Troy-Bilt TB225 Support Question
Troy-Bilt TB225 Support Question
Find answers below for this question about Troy-Bilt TB225.Need a Troy-Bilt TB225 manual? We have 1 online manual for this item!
Question posted by probie11 on October 10th, 2021
How To Replace Pull Rope
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Troy-Bilt TB225 Manual Pages
Operation Manual - Page 1
...www.troybilt.com (U.S.) or www.troybilt.ca (Canada). When servicing, use only identical replacement parts.
769-08657 / 00
All information, illustrations, and specifications in Canada. For ...PROOF OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE. Operator's Manual
2-Cycle Gas Cultivator
TB225
TABLE OF CONTENTS Service Information 1 Rules for Safe Operation 2 Know Your Unit 5 Specifications...
Operation Manual - Page 2
... Squeeze the throttle control and check that are approached, stop the engine and allow it requires replacement, ask your careful attention and understanding. Operate this unit when tired, ill or under the ... or damaged in the tank before using the unit, all warnings and safety instructions. Replace parts that it returns automatically to the idle position. If you to liability or a ...
Operation Manual - Page 3
... a authorized service dealer.
• Before inspecting, servicing, cleaning, storing, transporting or replacing any gum buildup. Wear a face mask or dust mask if the operation is idling.... Be in daylight or good artificial light.
• Avoid accidental starting position whenever pulling the starter rope. Do not operate the unit with anything before repairing damage. Use of trouble....
Operation Manual - Page 4
... slopes or inclines.
• PLACE RIGHT FOOT HERE Avoid accidental starting position whenever pulling the starter rope. Keep hands and feet away from the rotating rotor.
• KEEP BYSTANDERS AWAY... a stable position while starting.
4 Read the operator's manual for a short time.
• GARDEN CULTIVATORS - May be in the starting . Keep away from rotating tines.
• NO STEP ...
Operation Manual - Page 5
NO ASSEMBLY TOOLS REQUIRED
KNOW YOUR UNIT
Air Filter Cover
Muffler Spark Plug
Starter Rope Grip
Choke Lever
Throttle Control
Handlebar Knobs
Upper Handle On/Off Control
Primer Bulb
Tine Guard Gear Box
Fuel Cap Lower ... available at any time without notice.
5 APPLICATION • Cultivating sod and light to make changes at the time of printing. in garden areas, around trees, etc.
Operation Manual - Page 8
... throttle control with one foot to turn the unit on. Use one hand.
Move the choke lever to Position 3 and squeeze the throttle control. Pull the starter rope 3-5 times to Position 2 and continue the warm-up when the engine accelerates without hesitation. The unit may be in a stable position while starting . The...
Operation Manual - Page 9
... Instructions section. 3. Refer to cool. OPERATING TIPS 1. As cultivating action begins, pull back on the cultivator so that
the tines can penetrate the ground. Start the ..., continue at a moderate pace until you .
6. Pull the cultivator backwards to 6 inches. ADJUSTING THE TINE DEPTH The tines should penetrate most garden soils approximately 4 to improve the depth of injury
when...
Operation Manual - Page 10
... horizontal position.
NOTE: All installation instructions are explained from starting accidentally. Reconnect the spark plug wire. NOTE: Maintenance, replacement, or repair of the emission control devices and system may require special tools or skills. Check the spark plug condition ... re-oil the air filter.
Grasp the spark plug wire
firmly and pull the cap from each
other (Fig. 8).
Operation Manual - Page 11
Wash the filter in contact with the cover screw hole (Fig. 10). Apply enough clean SAE 30 motor oil to spread and remove excess oil. 6. Replace the air filter and the screen that sits behind it (Fig. 9). 3. Insert the hooks on the air filter
housing into the slots on acceleration • ...
Operation Manual - Page 12
...the spark plug wire.
0.025 in .
socket counterclockwise. If the spark plug is cracked, fouled or dirty, replace it with a 5/8-inch socket, turning it to set the air gap at 0.025 in .•lb. (...12.3-13.5 N•m). Use a feeler gauge to cool. Grasp the spark plug wire firmly and pull the cap from around the spark plug. NOTE: If using a torque wrench, torque to: 110-120 in ...
Operation Manual - Page 13
... and drain all fuel has been drained from the cylinder before you clean or service it stalls. Repair or replace damaged parts and tighten loose screws, nuts or bolts. Wipe off and allow it to run until it ....put 5 drops of the unit and to start the unit after storage. 4. Pull the starter rope slowly to cool. Reinstall the spark plug. Thoroughly clean the unit and inspect for storage.
13
Operation Manual - Page 14
... primer bulb 10 times or until fuel is visible Place choke lever into position 3, squeeze the throttle trigger and pull the starter rope Drain the fuel tank and add fresh, properly mixed fuel Replace or clean the spark plug
ENGINE WILL NOT IDLE Air filter is plugged The fuel is old (over 30...
Operation Manual - Page 16
...improve the design of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for products sold . Troy...state. Tune-ups - Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars,
Cultivator Tines, Blades. How State Law Relates to this...
Similar Questions
How To Replace Pull Rope On Troybilt Trimmer Tb575es
(Posted by jwclevenger 3 years ago)
How To Replace Pull String On A Tv 223 2 Cycle Gas Cultivator
(Posted by tonypeg1 8 years ago)