Home » Troy-Bilt » Lawn & Garden » Troy-Bilt TB6044 XP

Troy-Bilt TB6044 XP Support Question

Find answers below for this question about Troy-Bilt TB6044 XP.
Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by wh8847 on August 13th, 2018

Pull Rope Not Engaging Motorcycle

pull rope still winds but not engaging motor to start motor. Can I fix?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on August 13th, 2018 8:52 AM

This answer was accepted by the poster of the original question.

Odin

Member since:
April 10th, 2010

Points: 41,236,670

1,070
points

Try pressing the primer bulb 10 times. If the issue persists (or if you require further explanation), you'll have to consult Troy-Bilt: use the contact information here--https://www.contacthelp.com/troy-bilt/customer-service.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Troy-Bilt TB6044 XP Manual Pages

Operation Manual - Page 1

Service on our website: www.troybilt.com (U.S.) or www.troybilt.ca (Canada). Operator's Manual Electric Start Capable 4-Cycle Trimmer TB6044 XP TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20 SAVE THESE INSTRUCTIONS SERVICE DO...

Operation Manual - Page 2

... U.S. Check with the controls and proper use metal-reinforced line, wire, chain or rope. Read the operator's manual and follow these requirements. Teens must be constructed, equipped .... Please read these instructions for fuel leaks. Operate this manual. keep these instructions before starting the engine. NOTE: Advises you are cracked, chipped, or damaged in a clean, ...

Operation Manual - Page 3

... (pilot lights, etc.) or sparks (switches, electrical motors, etc.). • Store the unit in the starting . Allow the unit to Starting and Stopping. • Use the right tool. Disconnect... faster than the maintenance procedures described in a stable position while starting position whenever pulling the starter rope. Wear ear/hearing protection when operating this tool for the cause...

Operation Manual - Page 4

...: Read the operator's manual(s) and follow all bystanders, especially children and pets, at high speed, causing injury. SYMBOL MEANING • ON/OFF STOP CONTROL ON / START / RUN • ON/OFF STOP CONTROL OFF or STOP • PRIMER BULB Push primer bulb, fully and slowly, 10 times. • THROWN OBJECTS AND ROTATING...

Operation Manual - Page 5

... Lockout ASSEMBLY TOOLS REQUIRED: • #2 Phillips screwdriver • 3/8" Socket Handle On/Off Switch Shaft Housing Air Filter Cover Throttle Control Starter Rope Grip Primer Bulb Fuel Cap Cold Weather Start Lever Cutting Head Coupler Cutting Head Shield Oil Fill Plug Line Cutting Blade SPECIFICATIONS* Engine Type Air-Cooled, 4-Cycle Displacement 32 cc...

Operation Manual - Page 7

... understand the manual that came with a string trimmer attachment, lock the release button into the primary hole (Fig. 5). 3. While firmly holding the upper shaft housing, pull the attachment straight out of various optional attachments. Press and hold the release button (Fig. 4). 3.

Operation Manual - Page 8

... use. NOTE: This unit comes with gasoline. 6. This unit has a four- NOTE: Make sure the O-ring is in the crankcase. Check the oil level before starting the unit. Reinstall the top of oil. 1. Refer to the fuel tank. cycle engine. Wipe up any oil that may have spilled. 7. Funnel Spout Oil...

Operation Manual - Page 9

...sparks and open flames at least 30 ft. (9.1 m) from the fuel container and the fueling site before starting the engine. 9 NOTE: Do not overfill the tank. 4. Wipe up any fuel that fuel containing greater... 1% water in the fuel can make fuel and oil separate, forming acids when stored. Do not start the engine until fuel vapors dissipate. 1. Position the unit with the fuel cap facing up. 2. ...

Operation Manual - Page 10

...Press and hold the On/Off switch in a stable position when pulling the starter rope (Fig. 11). Off (O) / Stop On ( I ) position at all times (Fig. 8). Refer to Checking the Oil Level. 2. Crouch in the ON ( I ) / Start Throttle Lockout STARTING INSTRUCTIONS 1. IF... WARNING: Avoid accidentally starting procedure with a controlled and steady motion until fuel is properly...

Operation Manual - Page 11

...the primer bulb until fuel is properly warmed up for the proper use of the electric start port (Fig. 12). Press the throttle lockout and squeeze the throttle control (Fig. 8)..... DO NOT squeeze the throttle control (Fig. 8). Run the electric start lever to 60 seconds. Remove the electric start accessory (items sold separately). DO NOT squeeze the throttle control. Continue warming...

Operation Manual - Page 13

...etc. NOTE: Always use metal-reinforced line, wire, chain or rope. These can break off and become dangerous projectiles. Push the line...inches (12.7 cm) protrude from starting accidentally. DO NOT align the arrows when the line winding is running. These procedures should ... be a part of the cutting head (Fig. 17). Pull the line until a few inches protrude from the cutting head...

Operation Manual - Page 16

... using a torque wrench, torque to Starting and Stopping. 2. Refer to : 110-120 in.•lb. (12.3-13.5 N•m). Release the throttle control and let the engine idle. Stop the engine and allow it with a 5/8-inch socket, turning counterclockwise. Grasp the spark plug boot firmly and pull it clockwise until the engine idles...

Operation Manual - Page 17

...unit out of the reach of the oil from the carburetor. 3. Wipe off any high quality motor oil into an approved container. STORAGE • Never store a fueled unit where fumes may reach ... This ensures that all of children. Pull the starter rope slowly to prevent unauthorized use or damage. • Store the unit in a horizontal position. Start the engine and allow it for Use...

Operation Manual - Page 18

...pressed enough The fuel is old (over 30 days) The spark plug is fouled The cold weather start lever is in the closed position SOLUTION Fill the fuel tank with fresh fuel Press the primer bulb... cutting head and remove the welded section Rewind the line Stop the unit, push the bump knob and pull the line until 4 inches (102 mm) is outside of the cutting head THE CUTTING LINE ADVANCES UNCONTROLLABLY...

Operation Manual - Page 20

...the date of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for a listing in the ... possessions and territories. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars, Cultivator Tines, Blades. You assume the risk and...

Parts Diagram - Page 1

MODEL TB6044 XP 4-CYCLE TRIMMER PPN 41ADZ6PC766 46 47 1 48 49 2 5 37 38 39 27 41 6 3 4 50 42...05053 769-08524 / 01 Description Top Housing Assembly Air Purge Primer Top Cover Gasket Screw Starter Housing Assembly Screw Electric Start Adapter O-Ring Intake Port Boot Assembly Carburetor Gasket Insulator Insulator Gasket Washer Screw Aircleaner Assembly Screw Screw Carburetor Assembly O-...

Parts Diagram - Page 2

MODEL TB6044 XP 4-CYCLE GAS TRIMMER PPN 41ADZ6PC766 Item Part No. Description 1 753-06887 Throttle Housing Assembly (includes 2 - 5) 2 791-182405 Switch Assembly 3 753-05171 Throttle Lock-out 4 753-...