Uniden DCX640 Support Question
Uniden DCX640 Support Question
Find answers below for this question about Uniden DCX640.Need a Uniden DCX640 manual? We have 1 online manual for this item!
Question posted by rajinderkchhabra on April 6th, 2014
The Handsets Are Charged On The Base Unit But Does Not Charge On The Cradles.
Cradles seems to be good and indicating the charging light. I have cleaned as per manual but to no effect. Please advise reasons and solution. Thanks
Current Answers
Answer #1: Posted by BusterDoogen on May 17th, 2014 10:45 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
It would seem to be the the handset cradles have failed. The adapter(s) are probably fried.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Uniden DCX640 Manual Pages
English Owners Manual - Page 2
... detailed operation, refer to the main base unit of these items are expanding (see "Expanding Your Phone"). Welcome
Congratulations on your home as long as you have AC power is for use with the cordless telephone you are missing or damaged, contact the Uniden Parts Department.
• Cordless Handset • Charging Cradle • Battery Pack (BT-446)
(Capacity...
English Owners Manual - Page 3
... notches fit into place.
5 Place the handset in the charging cradle with the keypad facing forward.
• Use only the Uniden battery (BT-446) supplied with your handset on the battery wires. If the connection is registered to main base unit. • Fully charge the battery pack.
1 Press down on the handset battery case cover (use the finger...
English Owners Manual - Page 4
... charged, the phone is programmed to eliminate functions in standby mode, none of the telephone and damage the finish. Cleaning the battery charging contacts
To maintain a good charge, it is important to the charging cradle. Battery Information
Low battery alert
When the batteries are on a call, complete your conversation as quickly as possible, and return the handset to clean the charging...
English Owners Manual - Page 5
..., check to begin registration. (Picture is the DCT646 series main base.)
3 While the handset is in the main base unit to see the owner's manual supplied with the DCX640 handset. If Registration Failed appears, please try these steps again.
1
DCX640 Handset
Charger
Charge the handset for 15-20 hours.
2 Place the extra handset in standby mode.
• Standby Mode - 3 Make sure the...
English Owners Manual - Page 6
...terminals allowed to be ensured when using this terminal equipment is confirmed by the owner's manual, could void your authority to reduce lead content in our PVC coated cords in ...signifies that registration was performed based on a Declaration of Conformity indicating that may not be connected to standby mode.
• When you will hear a beep and the phone will return to a telephone ...
English Owners Manual - Page 7
...manual for a defect or malfunction covered by this warranty, (E) used as part of any conversion kits, subassemblies, or any configurations not sold by Uniden, (C) improperly installed, (D) serviced or repaired by someone other rights which vary from defects in its representatives in effect, warrantor will either repair or replace the defective unit...not maintained as reasonable or necessary, ...
Similar Questions
Does The Base Unit Have A Speakerphone Button??
Does the main base unit have a speakerphone button?
Does the main base unit have a speakerphone button?
(Posted by richardpence 8 years ago)
Bought Used Dcx 640 Handset& Charger, But Can't Get It To Register On My Base
I have a DCT series with a base and three handsets. I purchased a used DCX 640 handset and charger t...
I have a DCT series with a base and three handsets. I purchased a used DCX 640 handset and charger t...
(Posted by mpelander2 10 years ago)
How Do I Reset The Base Unit? I Have Tried To Unplug Everything But That Doesn't
trying to turn off my silent mode on my cordless uniden dec 6.0 phone. holding down the # sign two...
trying to turn off my silent mode on my cordless uniden dec 6.0 phone. holding down the # sign two...
(Posted by ws49 11 years ago)
The #1 Handset Near The Base Unit But Show ¡±out Of Range On The Display, And Th
THE #1 HANDSET NEAR THE BASE UNIT BUT SHOW ”OUT OF RANGE on the display, and then the handset ...
THE #1 HANDSET NEAR THE BASE UNIT BUT SHOW ”OUT OF RANGE on the display, and then the handset ...
(Posted by hlx5703 13 years ago)