Troy-Bilt Colt FT Support Question
Troy-Bilt Colt FT Support Question
Find answers below for this question about Troy-Bilt Colt FT.Need a Troy-Bilt Colt FT manual? We have 1 online manual for this item!
Current Answers
Related Troy-Bilt Colt FT Manual Pages
Operation Manual - Page 1
... In USA
TROY-BILT LLC, P.O. Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Front Tine Tiller - 340 Series
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE...
Operation Manual - Page 2
... injury or property damage. If you can seek help from the options below: ◊ Visit us directly.
Table of product specifications for purchasing a Troy-Bilt Garden Tiller. It was carefully engineered to ensure your complete satisfaction at all models. All information in this manual may cover a range of Contents
Safe Operation Practices...
Operation Manual - Page 3
... understand the instructions and safe operation practices in moving parts. Never attempt to make any type of power equipment, carelessness or error on the machine and in a safe place for...WARNING!
Never allow adults to assemble and operate. Safe Handling of yourself and others. Use only an approved gasoline container. Failure to cause cancer and birth defects or other foreign...
Operation Manual - Page 4
...and the name of grass, leaves, or other debris build-up oil or fuel spillage and remove any adjustments, or inspections.
13.... careful when tilling in the ground and propel the tiller forward. Thoroughly inspect the machine for fuel expansion. ...loading, unloading, transporting, and storage of a rate.
17. Use only attachments and accessories approved by attempting to till soil too...
Operation Manual - Page 5
...order by law (Section 4442 of the Average Useful Life have similar laws. Important Safe Operation Practices
5 Observe proper disposal laws and regulations for gas, oil, etc. Environmental Protection Agency (EPA), this ...California Public Resources Code). If the fuel tank has to do this product has an Average Useful Life of seven (7) years, or 130 hours of operation. 9. If a spark arrestor ...
Operation Manual - Page 6
... and describes safety symbols that may appear on the machine.
WARNING- Engine exhaust contains carbon monoxide, an odorless and deadly gas.
Your Responsibility-Restrict the use of this power machine to persons who read, understand and follow all instructions in the manual(s) before attempting to cool before refueling.
WARNING-
WARNING- Allow...
Operation Manual - Page 7
...• One 3⁄8" open-end wrench • Clean oil funnel • Motor oil.
Handle
1.
Figure 1-2 3. Step 1 in Figure 1-3.
5. Insert the handle into tiller frame as it will fall when the bolt is removed....Step 3 in the
cable guide bracket goes over the flange on the left side of tiller are determined from the right side of frame as shown. Refer to kink cables while...
Operation Manual - Page 8
... Figure 1-5.
Insert the carriage screw through the bracket on the Depth Stake refer to meet your tiller. 8. See Figure 1-4. 9. Depth Gauge
1. Depth Stake Assembly
Figure 1-6
Secure the pin with the ground surface. Adjustments
Wheels
The tiller is made by removing the clevis pin from the depth stake assembly. See Figure 1-7. See Figure...
Operation Manual - Page 9
...using the previous steps in this section.
7. With the forward engagement handle in the separate Engine Operator's Manual packed with your tiller. Set-Up
Gas & Oil Fill-Up
Service the Engine with gasoline and oil... several times. WARNING! See Figure 1-8.
Clutch Cable Adjustment
Before operating the tiller the adjustment of the forward clutch cables must be checked.
1. Disconnect and...
Operation Manual - Page 10
Tiller Tines
Tilling tines are used to cultivate, furrow and prepare your garden for information and functions of the handle. Tighten hardware when complete.
10 Squeezing the lever against ... of the engine controls. Controls & Features
4
Handle
Forward Tine Engagement Lever Handle Knob
Depth Stake
Tiller Tines
Engine Controls
See the separate Engine Operator's Manual for seeding.
Operation Manual - Page 11
Read, understand, and follow all the instructions and warnings posted on the machine and in front of the tiller while the engine is running or being started.
1. closest to raise or lower depth stake. for the tiller and controls the depth and speed at which the machine will operate.
Figure 1-2
Depth Stake
The...
Operation Manual - Page 12
...be done after the soil has been broken to a depth of lawn area for instructions on the handles will increase the working depth. For proper decaying action,... stake and the handle pressure required. The type of soil and working the length of the garden alternately. Using Your Tiller
Your tiller is obtained the first time over the garden two or three times.
An upward pressure ...
Operation Manual - Page 13
...wheel assemblies and lubricate the axle shafts at least once a season with light oil. Tines
Clean the underside of the tiller and re-securing the pins in the holes provided. The dirt washes off ...to 26" by removing the clevis and cotter pins, sliding each use a "pressure washer" to the Assembly & Set-Up section of oil or silicone to machine. Tine Shafts
Remove the tine assemblies and ...
Operation Manual - Page 14
...to Figure 1-2 for the following steps should be taken to prepare the tiller for cleaning your tiller. Store tiller in an unventilated area or metal storage shed, care should be taken ... use of pressure washers will result in the lubrication instructions.
2. Using a light oil or silicone, coat the equipment and especially any type of power equipment in a clean, dry area.
If necessary, use ...
Operation Manual - Page 15
... side of special
material (Kevlar Tensile) for longer life and better performance.
Using a 1⁄2" wrench, remove the hex screw securing the belt keeper to Figure 1-4. It
should...See Figure 1-2. Service
7
Belt Replacement
4. Figure 1-1
3. Remove the belt.
6. Your tiller has been engineered with an off-the-shelf belt. Disconnect and ground the spark plug wire against the engine.
...
Operation Manual - Page 16
...Replace clevis pin 2. Belt worn and/or stretched 1. Forward rotation should only be used on soil
that has already been tilled, not on virgin soil. 1. Adjust control...Replace belt
16 Dislodge foreign object 2. Adjust control cable 5. Improper rotation.
1. Take tiller to authorized service dealer 4. Replace tine clevis pin(s) 3. Belt worn and/or stretched
Remedy
...
Operation Manual - Page 18
...greater than the original purchaser or to the person for commercial use , neglect, accident, improper maintenance, alteration, vandalism, theft... in material and workmanship for the life of the tiller, to obtain warranty coverage. The engine or component parts..., without limitation, expenses incurred for substitute or replacement lawn care services or for terms and conditions. Troy-Bilt...
Similar Questions
How Do You Remove A Sparkplug On A Colt Troybilt Tiller?
(Posted by shawenator 1 year ago)
What Is The Spark Plug Gap Setting For The Troy Biltolt Ft?
what is the correct spark plug gap for the Troy Bolt colt FT?
what is the correct spark plug gap for the Troy Bolt colt FT?
(Posted by Anonymous-165415 5 years ago)
Colt Ft Will Fire But Not Stay Running
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
it is brand new only used 3 times, fresh gas cleaned carb, will start off starter fluid but immediat...
(Posted by Anonymous-150145 9 years ago)
Gas Shut Off Valve
Is there a gas shut off valve for the colt ft 208cc? If so, where is it located?
Is there a gas shut off valve for the colt ft 208cc? If so, where is it located?
(Posted by Amiablemike 9 years ago)