Toro 20333 Support Question
Toro 20333 Support Question
Find answers below for this question about Toro 20333 - BBC Personal Pace Walk Power Mower.Need a Toro 20333 manual? We have 2 online manuals for this item!
Question posted by conbil40 on August 8th, 2014
Brand New Toro Recycler 20333 Won't Run When Blades Are Engaged
I bought a Toro Recycler Personal Pace yesterday and after getting it all together and ready to use, It won't mow. It cranks great and idles great, but as soon as I engage the blade bar to start mowing it immediately dies. What am I doing wrong????
Current Answers
Related Toro 20333 Manual Pages
Operation Manual - Page 1
... and serial numbers in the USA
All Rights Reserved
Figure 2 1. 22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up Model No. 20333C-Serial No. 312000001 and...Manual is intended to use or operate the engine on the product. This rotary-blade, walk-behind lawn mower is supplied for information regarding the US Environmental
© 2011-The Toro® Company 8111...
Operation Manual - Page 2
...lawn mowers and the B71.1 specifications of the American National Standards Institute in place and working.
• Never leave a running .
• Be sure the area is used to vibrate abnormally, stop before starting....
Safety
This lawn mower meets or exceeds the CPSC blade safety requirements for walk-behind the handle...fall accident.
• Do not mow near or under the influence of the...
Operation Manual - Page 3
...with manufacturer's recommended parts, when necessary.
• Mower blades are often attracted to cool before filling.
• Remove gas-powered equipment from the truck or trailer and refuel it... of Gasoline
To avoid personal injury or property damage, use a nozzle lock-open flame, spark, or pilot light such as necessary.
3
Allow machine to prevent unintended starting .
• Never ...
Operation Manual - Page 5
... is damaged, contact an Authorized
Service Dealer.
5 Figure 3
Figure 4
2. Install and tighten the handle knobs that covers the engine.
1
Installing the Blade Control Bar
No Parts Required
Procedure
Install the blade control bar into the upper handle (Figure 3).
1. Setup
Important: Remove and discard the protective plastic sheet that you install the handle. Remove the...
Operation Manual - Page 6
...not shown) 13. 3
Filling the Engine with Oil
Product Overview
No Parts Required
Procedure
Your mower does not come with the dipstick. Ignition switch
9. Recoil start handle
7. Slowly pour oil into the oil fill tube until the oil level reaches the Full... thereafter.
Spark plug
14. Bag-on the dipstick (Figure 5). Install the dipstick securely. Blade control bar 3.
Operation Manual - Page 7
... (Figure 9). Wait 3 minutes after adding oil to the fuel all moving blade, causing serious injury.
• Stop the engine and wait for automotive use or daily 1. Do not overfill. (Max. Keep away from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in an approved fuel...
Operation Manual - Page 9
... back (Figure 15). You can also try reaching just under the personal pace handle to the metal handle and push the mower forward a couple of inches (centimeters) forward to the handle (Figure 16). Hold the blade control bar against the handle (Figure 17). Figure 15
Figure 13
2. Figure 16
Stopping the Engine
If the ignition...
Operation Manual - Page 10
... the control bar before recycling the clippings. Using the Grass Bag
Service Interval: Before each use the grass bag to perform an additional test to inflate, indicating that the blade brake clutch system is engaged and rotating. 4. Install the empty grass bag on the mower, remove it does not stop properly, stop .
10. Start the engine. 3. Engage the blade. Note...
Operation Manual - Page 11
...new Toro replacement bag. contacting the blade can result in the correct position. Rear deflector
Figure 19 3.
If the side discharge chute is sharp; Notches 2. Removing the Grass Bag
To remove the bag, reverse the steps above.
11 Lower the rear deflector. Bagging the Clippings
Use... and result in the recycling position, move it is in serious personal injury or death to Operating...
Operation Manual - Page 12
...'s direction and result in serious personal injury. Bag-on-demand lever (in the bagging position, move the lever to the recycling position (refer to Operating the Bag-on-Demand Lever). If the grass bag is on the mower and the bag-on-demand lever is sharp; WARNING
The blade is in bagging position)
•...
Operation Manual - Page 13
... examine the mower for the best lawn appearance. Replace the blade or have it is too long, the mower may plug ...mower strikes an object or starts to stall. then mow again at a slower pace while mowing.
- Walk at a lower setting for damage.
• For best performance, install a new blade before the cutting season begins.
• Replace the blade when necessary with a Toro replacement blade...
Operation Manual - Page 15
....
Gasoline is flammable, explosive and can cause personal injury.
Important: Before tipping the mower to change the oil or replace the blade, allow the fuel tank to open the air...Clean the air cooling system; Use a screw driver to run dry through normal usage. Recommended Maintenance Schedule(s)
Maintenance Service Interval
After the first 5 hours
Before each use a
Figure 24
15 Stop the...
Operation Manual - Page 16
...you install a new self-propel cable or if the self-propel drive is simplified for Maintenance. 2. Tip the mower onto its ...first 5 hours Yearly
Run the engine a few minutes before changing the oil to Preparing for the purpose of the used oil out through the... air filter (Figure 25). Pull down the cable jacket (toward the mower) until the oil level reaches the Full line on the dipstick (Figure...
Operation Manual - Page 17
...).
1. Remove the blade (Figure 31). 5. Blade nuts
Figure 30 2. Remove the blade driver and disk (Figure 31).
17 Tip the mower onto its side with the air filter up . 3. Stiffener
3. Install the new blade (Figure 30). 6.
Disconnect the spark plug wire from the spark plug. contacting the blade can result in serious personal injury. Install the blade nuts and...
Operation Manual - Page 18
...Start the engine and run it from under the mower housing.
7. Refer to cool before storing the mower in the area. Move the mower onto a flat paved surface.
3. Install the blade brake clutch shield that is running... Height.
2. For best results, clean the mower soon after you previously
removed. 10. Lower the mower to 37 N-m). Install the blade nuts and torque them to 15 to
27 ft...
Operation Manual - Page 19
...distribute oil throughout the cylinder to run until the engine stops from running out of any unused fuel properly. Recycle it according to local codes, or use it with a torque wrench to ...Service Dealer.
19 Dispose of fuel. 4. Start the engine again. 5. Fold the upper handle forward as directed by the engine manufacturer.
2. Removing the Mower from the spark plug. 7. Folding the ...
Operation Manual - Page 20
...Mulcher/Bagger
Walk Power Mowers
Conditions and Products Covered
The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly promise to follow this warranty.
contaminants in item #3 to use of the Toro Products covered by these warranties, including any reason you . Some states do not allow exclusions of repairs under "Lawn Mowers") or...
Parts Catalog - Page 1
Form No. 3371-848 Rev A
22in Recycler® Lawn Mower
Model No. 20333-Serial No. 312000001 and Up
Parts Catalog
Register at www.Toro.com. Original Instructions (EN)
Parts Catalog - Page 3
... Door Assembly 4 Rear Bag Assembly 5 Engine and Blade Assembly 6 Front Wheel and Height-of-Cut Assembly 7 Transmission and Rear Wheel Drive Assembly 8 Upper Handle Assembly 9 Upper Handle Component Assembly 10 Attachments and Accessories 11
© 2011-The Toro® Company
Contact us at www.Toro.com.
8111 Lyndale Avenue South Bloomington, MN 55420...
Parts Catalog - Page 4
... Demand
3371-848A
4
A2 Description
1 117-1084
1 Housing ASM
1:2 94-8072
1 Decal-Danger
1:3 115-4676
1 Decal-Recycler
1:4 112-8867
1 Decal-Port, Washout
2 114-7963-01 1 Baffle-Front
5 114-7961
1 Baffle-Rear
6 115-4677
1 Chute-Recycle
7 46-8091
9 Screw-HWH
8 112-6416
1 Bracket-Cover
9 99-8445
2 Screw-HWH, Taptite
10 99-5291
1 Rod...
Similar Questions
Brand New Toro Mower Wont Stay Running
(Posted by zabrigh 9 years ago)
Toro Personal Pace Mower Wont Stay Running Brand New
(Posted by bazm4 10 years ago)
How To Install Blade Break Linkage Toro Walk Behind Mower
(Posted by Hugadm1 10 years ago)
Troubleshooting New Toro 20333 Will Not Start
(Posted by raycaclhil 10 years ago)
Brand New Mower Mowed Front Yard, Then Would Not Start When I Went To Mow The Ba
(Posted by Bematwell 14 years ago)