Whirlpool WMH53520CS Support Question
Whirlpool WMH53520CS Support Question
Find answers below for this question about Whirlpool WMH53520CS.Need a Whirlpool WMH53520CS manual? We have 4 online manuals for this item!
Question posted by kerryclarke on June 1st, 2014
Good Morning, The Light Comes On And The Plate Spins But The Water Is Still Cold
Microwave is mounted and set up, the light comes on and the plate spins for the time selected but the water comes back out cold. Can you helpe
Current Answers
Answer #1: Posted by Odin on June 1st, 2014 6:40 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,700
Member since:
April 10th, 2010 Points: 41,236,700
See http://www.repairclinic.com/RepairHelp/Microwave-Repair/6-5-1447178-/Whirlpool-Microwave-WMH53520CS0-Troubleshooting and follow the first link.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WMH53520CS Manual Pages
Installation Guide - Page 1
...MICROWAVE HOOD COMBINATION SAFETY 1 INSTALLATION REQUIREMENTS 2
Tools and Parts 2 Remove Cardboard Template 2 Location Requirements 2 Product Dimensions 3 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Remove Mounting Plate...Install the Microwave Oven 9 Complete Installation 10 VENTING DESIGN SPECIFICATIONS 11 ASSISTANCE 12 Replacement Parts 12 Accessories 12
MICROWAVE HOOD ...
Installation Guide - Page 2
... metal screws (2) G. See User Instructions.)
NOTE: Depending on reordering, see "Replacement Parts" section. Set the cardboard template to the side and refer to Round Transition" illustration in "Venting Design Specifications" section... or roof
venting)
Not Shown:
Upper cabinet template
Mounting plate (attached to exist above the microwave oven so that the vent fits
properly, and the damper...
Installation Guide - Page 3
... 3 prong outlet must be grounded. Failure to whether the microwave oven is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. Recommended: ■ A time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven. The microwave oven is typical for the electric current.
upper cabinet and side...
Installation Guide - Page 4
... installation. NOTE: To avoid damage to the back of the microwave oven, remove it and set it may be used.
Louvered damper vent covers
4 NOTE: To avoid possible damage to the back of the microwave oven. Remove any remaining contents from the microwave oven cavity.
2. If the mounting plate is being handled.
4.
A
A. Blower motor
5. Rotate blower motor 180°...
Installation Guide - Page 5
... motor face back of "Wall Venting Installation Only."
Damper plate tabs D. 7. Reattach blower motor to back of microwave oven with flat sides facing the back of "Wall Venting Installation Only." Reattach damper plate. Make sure damper plate tabs are inserted into microwave oven. A
B
C
6.
D
A. Damper plate B. Screws C. Slots
9. Repeat Step 1 from "Wall Venting Installation Only...
Installation Guide - Page 6
... at One End Hole Figure 3
Wall Studs at End Holes Figure 2
B
C
C
C
D
B
D
A
A
A
A
E
E
E
E
F
F
NOTE: If wall stud is within the cabinet opening, do not install the microwave oven.
1. Support tabs F. Mounting plate center markers
6 Locate Wall Stud(s)
NOTE: If no wall studs exist within 6" (15.2 cm) of the vertical centerline (see "Mark Rear Wall" section), only...
Installation Guide - Page 7
...The blackened holes in Step 9 to the wall at both sides of "Mark Rear Wall."
2. Set the mounting plate aside. Using a straightedge, draw the 2 horizontal, level lines through the marks made in the ...one corner of upper cabinet
3.
They must each other.
Rear wall B. Mark Rear Wall
The microwave oven must be installed on the wall, making sure it is level, and that the end holes ...
Installation Guide - Page 8
... with tape or thumbtacks. Start a toggle nut on at End Holes (Figures 1 and 2)
NOTE: The mounting plate must be against drywall. 5. The template has trim lines to use as guides.
■ If the wall behind the microwave oven (as at both ends. 1. Refer to the wall at both end holes drilled into the wall...
Installation Guide - Page 9
...Using a keyhole saw, cut out the rectangular area. Position the damper assembly on Upper Cabinet Template.
8. Handle the microwave oven gently. 1.
Back of the microwave oven so that damper blade moves freely, and opens fully.
2. Mounting plate B. Push microwave oven against mounting plate and hold in back or other injury. This hole is being handled. Metal cabinet B. Cut 3/4" (19 mm...
Installation Guide - Page 10
Using 2 or more people, lift microwave oven off of mounting plate, and set aside on the turntable, and programming a cook time of 1 minute at 100% power. With the microwave oven centered, and with sheet metal screw.
A
B
A. Install filters. NOTE: The screw cannot be added. Upper cabinet cutout E. Damper plate
Electrical Shock Hazard
Plug into grounded 3 prong outlet. 3.
Do not ...
Installation Guide - Page 11
...C. Rectangular to Round Transition NOTE: The minimum 3" (7.6 cm) clearance must exist between the top of the microwave oven and the transition piece. Roof cap B. 6" (15.2 cm) min. Do not vent exhaust air into ...the most direct route by minimizing the length of the vent and number of the microwave oven and the rectangular to round transition piece so that there is intended for wall venting...
Installation Guide - Page 12
...Mounting Plate
■ Upper Cabinet Template
■ Mounting Screw Kit (includes parts A-G in "Parts Supplied" in the system. Recommended Vent Length
A 3¹⁄₄" x 10" (8.3 x 25.4 cm) rectangular or 6" (15.2 cm) round vent should be used.
For best performance, use when installing this microwave oven... microwave oven model number and serial number.
The filler panels come in...
Use & Care Guide - Page 1
...should experience a problem not covered in this high-quality product.
IMPORTANT SAFETY INSTRUCTIONS
When using the microwave oven.
■ Read and follow instructions. See "GROUNDING INSTRUCTIONS" found in this section and in the microwave oven.
■ The microwave oven must be followed, including the following:
WARNING: To reduce the risk of others . SAVE THESE INSTRUCTIONS...
Use & Care Guide - Page 2
... (3) Door seals and sealing surfaces.
(d) The oven should be allowed to stand in the microwave oven for a short time before placing bags in oven.
- Do not use . It is in ...MICROWAVE ENERGY
(a) Do not attempt to operate this microwave oven outdoors. Carefully attend the microwave oven when paper, plastic, or other utensil into the container.
■ Do not mount over edge of oven...
Use & Care Guide - Page 4
... the prompts to practice using the Vent Fan control.
Comes on automatically as it heats, and adjusts the cooking time accordingly.
4 Auto Vent Fan (on the temperature from the range or cooktop below the microwave oven. Dynamic Fan Sensing (on the magnetron. See "Microwave Oven Care" section.
NOTE: Light Timer uses 12-hour clock only. Cook functions...
Use & Care Guide - Page 5
... first 20 seconds of water beside it heats, and adjusts the cooking time accordingly. The cook power for the next stage, then enter the cook time and cook power of cook time at 100%.
Warm Hold can be adjusted for automatic cooking functions by itself or can result in the microwave oven. Manual Cooking/Stage Cooking...
Use & Care Guide - Page 6
..., and is time to reset filter status.
■ Grease filters: Grease filters are off and the microwave oven is not recommended.
Dishwasher cleaning is cool. Close bulb cover, replace vent grille, and secure with screw.
■ Cavity light: The cavity light bulb is located behind the vent grille at the top front of microwave oven.
See "Settings" section...
Use & Care Guide - Page 7
... comes on and off . Make sure the microwave oven door and sealing surfaces are clean. ■ Frequency - If you avoid a service call. If water does not
heat, try the steps in the microwave oven
Turntable alternates rotation directions Display shows messages Fan running during microwave oven operation.
7 The microwave oven's cooling fan, which is set properly. If microwave oven...
Use & Care Guide - Page 8
...is not available.
10.
You can write to repair or replace appliance light bulbs, air filters or water filters.
The cost of repair or replacement under this limited warranty. Please... an inaccessible location or is used in the country in China Proof of the microwave oven opening, behind the door. Costs associated with published installation instructions.
11. Service ...
Warranty Information - Page 1
... if it was purchased. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. WHIRLPOOL SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. Service calls...VARY FROM STATE TO STATE OR PROVINCE TO PROVINCE. The removal and reinstallation of the microwave oven opening, behind the door. This warranty is not installed in an inaccessible location or ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
How to remove odors from front-load washer (for washers with stored program for cleaning washer)
... Select Low Spin Speed. If the washer displays the letters "rL" (Remove Load) in the Estimated Time ...Set the End of buttons must be interrupted by pressing the Pause/Cancel button. However, this cleaning process. If the washer displays the letters "Ab" (Add Bleach). To activate the cleaning cycle, a specific combination of Cycle Signal to start - Select Warm/Cold Water... -
How to get the best performance from my washer - Cabrio® HE washer with Dispensers in Corners
... helps reduce drying time. Select a spin speed that fits the load you determine the right cycle for this cycle to wash small, lightly soiled...settings help reduce tangling and wrinkling. Higher soil level settings help reduce wrinkling and tangling. High spin speeds extract more than others to help keep large items from tangling and balling up. Colder water temperatures help... -
Warm or hot wash temperatures are cooler than I expect - Top-load HE washer with Dispenser Drawer - video
... and Warm wash selections. video The water temperature is to comfortable swimming-pool water temperature. Cabrio® washer with hot. Learn more cold water with Dispensers in cold water to regulate the temperature of video Why are the Warm or Hot wash temperatures cooler than I expect - hot water heater and cold from your hot-water heater setting. Top-load...
Similar Questions
I Have A Gmh5205xvs-0 Not Cooking
I unplugged the unit, plugged back in, reset clock, cleared anything that didnt look right. All the ...
I unplugged the unit, plugged back in, reset clock, cleared anything that didnt look right. All the ...
(Posted by susanhedi 2 years ago)
Light Operation Whirlpool Micro Model Wmh 31017aw - 2
The light was working fine, high low, off. Recently when you push the light button, FULL appears in ...
The light was working fine, high low, off. Recently when you push the light button, FULL appears in ...
(Posted by denmo20 8 years ago)
Microwave Exhaust Fan
I have repositioned the exhaust fan so that the fins are facing out the back of the microwave. When ...
I have repositioned the exhaust fan so that the fins are facing out the back of the microwave. When ...
(Posted by Anonymous-153793 8 years ago)
Wmh53520cs Cavity Light Bulb Wattage
can the cavity light bulb be replaced with a higher watt bulb? just bought microwave. existing bulb ...
can the cavity light bulb be replaced with a higher watt bulb? just bought microwave. existing bulb ...
(Posted by Anonymous-134788 10 years ago)
Is There A Interior Light In This Microwave?
(Posted by ceberhardt 12 years ago)