

Popular Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin Search Terms

The following terms are frequently used to search for Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin support:

Ask a New Question
Use the box below to post a new question about Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin.
Manuals / Documents
Download any of our Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin manuals for free!

We have the following 2 documents available for the Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin:
  • Installation Instructions
  • Transom-Mount Transducer Installation Instructions
Related Items
View other Garmin Marine Electronics:

Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Garmin Manuals

Find free Garmin GT30-TM - Transom Mount DownVü/SideVü 500 W CHIRP 455/800 kHz Scanning Transducer with Temp 12-pin manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Contact Information

Complete Garmin customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Garmin customer service rankings, employee comments and much more from our sister site.