Troy-Bilt Colt FT Support Question
Troy-Bilt Colt FT Support Question
Find answers below for this question about Troy-Bilt Colt FT.Need a Troy-Bilt Colt FT manual? We have 1 online manual for this item!
Question posted by mackirwin on March 16th, 2016
Tiller Will Not Stay Running
runs by dripping gas in carburetor but will not run continuously
Current Answers
Related Troy-Bilt Colt FT Manual Pages
Operation Manual - Page 1
... MAY RESULT IN PERSONAL INJURY. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Front Tine Tiller - 340 Series
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
Operation Manual - Page 2
...
Service 15 Troubleshooting 16 Replacement Parts 17 Warranty Back Cover
Record Product Information
Before setting up , operate and maintain your machine, for purchasing a Troy-Bilt Garden Tiller. If you have difficulty assembling this manual frequently to familiarize yourself with regards to Troy-Bilt LLC • P.O. Box 361131 • Cleveland, OH • 44136...
Operation Manual - Page 3
...capable of California to cause cancer and reproductive harm. Be familiar with the engine running , except where specifically recommended in handling gasoline.
Preparation
1. Wear sturdy, rough-...chemicals known to State of amputating fingers, hands, toes and feet.
This machine is running .
5. Safe Handling of all stones, sticks, wire, and other reproductive harm. This...
Operation Manual - Page 4
... the engine is in the ground and propel the tiller forward. Follow this manual for any damage. When practical, remove gas-powered equipment from the machine while it off the ...e. g. j. Stop the machine if anyone enters the area.
5. Stay alert for damage. Wait until fueling is spilled, wipe it is running . If situations occur which are not covered in a poorly ventilated ...
Operation Manual - Page 5
..., injuries or death. Box 361131 Cleveland, Ohio 44136-0019. Important Safe Operation Practices
5 At the end of the California Public Resources Code).
A spark arrestor for gas, oil, etc. Section 2 - Other states may include the following emission control systems: Engine Modification (EM), Oxidizing Catalyst (OC), Secondary Air Injection (SAI) and Three Way...
Operation Manual - Page 6
... instructions in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. SAVE THESE INSTRUCTIONS!
6
Section 2 - Safety Symbols
This page depicts and describes safety symbols... and on the machine before attempting to assemble and operate.
CARBON MONOXIDE Never run an engine indoors or in the manual(s) before attempting to assemble and operate
...
Operation Manual - Page 7
... into the cable guide bracket (note the notch in the
cable guide bracket goes over the flange on the left side of Carton
• One Tiller • One Operator's Manual
• One Handlebar Assembly • One Engine Operator's Manual
• One Depth Gage Assembly
Assembly
2.
Identify the forward clutch cable. Step...
Operation Manual - Page 8
.... Return to secure the handle in the desired position. The depth stake can be adjusted to meet your tiller. 8. For setup purposes it is suggested that the machine sits level. Depth Gauge
1. See Figure 1-5. ...above or level with the clip removed earlier.
Adjustments
Wheels
The tiller is made by removing the clevis pin from the depth stake assembly. See Figure 1-7.
See Figure 1-4....
Operation Manual - Page 9
...and the vapors are explosive. Assembly & Set-Up
9 Clutch Cable Adjustment
Before operating the tiller the adjustment of the forward clutch cables must be checked.
1. The tines should not turn...the separate Engine Operator's Manual packed with your tiller. Check again for correct tension on the cable. Gasoline is hot or running. Section 3 - Set-Up
Gas & Oil Fill-Up
Service the Engine with ...
Operation Manual - Page 10
...
Engine Controls
See the separate Engine Operator's Manual for seeding. Squeezing the lever against the handle engages the tine drive.
Tiller Tines
Tilling tines are used to cultivate, furrow and prepare your garden for information and functions of the handle.
Loosen the knob to stop the tines. Tighten hardware when complete.
10...
Operation Manual - Page 11
... refer to depth stake - Figure 1-1
Figure 1-3 11 See Figure 1-3.
Be sure no one is running or being started.
1. Remove the clevis pin and hairpin clip to tines) for engine starting and ...and follow all the instructions and warnings posted on the machine and in front of the tiller while the engine is standing in this manual before operating. Setting the Depth
Yoke Forward
Place...
Operation Manual - Page 12
...Tiller
Your tiller is the preparation of lawn area for mixing compost in with several inches of soil allows proper aeration of the plant root system and retards the growth of weeds.
12
Section 5- The tine width can be obtained by making separate passes across the length and width of the garden...;
Passes should be worked in your garden. The tiller will prepare a deep seed bed which...
Operation Manual - Page 13
... and apply a light coat of oil or silicone to clean your tiller. See Figure 1-1. Wheel Shafts
Remove the wheel assemblies and lubricate the axle shafts ... all the pivot points and linkages at factory. Maintenance & Adjustments
6
WARNING! Water can penetrate tight areas of the tiller and its chain case and cause serious damage to 26" by removing the clevis and cotter pins, sliding each use...
Operation Manual - Page 14
...1.75) and flange lock nut (3⁄8-16 ) that attach a single tine to prepare the tiller for storage.
1. Install each tilling season and after every 30 operating hours. When installing a single.... The use of pressure washers is not recommended for correct engine storage instructions.
4. Store tiller in the lubrication instructions.
2.
If necessary, use , the tines will result in a...
Operation Manual - Page 15
... Hex Washer Screws
Figure 1-3
5. To install the new belt, follow the instructions in Figure 1-2.
Your tiller has been engineered with an off-the-shelf belt. Figure 1-1
3. Idler Pulley Keeper
Idler Pulley Bolt
Figure...reverse order and refer to Figure 1-4. Take note of the notch on the bottom of the tiller by removing the two hex washer screws and the lock nut and washer. See Figure 1-3....
Operation Manual - Page 16
Improper rotation.
1. Dislodge foreign object 2. Take tiller to authorized service dealer 4. Replace clevis pin 2. Control cable not adjusted properly 3. Replace tine clevis pin(s) 3. Adjust control cable 3. Tine clevis pin(s) missing 3. Adjust control ...
Operation Manual - Page 18
...all gears, shafts and housings) against defects in material and workmanship for the life of the tiller, to misuse, abuse, commercial use, neglect, accident, improper maintenance, alteration, vandalism, theft...or consequential loss or damage including, without limitation, expenses incurred for substitute or replacement lawn care services or for rental expenses to the person for loss, damage, or ...
Similar Questions
Colt Ft Will Fire But Not Stay Running
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
(Posted by Anonymous-150145 9 years ago)
Proline Crt Want Stay Running
It cranks right up, although its harder to pull than it use to be but as soon as it meets any resist...
It cranks right up, although its harder to pull than it use to be but as soon as it meets any resist...
(Posted by janmills64 9 years ago)
Colt Tiller Pulley Wheel Locked Cannot Pull To Start
(Posted by Anonymous-123613 10 years ago)
Wont Stay Running
my father in law uses my weed eater and it runs fine but as soon as i try to use it it stalls when i...
my father in law uses my weed eater and it runs fine but as soon as i try to use it it stalls when i...
(Posted by mnellammij 10 years ago)