Whirlpool MH1170XSQ Support Question
Whirlpool MH1170XSQ Support Question
Find answers below for this question about Whirlpool MH1170XSQ.Need a Whirlpool MH1170XSQ manual? We have 3 online manuals for this item!
Question posted by cbosley129 on May 26th, 2012
Charcoal Filter
How do I change the charcoal filter?
Current Answers
Related Whirlpool MH1170XSQ Manual Pages
User Instructions - Page 1
...symbol alerts you to excessive microwave energy:
■ Install or locate the microwave oven only in accordance with the provided Installation Instructions.
■ Read all safety ... instructions are able to properly grounded outlet. IMPORTANT SAFETY INSTRUCTIONS
When using the microwave oven.
■ Read and follow instructions. See "GROUNDING INSTRUCTIONS" found in this manual...
User Instructions - Page 2
... it is no damage to the: (1) Door (bent), (2) Hinges and latches (broken or loosened), (3) Door seals and sealing surfaces.
(d) The oven should not be allowed to accumulate on hood or filter.
■ Do not use paper products when appliance is operated in the "PAN BROWN" mode (on models with this feature).
■...
User Instructions - Page 3
...the Cancel control for 3 seconds until 2 tones sound and padlock icon appears in the display. See "Microwave Oven Care" section. Observe all tones.
Touch number pad "1" for SLOW, "2" for NORMAL or "3" for about ... is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. Settings
Clock
12-hour (12:00-11:59). Enter time. 3. Touch CLOCK or...
User Instructions - Page 4
... be cleaned, and should be kept warm in the microwave oven detects moisture released from underside of microwave oven, and clean monthly.
■ Charcoal filter: The charcoal filter is replaceable.
4
Sensor Cooking (on the underside of the microwave oven, and is(are off and the microwave oven is not recommended. Always follow a cooking cycle. Dishwasher cleaning is cool...
User Instructions - Page 5
.... Turntable alternates rotation directions ■ This is an error indicator. Call for some models) is off .
The microwave oven's cooling fan (on some models) ■ Rack clip ■ Rack support ■ Grease filter ■ Charcoal filter ■ Cooktop light bulb ■ Cavity light bulb
■ Pan and handle ■ Steamer vessel Cleaning Supplies ■...
User Instructions - Page 6
... appliance.
9. Any food loss due to repair or replace appliance light bulbs, air filters or water filters. Major appliances with published installation instructions.
11. SOME STATES AND PROVINCES DO NOT ALLOW... BY LAW.
Please keep this limited warranty does not apply.
The cost of the microwave oven opening, behind the door. This limited warranty is valid only in a remote area where ...
Installation Instructions - Page 1
... symbol. See "Installation Requirements" section for use above electric or gas cooking products up to Wall 8 Prepare Upper Cabinet 8 Install Damper Assembly 9 Install the Microwave Oven 9 Complete Installation 10 VENTING DESIGN SPECIFICATIONS 11 ASSISTANCE 12 Replacement Parts 12 Accessories 12
MICROWAVE HOOD COMBINATION SAFETY
Your safety and the safety of your...
Installation Instructions - Page 2
... cabinet and building materials are not designed to separate the template from the
rest of packaging)
Aluminum grease filters
Charcoal filters (Depending on model, aluminum grease filter and charcoal filter may not be sure to exist above the microwave oven so that the vent fits
properly, and the damper blade opens freely and fully. Location Requirements
Check...
Installation Instructions - Page 3
... cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. Electrical Shock Hazard Plug into an outlet that is properly grounded. Required:
■ A ...time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven. Do not remove ground prong. In the event of an electrical short circuit, grounding reduces ...
Installation Instructions - Page 4
... and set for recirculation installation. Keep the damper assembly in case the venting method is changed, or the microwave oven is being handled. A Screws B. Screws (in another location where wall or roof venting may be made to the microwave oven, do not grip or use the door or door handle while the microwave...
Installation Instructions - Page 5
...removed in Step 1. Secure damper plate with flat sides facing the back of the microwave oven (as shown), performance will be reattached to back of "Wall Venting Installation Only."
5... blower motor so that exhaust ports face the back of the microwave oven. Lower blower motor back into the microwave oven.
5. Reattach damper plate.
Slots
8. Repeat Step 1 from "Wall...
Installation Instructions - Page 6
... draw a plumb line down each stud center.
Mounting plate center markers
6
See illustrations in "Possible Wall Stud Configurations." Cabinet opening , do not install the microwave oven.
1. Holes for lag screws E. Mark the center of the wall stud(s) within the cabinet opening vertical centerline C. Support tabs F. Possible Wall Stud Configurations These depictions...
Installation Instructions - Page 7
... ideal hole locations.
7. Using a keyhole saw, cut out the venting cutout area. The blackened holes in "Locate Wall Stud(s)" section.
7 Mark Rear Wall
The microwave oven must
align with front edge of cabinet.
Installation Instructions - Page 8
... , trim the template edges so that the holes cut into the wall stud at End Holes" in the "Drill Holes in Step 6 of the microwave oven. Securely tighten the lag screws. Drill a 3/16" (5 mm) hole into the upper cabinet align with toggle nut through the wall and to
points "D" and "E" on...
Installation Instructions - Page 9
...(3.8 cm) diameter hole at the top, and the damper blade opens away from the microwave oven.
Position the damper assembly on the template. Using 2 or more people to the upper cabinet...6.
Failure to be installed around the supply cord hole, as shown. Damper assembly C. Rotate microwave oven up toward upper cabinet. Check that the damper blade hinge is being handled.
5. Cut 3/4" (...
Installation Instructions - Page 10
...Damper plate
Electrical Shock Hazard
Plug into grounded 3 prong outlet. 3. Check the operation of microwave oven by operating the vent fan. 5. Save Installation Instructions for future use an extension cord. Adjust...programming a cook time of the damper plate. Failure to install filters into your model. Plug microwave oven into a grounded 3 prong outlet.
Loosen mounting plate screws. ...
Installation Instructions - Page 11
...minimum 3" (7.6 cm) clearance must exist between the top of the microwave oven and the rectangular to round transition piece so that there is intended for architectural... F. Vent extension piece, at least 3" (7.6 cm) of clearance between the top of the microwave oven and the transition piece. VENTING DESIGN SPECIFICATIONS
This section is proper clearance within walls or
ceilings, attics...
Installation Instructions - Page 12
...99403
White Black Biscuit Stainless Steel Almond
See your model number located on the front facing of the microwave oven opening . Replacement Parts
If any of vent.
See the following examples:
3¹⁄₄" x 10"...SP PN W10191955A
© 2008. For best performance, use when installing this microwave oven in pairs. In addition, a rectangular 3" (7.6 cm) extension vent between the ...
Dimensions - Page 1
...as standard elbows. For complete details, see Installation
our products, we reserve the right to change without notice.
Grounded 3 prong outlet
Roof venting
roof cap
Wall venting
wall cap
3-1/4" x... not be able to seal exterior wall or roof opening . Specifications subject to the microwave oven hood. Exact dimensions may vary depending on type of
3-1/4" x 10" system = 73 ...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
What should I do when it's time to replace the aluminum filter/light lens, or charcoal filter pads on my convertible range hood?
... to ask the our representative about other Whirlpool Product Accessories, like new. When it 's time to replace the aluminum filter/light lens, or charcoal filter pads on my microwave oven? These parts are made to the same exacting specifications used to build every new Whirlpool appliance. What type of models sold, we... -
How do I remove and replace the charcoal filter on my microwave oven?
... embedded dirt and grease. Replacing Filters The grease filters should be replaced every 6 to 12 months. Remove each charcoal filter by calling the Customer eXperience Center at least once a month. To clean the grease filters in the filters.Do not use ammonia or corrosive cleaning agents such as lye based oven cleaners. To Remove: Remove... -
How do I replace the grease filters in my microwave oven?
... to receive a 10% discount on my microwave oven? Find Manuals & Ordering replacement parts or accessories FAQs Knowledgebase search tips What should I do I replace the grease filters in place. The charcoal filters cannot be washed and should be replaced every 6 to replace the aluminum filter/light lens, or charcoal filter pads on the outer edge of the...
Similar Questions
Microwave Quits Heating After 2 Minutes
When we use the microwave, for popcorn for example, we set the timer for 3 minutes or however long i...
When we use the microwave, for popcorn for example, we set the timer for 3 minutes or however long i...
(Posted by suntravel 7 years ago)
What Is The Grease Filter Manufacture Part Number
(Posted by kfont72 11 years ago)
Where Can I Buy A Charcoal Filter In Toronto?
(Posted by sandra881 11 years ago)
Charcoal Filters
I am looking for the charcoal filters, Where can I buy them?
I am looking for the charcoal filters, Where can I buy them?
(Posted by flboricua67 11 years ago)
How Do I Change The Charcoal Filter?
I need to change the charcoal filter on my WMH1162xvs1 microwave. It is a combination hood and under...
I need to change the charcoal filter on my WMH1162xvs1 microwave. It is a combination hood and under...
(Posted by jimruth1972 11 years ago)