Troy-Bilt TB675 Support Question
Troy-Bilt TB675 Support Question
Find answers below for this question about Troy-Bilt TB675.Need a Troy-Bilt TB675 manual? We have 1 online manual for this item!
Question posted by gnidrahmk on July 16th, 2014
Jumpstart Tb675 Ec Throttle Control
The throttle control ceased to work today in mid use. I have cleaned the air filter. What do I need to do?
Current Answers
Related Troy-Bilt TB675 Manual Pages
Operation Manual - Page 1
... our website: www.troybilt.com (U.S.) or www.troybilt.ca (Canada). When servicing, use only identical replacement parts.
769-08458 / 02
All information, illustrations, and specifications in...4-Cycle Trimmer
TB675 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage ...
Operation Manual - Page 2
..., maintained in effective working order, or the ...damaged parts.
• Only use .
• Read the...clean, well-ventilated outdoor area where there are not substitutes for fuel leaks. The instructions or warnings they are approached, stop the engine and allow it to the operation or maintenance of such materials.
• Always stop the unit immediately.
• Squeeze the throttle control...
Operation Manual - Page 3
... or dust mask if the operation is idling. Take extra care when working on steep slopes or inclines.
• Keep hands, face, and feet...cleaning, storing, transporting or replacing any other than the speed needed to Starting and Stopping.
• Use the right tool. Carefully remove vegetation and other users. Clean the unit after the unit is not in use . Refer to them often and use...
Operation Manual - Page 4
...Use a full face shield when needed.
• UNLEADED FUEL Always use clean, fresh unleaded fuel.
• OIL Refer to the operator and/or bystanders.
• WEAR EYE AND HEARING PROTECTION
WARNING: Thrown objects and loud noise can be used... unit.
SYMBOL MEANING
• ON/OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully...
Operation Manual - Page 5
... Housing
Air Filter Cover
Throttle Control
Fuel Cap Choke Lever
Coupler
Oil Fill ...Plug
Cutting Head
Cutting Head Shield
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, 4-Cycle Displacement 30 cc (1.83 cu. We reserve the right to make changes at the time of printing. Other optional accessories may be used...
Operation Manual - Page 6
... tighten the bolt completely.
3. Shaft Grip
Minimum 6 in place. Place the cutting head shield onto the mount bracket. Using a #2 Phillips screwdriver, tighten the screws until finger tight.
3. Tighten the screws equally.
Screws (2)
Use the following instructions if the cutting head shield is firmly in the handle should be to the location that...
Operation Manual - Page 7
...unit off before removing or installing an attachment. NOTE: Do not tighten the nut (Fig. 4). Using the wrong hole could lead to personal injury or damage to assembling the attachment.
1. While firmly ...make installing or removing the attachment easier, place the unit on the ground or on a work bench. Installing the Attachment
NOTE: Remove the protective cap and gray spacer from the upper...
Operation Manual - Page 8
...may have spilled. 7. Change the oil according to use clean oil of maintaining the proper oil level cannot be added before each use dirty oil. Unscrew the top of oil during ... correct type can cause premature engine wear and failure. Remove the paper seal. ADDING OIL: INITIAL USE
WARNING: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. DO NOT mix oil with a 2.03 fluid...
Operation Manual - Page 9
... IN THIS UNIT. NOTE: Do not overfill the tank. 4. NOTE: Dispose of ignition for spilled fuel. Definition of Blended Fuels Today's fuels are often a blend of performance problems. Use only fresh, clean unleaded gasoline. Wipe up . 2. It has been proven that may explode. Always stop the engine and allow it to federal, state...
Operation Manual - Page 10
Refer to squeeze the throttle control.
The On/Off switch is no need to turn the unit on. Crouch in the OFF (O) position until
the engine comes to squeeze the throttle control.
Continue to Checking the Oil Level.
2. Continue to squeeze the throttle control. Continue to squeeze the throttle control. The unit may be used during this time.
If it does...
Operation Manual - Page 11
... 2, and run the unit for 2-5 minutes, or as needed . If the engine speed fluctuates in intervals no need to the electric start accessory for the proper use of the electric start accessory from the unit.
11. Refer to Position 3. NOTE: SQUEEZE and HOLD the throttle control for more information. Run the electric start accessory operator...
Operation Manual - Page 12
... or hard soil. TIPS FOR BEST TRIMMING RESULTS • Keep the cutting head parallel to the ground. • Cut from the cutting head without the need for bending over. To release more difficult when the cutting line gets shorter. NOTE: Always keep the trimming line fully extended.
CAUTION: Do not remove...
Operation Manual - Page 13
...Clean and re-oil the air filter. DO NOT push the bump knob down while winding the line. MAINTENANCE SCHEDULE
Perform these procedures, take the unit to prevent the unit from each side of the emission control... line into the entry eyelet (Fig. 16).
Refer to the unit.
WARNING: Never use metal-reinforced line, wire, chain or
rope.
MAINTENANCE
WARNING: To prevent serious injury, ...
Operation Manual - Page 14
...: Make sure the O-ring is approximately
halfway up any old trimming line and/or obstructions. 4. Use a clean cloth to Adding Oil. Inspecting the Oil Level Window 1. The cutting head shield should fill the ...
O-Ring
14 CHECKING THE OIL LEVEL
WARNING: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. use . Set the unit on the outer
spool (Fig. 18). Wipe up the oil level ...
Operation Manual - Page 15
... not covered by the product warranty.
Lightly coat the air filter with clean SAE 30 oil. 5. Fig. 21
Fill Line
Fig. 22
Hole
Air Filter Housing
Tab
Air Filter Cover
Air Filter
Fig. 23
Cover Screw
15 Pour 2.03 fl.oz. (60 ml) of the bottle (Fig. 22). 6. NOTE: Use the empty oil bottle saved from entering the oil fill...
Operation Manual - Page 16
... the throttle control and let the engine idle. Stop the engine and allow it from the cylinder head with a replacement part #753-05784, a Champion RDZ4H or an equivalent spark plug.
4. ADJUSTING THE IDLE SPEED
WARNING: The cutting head may spin during idle speed
adjustments. If, after checking the fuel and cleaning the air filter, the...
Operation Manual - Page 17
... is not possible, store the unit vertically with a soft cloth. Thoroughly clean the unit and inspect it for Use after Long-term Storage
1. Repair or replace damaged parts and tighten loose screws...and drain all fuel has been drained from the cylinder. 2. Dispose of the unit. Use a small brush to clean the outside of old fuel according to federal, state and local regulations.
17 Store the...
Operation Manual - Page 18
... The spark plug is fouled
Drain the fuel tank and add fresh fuel Stop the engine and clean the cutting head Clean or replace the air filter
Drain the fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug
THE CUTTING HEAD WILL NOT ADVANCE LINE The cutting head is bound...
Operation Manual - Page 20
...does not provide coverage in Canada. Spark Plugs, Carburetor Adjustments, Filters B. This limited warranty shall not extend to P.O. Box 361131 ... sold through Troy-Bilt's authorized channels of the use the product. C. This limited warranty shall only... without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses...
Similar Questions
Tb4hb Ec Leaking Oil From Air Filter
tb4hb ecleaf blower leaking oil from air filter, what would be the cause?
tb4hb ecleaf blower leaking oil from air filter, what would be the cause?
(Posted by brentpowell 8 years ago)
Why Does My Troy Built Trimmer Tb675 Ec Overheat ?
(Posted by Anonymous-154291 8 years ago)
How To Rewind Pull Cord On Troy Built Model Tb675 Ec
(Posted by jake5070 10 years ago)
Oil For Troy-bilt Tb675
what kind of oil should I put in my Troy-Bilt TB675
what kind of oil should I put in my Troy-Bilt TB675
(Posted by herjeac 10 years ago)