Thermador PRG486JDG Support Question
Thermador PRG486JDG Support Question
Find answers below for this question about Thermador PRG486JDG.Need a Thermador PRG486JDG manual? We have 2 online manuals for this item!
Question posted by garzaericac1980 on February 9th, 2022
The Ignitor On My Thermador Prg486jdg Constantly Keeps On Clicking On Its Own
The ignitor on my thermador prg486jdg constantly keeps on clicking on its own
Current Answers
Related Thermador PRG486JDG Manual Pages
Installation Manual - Page 2
... 2 Step 1: Ventilation Requirements 3 Step 2: Cabinet Preparation 4 Step 3: Unpacking and Moving the Range 8 Step 4: Door Removal and Reinstallation 10 Step 5: Installing Anti-Tip Device 12 Step 6: Gas...9: Placing and Leveling the Range 23 Step 10: Burner Test and Adjustment 27 Installer Final Check List 29 To Clean and Protect Exterior Surfaces 29
This THERMADOR® appliance is made by...
Installation Manual - Page 4
...gas.
Installation, electrical connections and grounding must be avoided.
Refer to specific installations. A THERMADOR® Low Back or High Shelf must comply with a suitable overhead vent hood ("...more of the following standards:
• UL 858, Standard for the Safety of Household Electric Ranges
• UL 923, Standard for the Safety of Microwave Cooking Appliances
• UL 507...
Installation Manual - Page 5
...English 3
For island applications, it is recommended to www.thermador.com for longer duct runs.
Range Width
Range Top Configuration
Cubic Feet per Minute (min requirement)
Ventilation Options... rating).
Important:
Ventilation hoods and blowers are recommended for use with all THERMADOR® ranges. Tools Needed
(2) 1/2" wrenches
1/8" (3.17mm) drill bit
3/16" (4....
Installation Manual - Page 6
...• A 5" (127mm) minimum clearance is needed when the range is installed beside a combustible side wall. • Always keep appliance area clear from combustible materials, gasoline and other flame spread ratings...Cabinet Preparation
• The range is required between combustible material and the
back edge of the range above the cooking surface, a THERMADOR® Low Back or High...
Installation Manual - Page 10
... must be handled accordingly. Remove the outer carton and packing materials from scratches, until the range is recyclable. This will allow children to the receptacle or junction box, orient the receptacle ...create an estimated reduction in the weight as all THERMADOR® appliance packaging material is installed in "Chart A" and allow the range to the unit or the floor. To minimize ...
Installation Manual - Page 14
...DAMAGE:
• Contact a qualified installer or contractor to take this precaution can tip the range and be killed. --Verify the anti-tip device has been properly installed and engaged as ... properly reengaged when the range is not installed in electrical shock or other personal injury.
ATTENTION - THERMADOR Service Part No. RANGE TIPPING HAZARD:
• All ranges can tip and injury can...
Installation Manual - Page 20
...; Wall studs are usually installed with a 16" (406mm) or 24" (1372mm) space on the backsplash until after installation is complete.
• If range is to be installed with a Keep Hot Shelf
A hood can be installed first if the Backsplash is already installed, refer to the manufacture's instructions to disconnect gas and power...
Installation Manual - Page 23
... before sliding range into place. Backguard Installation
PRG366JG PRL366JG PRG364JDG PRL364JDG PRG486JDG PRL486JDG
AVAILABLE FOR THESE MODELS:
Pro Grand® 36" Gas Range 6 Burner Pro Grand® 36" Gas Range 6 Burner...or injury to persons, check to finger or hand while sliding the backguard down onto the range.
(1) High Shelf top panel (1) High Shelf front panel
CAUTION:
The High Shelf can...
Installation Manual - Page 24
... is less than a 12" (305mm) horizontal clearance between combustible surfaces ∆ and the back edge of the range above the cooking surface, a THERMADOR® Low Back or High Shelf must be attached before sliding the range into the back of the shelf. 4.
Mounts inside side panel flange
Mounts inside side panel flange
Backguard...
Installation Manual - Page 27
...back of both stacked and facing the back (Figure 21).
3. The water should feel a definitive click, letting you cannot see) for which the holes of the stainless steel 'sleeves'.
2. You should... roll into the grease tray.
If not, adjust the (2) screws under the back of the range's cooktop. Further adjustment should seize. Ensure that you know that the apparatus has been mounted to...
Installation Manual - Page 29
...not improve, call THERMADOR®.
Some ... The ignitor/spark module will produce a clicking sound....
Turn the gas shut-off when the knob is Properly Adjusted:
• There should be no air gap between the flame and
burner port.
See Figure 24 for the correct fuel. This is completely or mostly yellow, verify that the unit has been connected to the XLO® range...
Installation Manual - Page 30
... and angled baffle plate out to expose the bake burner in the small oven of the 48" range is the same. Air shutters of oven cavity. After a short delay, the burner will ignite ...Less Blue Flame More Carryover Less Lifting or Blowing
FIGURE 25: AIR SHUTTER ADJUSTMENT (IF NECESSARY)
Call THERMADOR® if: 1. English 28 If the flame burns completely or mostly yellow, it is necessary to...
Use and Care Manual - Page 5
... Begin 7 Using Your Range for the First Time 7 Range Description 10 Parts Identification - 48" Range 10 Parts Identification - 36" Range 11 Using The Cooktop ...Roasting Recommendations 28 Convection Baking 28 Convection Baking Recommendations 29 Keep Warm 30 Proof (48 31 Other Uses Of Bake 31... 41
Statement of Warranty 42
This THERMADOR® appliance is made by BSH Home Appliances Corporation 5551...
Use and Care Manual - Page 6
... freestanding units available in place. A child or adult can result in Figure 35 on Page 41 of anti-tip bracket. Check for all THERMADOR PROFESSIONAL® ranges.
Carefully tip range forward pulling from a neighbor's phone. English 1 This manual contains important Use and Care information for proper installation and use gasoline or other appliance...
Use and Care Manual - Page 7
A THERMADOR® Low Back or High Shelf must not exceed 14.0 inches water column (34.9...ordinances. WARNING:
To avoid possible burn or fire hazard, a backguard designed specifically for electrical requirements and grounding instructions. Make certain your range and gas type are certified for more than a 12" (305mm) horizontal clearance.
CAUTION:
The High Shelf can melt • ...
Use and Care Manual - Page 8
... product. TESTED IN ACCORDANCE WITH: • ANSI Z21.1 for Household Gas Appliances • UL858 for Household Electric Ranges • CAN/CSA-22.2 No. 61-M89 for Household Cooking
Ranges • CAN/CGA 1.1-M81 Domestic Gas Ranges
Check your new THERMADOR PROFESSIONAL® range has been designed to use extreme care when using this restaurant caliber...
Use and Care Manual - Page 11
... surrounding the door. do not touch the broiler element, the interior surfaces of the burners, keep the igniter ports clean. Be sure all cooktop controls are set to BROIL or BAKE modes,...center for this booklet. In case of burning as the alcohol vapors may catch fire in this range must disconnect the power supply before removing or replacing foods. Before self-cleaning the oven, remove...
Use and Care Manual - Page 14
...two following methods:
-
Remove oven racks. The THERMADOR PROFESSIONAL® range occasionally has a smell or smoke when first used... to cover the oven racks or to line the oven. Before baking or broiling, the oven and broiler should never be used . Please read "Care and Maintenance" on to check for the cooling process to keep...
Use and Care Manual - Page 37
...simultaneously.
Secondary Oven (48") Foods may be used in thickness.
Successful broiling requires constant exposure to activate while broiling.
Rack #3 - This type of glassware cannot withstand the...8226; Door is to be closed throughout the broil cycle. • Your THERMADOR PROFESSIONAL® range comes with a large two-piece broiler pan. Use convection broil if steaks ...
Use and Care Manual - Page 45
... turned back on again. The four ExtraLow® burners on the outer sides cannot be lit manually.
polarized.
Have a qualified electrician ground the
range properly. More than four clicks of igniter before lighting
Constant Sparking
• Improper fit of burner cap onto burner base.
• Align burner cap properly on burner base.
•...
Similar Questions
Thermador Dual Fuel Range Model:prd486jdgu
Need an oven light bulb for the Thermador Dual Fuel Range Model:PRD486JDGU. Where can I order/purcha...
Need an oven light bulb for the Thermador Dual Fuel Range Model:PRD486JDGU. Where can I order/purcha...
(Posted by rokhshiemalone 2 years ago)
Thermador Prd486jdgu/04 Gas Range Griddle
Our griddle will not heat. We have found the heating element part but when taking griddle apart to i...
Our griddle will not heat. We have found the heating element part but when taking griddle apart to i...
(Posted by Kathyhweathers 2 years ago)
Small Oven Not Working. The Ignitor Is Ok. What Is The Problem?
(Posted by euromehran 10 years ago)
I Am Looking For The Correct Part Number For A Prd486jdg Thermador Oven.
It's the oven ignitor, its next to the burner rail, for the right oven. I've looked and have had not...
It's the oven ignitor, its next to the burner rail, for the right oven. I've looked and have had not...
(Posted by critesheatingandcooling 11 years ago)
Additional Wall Prep Necessary If The Range Has A 9'backguard
I am getting ready to install a Thermador dual fuel PRD364GDHU range where there used to be an elect...
I am getting ready to install a Thermador dual fuel PRD364GDHU range where there used to be an elect...
(Posted by meemltl 11 years ago)