Troy-Bilt TB6044 XP Support Question
Troy-Bilt TB6044 XP Support Question
Find answers below for this question about Troy-Bilt TB6044 XP.Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!
Question posted by Rustybo3 on May 17th, 2020
Stops Running
will start and run for about 10 minutes and then it will slows till it quits
Requests for more information
Request from joeg1698970 on July 12th, 2020 3:34 PM
Information on same problem - runs form 1-3 minutes and then dies.
Information on same problem - runs form 1-3 minutes and then dies.
Current Answers
Answer #1: Posted by ProfessorExpert on May 18th, 2020 12:05 PM
ProfessorExpert
Member since:
May 18th, 2020 Points: 100,920
Member since:
May 18th, 2020 Points: 100,920
It need to be charged for longer. If you charge it till its full and it still doesn't work there may be a leak in the battery and you may need to get a battery replacement.
Hopefully this was helpful, if so please rate my answer. Thanks!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Get 75 dollars for free by signing up at the below link.
https://app.joinupvoice.com/referral/XsQvDdwl5gAICys3#
Related Troy-Bilt TB6044 XP Manual Pages
Operation Manual - Page 1
...Copyright© 2012 MTD SOUTHWEST INC, All Rights Reserved.
10/12 For service, please call the Customer Support Department at... dealers near you. Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB6044 XP
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage ...
Operation Manual - Page 2
...familiar with a spark arrestor, maintained in any way.
DO NOT smoke. • Never start or run the unit inside a closed room or building. Make all safety rules must be
followed. ...the fuel cap securely in a clean, well-ventilated outdoor area where there are approached, stop the engine and allow it requires replacement, ask your careful attention and understanding.
Failure to...
Operation Manual - Page 3
... parts. Do not run the unit at high speed when not in a dry place, secured or at the intended rate.
• Always stop moving parts have stopped. 3. Carefully remove ...instructions.
Always keep proper footing and balance. These are marked as such. Stop the unit. 2. Allow the unit to Starting and Stopping.
• Use the right tool. The operator and unit must always ...
Operation Manual - Page 4
.... SYMBOL MEANING
• SAFETY ALERT SYMBOL Indicates danger, warning or caution. SYMBOL MEANING
• ON/OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully and slowly, 10 times.
• THROWN OBJECTS AND ROTATING CUTTER CAN CAUSE SEVERE INJURY
WARNING: Small objects can be used...
Operation Manual - Page 5
...:
• #2 Phillips screwdriver • 3/8" Socket
Handle
On/Off Switch
Shaft Housing
Air Filter Cover
Throttle Control
Starter Rope Grip
Primer Bulb
Fuel Cap
Cold Weather Start Lever
Cutting Head
Coupler
Cutting Head Shield
Oil Fill Plug
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, 4-Cycle Displacement 32 cc (1.95 cu. KNOW...
Operation Manual - Page 8
... tank.
Pour the entire bottle into the oil fill hole (Fig. 7). This unit has a four- Reinstall the oil fill plug. Check the oil level before starting the unit. NOTE: This unit comes with gasoline. 6. ADDING OIL: INITIAL USE
WARNING: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. Change the oil according...
Operation Manual - Page 9
...10%...performance problems. Use only fresh, clean unleaded gasoline. Always stop the engine and allow it to inhibit corrosion and minimize...STA-BIL® or an equivalent • Drain the tank and run the engine dry before filling the fuel tank. Avoid creating a ... to avoid injury
from the fuel container and
the fueling site before starting the engine.
9 Keep sparks and open flames at least 30 ft...
Operation Manual - Page 10
... hesitation. Allow the engine to the Open position (Fig. 10).
6. NOTE: The engine is visible.
4. the engine does not start lever to Fueling the Unit.
STARTING AND STOPPING
WARNING: Operate this time. Check the oil level.
DO NOT move the cold weather start , begin the starting procedure with step 3. If fuel cannot be lethal in a confined...
Operation Manual - Page 11
... Closed position (Fig. 10).
the engine does not start accessory in intervals no need to Checking the Oil Level.
2. DO NOT move the cold weather start lever to warm up when it accelerates without hesitation. Remove the electric start port (Fig. 12). begin the starting procedure with an optional electric start lever to a complete stop (Fig. 8).
11...
Operation Manual - Page 12
... a Bump Head.
For best results, tap the bump knob on the ground while the unit is
running. A blade in tall grass may lead to serious personal injury or damage to the proper length if...trees, posts, fences, etc., rotate the whole unit so that it easily
contacts the grass without stopping the engine. To release more difficult when the cutting line gets shorter. Keep the left to ...
Operation Manual - Page 13
...dangerous projectiles. If necessary, remove any seasonal tune-up. Refer to prevent the unit from starting accidentally. Cut one 20 foot (6 m) length of terms and coverage for the emissions ...or
rope.
Turn the bump knob clockwise to the unit. FREQUENCY Every 10 hours
After the first 10 hours and at the frequency stated in the Specifications section. WARNING: ... is running.
Operation Manual - Page 14
... the Oil Level Window 1. Tab Hole
Fig. 18
Fig. 19
Oil Fill Hole
Maximum Oil Level
Fig. 20
Spool Cover Inner Reel Outer Spool
14 Stop the engine and allow it to overfill. 3. If the oil level is approximately
halfway up any oil that the engine is in the tabs on...
Operation Manual - Page 15
... filter housing (Fig. 23). 3. Lightly coat the air filter with clean SAE 30 oil. 5. MAINTAINING THE AIR FILTER
WARNING: To avoid serious personal injury, always stop
the engine and allow it to the right. Push the air filter cover back onto the air filter housing.
Allow ample time for complete drainage...
Operation Manual - Page 16
...turn the idle speed screw clockwise, 1/8 of engine power
MAINTAINING THE SPARK PLUG
1.
Stop the engine and allow it from the cylinder head with a 5/8-inch socket, turning ...the engine
stops, use a small Phillips screwdriver to cool. Use a feeler gauge to Starting and Stopping. 2. Do not over tighten.
6. NOTE: Careless adjustments can seriously damage the unit. Start the ...
Operation Manual - Page 17
... ensures that all of children. CLEANING AND STORAGE
CLEANING
WARNING: To avoid serious personal injury, always stop
the engine and allow it to run until it for any high quality motor oil into an approved container.
Start the engine and allow it to cool before storing. • Lock up the unit to prevent...
Operation Manual - Page 18
...days) The spark plug is fouled The cold weather start lever is in the closed position
SOLUTION
Fill the fuel tank with fresh fuel Press the primer bulb 10 times or until fuel is visible Drain the fuel tank...Clean the inner reel and outer spool Open the cutting head and remove the welded section Rewind the line Stop the unit, push the bump knob and pull the line until 4 inches (102 mm) is outside of...
Operation Manual - Page 20
..., Filters B. Troy-Bilt reserves the right to change or improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily replace a warranted product. (Some states do not allow limitations on how...
Parts Diagram - Page 1
...TB6044 XP
4-CYCLE TRIMMER
PPN 41ADZ6PC766
46
47
1
48
49
2 5
37 38
39 27
41
6
3
4
50
42
43
45
44 40
36 35
34
33
31
30 29
28
32
7 8
9
22 21
10 11 12 13
14
18
15
20
16
26
25
24
19
24
17
Item 1 2 3 4 5 6 7 8 9 10... Primer Top Cover Gasket Screw Starter Housing Assembly Screw Electric Start Adapter O-Ring Intake Port Boot Assembly Carburetor Gasket Insulator Insulator...
Parts Diagram - Page 2
MODEL TB6044 XP
4-CYCLE GAS TRIMMER
PPN 41ADZ6PC766
Item Part No. REPLACEMENT PARTS - Description
1 753-06887 Throttle Housing Assembly ... Shaft Assembly
7 753-06889 D-Handle Assembly (includes 8)
8 753-06040 Bolt
9 753-06886 Split Boom Coupler (includes 10)
10 7682
Coupler Anti-Rotation Screw
11 753-08162 Lower Drive Shaft Housing Assembly
12 753-06125 Shield Mounting Screws and Nuts
4...
Similar Questions
Troy Bilt Cs 4265
Could not start engine, replaced spark plug, started for 1 minute only after spread starter, and sto...
Could not start engine, replaced spark plug, started for 1 minute only after spread starter, and sto...
(Posted by fangchlee 7 years ago)
Changing Trimmer Head On Troy-bilt Tb6044 Xp
I have a TB6044 XP and want to replace the trimmer head with a Pivotrim hybrid. But cannot remove th...
I have a TB6044 XP and want to replace the trimmer head with a Pivotrim hybrid. But cannot remove th...
(Posted by GCP1 8 years ago)
Starter Cord Will Not Recoil.
I have a TB6044 xp 4-cycle gas trimmer. Recently I tried to start unit and the pull cord did not rec...
I have a TB6044 xp 4-cycle gas trimmer. Recently I tried to start unit and the pull cord did not rec...
(Posted by tstale 8 years ago)
My Tb225 Was Running Good And It Just Stopped Have You Had Any Problems With The
engine or tiller locking up. my engine will not turn over its locked up.any sugestons .
engine or tiller locking up. my engine will not turn over its locked up.any sugestons .
(Posted by daviderickson11 10 years ago)