Home » Troy-Bilt » Lawn & Garden » Troy-Bilt TB675

Troy-Bilt TB675 Support Question

Find answers below for this question about Troy-Bilt TB675.
Need a Troy-Bilt TB675 manual? We have 1 online manual for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by jake5070 on April 9th, 2014

How To Rewind Pull Cord On Troy Built Model Tb675 Ec

The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Troy-Bilt TB675 Manual Pages

Operation Manual - Page 1

Operator's Manual Electric Start Capable 4-Cycle Trimmer TB675 EC TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 ...

Operation Manual - Page 3

... with water or any other than the speed needed to instruct other liquid. The operator and unit must always be in the starting position whenever pulling the starter rope. Do not operate the unit before starting the unit. • Use the unit only in a stable position while starting . Vibration is dusty...

Operation Manual - Page 7

... upper and lower shafts prior to the unit, shut the unit off before removing or installing an attachment. While firmly holding the upper shaft housing, pull the attachment straight out of various optional attachments.

Operation Manual - Page 10

...Continue to Position 3 (Fig. 10) and continue warming the engine for 2-5 minutes, or as needed . Pull the starter rope with a controlled and steady motion 5 times (Fig. 11). 7. Move the choke lever to... MINUTES AND THE ENGINE IS HOT... If the engine speed fluctuates in a stable position when pulling the starter rope (Fig. 11). Release the throttle control and allow the engine to Checking ...

Operation Manual - Page 13

... emissions control devices, such as the spark arrestor, muffler, carburetor, etc. Push the line through the cutting head until a few inches protrude from starting accidentally. Pull the line until about these required maintenance procedures at 38 hours MAINTENANCE REQUIRED • Clean and re-oil the air filter. NOTE: Some maintenance procedures...

Operation Manual - Page 16

... the unit. Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. Grasp the spark plug boot firmly and pull it to set the air gap at a time (as follows: 1. Grit in . (0.635 mm) Fig. 25 16 Install the spark plug in the cylinder head...

Operation Manual - Page 17

... such as pine and lemon, and solvents such as kerosene, can damage plastic. If this is not possible, store the unit vertically with a soft cloth. Pull the starter rope slowly to clean the outside of children. Household cleaners that has been stored for more than 30 days. Store the unit in...

Operation Manual - Page 18

... line Clean the inner reel and outer spool Open the cutting head and remove the welded section Rewind the line Stop the unit, push the bump knob and pull the line until 4 inches (102 mm) is outside of line The inner reel is bound up The cutting head is dirty The line...

Operation Manual - Page 20

... below is used in the following cases: A. Spark Plugs, Carburetor Adjustments, Filters B. Wear items - Troy-Bilt reserves the right to change or improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily...