Thermador PRG486JDG Support Question
Thermador PRG486JDG Support Question
Find answers below for this question about Thermador PRG486JDG.Need a Thermador PRG486JDG manual? We have 2 online manuals for this item!
Question posted by critesheatingandcooling on December 28th, 2012
I Am Looking For The Correct Part Number For A Prd486jdg Thermador Oven.
It's the oven ignitor, its next to the burner rail, for the right oven. I've looked and have had not luck. Can you help me at all? Thanks
Current Answers
Related Thermador PRG486JDG Manual Pages
Installation Manual - Page 2
... 2 Step 1: Ventilation Requirements 3 Step 2: Cabinet Preparation 4 Step 3: Unpacking and Moving the Range 8 Step 4: Door Removal and Reinstallation 10 Step 5: Installing Anti-Tip Device 12 Step 6:... 9: Placing and Leveling the Range 23 Step 10: Burner Test and Adjustment 27 Installer Final Check List 29 To Clean and Protect Exterior Surfaces 29
This THERMADOR® appliance is made by...
Installation Manual - Page 4
...range. English 2 Important Installation Information
Gas Type Verification
Verify the type of appliance installation. After selecting the correct backguard, the range... .2 - A THERMADOR® Low Back...Backguard Kit Model Numbers" on safety ...Burners with the range. In the absence of the range, a
Flush Island Trim has been supplied with the range (refer to the pressure regulator. All ranges...
Installation Manual - Page 5
...
It is strongly recommended that are recommended for use with all THERMADOR® ranges. Important:
Ventilation hoods and blowers are not suitable for use with single wall ducting. Range Width
Range Top Configuration
Cubic Feet per Minute (min requirement)
Ventilation Options
4 burners with griddle 36"
6 burners
800 (cfm) 1100 (cfm)
36" or 42" Pro Wall Hood...
Installation Manual - Page 6
... is required between combustible material and the
back edge of the range above the cooking surface, a THERMADOR® Low Back or High Shelf must be sealed.
• When... 5 are required. Step 2: Cabinet Preparation
• The range is flush with the cabinet face. CAUTION:
Do not install the range such that the oven door is a free standing unit. A flush installation could ...
Installation Manual - Page 10
... damage the door hinges and cause the door to protect finish from scratches, until the range is recyclable.
The grates, griddle plate, burner caps, and oven racks must be handled accordingly. Do not remove the griddle element and tray assembly.
1.
Remove all THERMADOR® appliance packaging material is installed in "Chart A" and allow the...
Installation Manual - Page 13
...the door slowly to test the movement and the fit of the range when closed.
2.
Turn adjustment screw until they meet the hinge...REMOVAL
Photo D
English 11 If the door does not operate correctly, verify that the hinges are properly seated into the hinge ...The hinges will securely hook into the hinge slots (toward the oven) until door is properly installed, it should move smoothly and ...
Installation Manual - Page 24
...island installations, the supplied THERMADOR® Flush Island Trim may be attached before sliding the range into the back of ...Numbers
Model Low Back High Shelf Flush Island Trim
36" PA36JLBG PA36JHSG Included on Range
48" PA48JLBG PA48JHSG Included on the front side of the range.
5. Make sure the backguard's front face is inserted inside the guide channels on the range side panels right...
Installation Manual - Page 27
... the back (Figure 21).
3. After the range is properly leveled and the leg covers have been installed, replace the door trim and reinstall the Oven Door ("Step 4: Door Removal and Reinstallation" on...the unit (Figure 22).
5. Beneath the range, wrap the mated pieces around the leg.
4. The mating part has dimples (that you know that the burner caps are correctly seated on the back of the screws....
Installation Manual - Page 29
... the flame to cycle on to the XLO® range.
This is required. Test Rangetop Burners
Test Burner Ignition. The ignitor/spark module will produce a clicking sound.
Turn burner on and off valve to the open position. If any loose components, such as "carry over ," call THERMADOR®.
FIGURE 24: FLAME CHARACTERISTICS
When Flame is Properly...
Installation Manual - Page 30
... and reattach to bottom of the 48" range is not recommended). More Open: Less Yellow Flame
Screw Air Shutter
More Closed: Less Blue Flame More Carryover Less Lifting or Blowing
FIGURE 25: AIR SHUTTER ADJUSTMENT (IF NECESSARY)
Call THERMADOR® if: 1. Allow burners to cool before
the oven heats to the desired temperature. 3.
It...
Installation Manual - Page 31
...which it is located on the right side of steel may be ...range between the oven cavity and side panel).
Door opens and closes properly.
Burner grates correctly positioned, level, and do not rock.
Flame characteristics checked on all burners, and air shutter(s) on oven bake burner(s) properly adjusted (if necessary).
INSTALLER: Write the model number and serial number...
Use and Care Manual - Page 5
... You Begin 7 Using Your Range for the First Time 7 Range Description 10 Parts Identification - 48" Range 10 Parts Identification - 36" Range 11 Using The Cooktop 12 Cookware Recommendations 17 Specialty Cookware 18 Surface Burner Cooking Recommendations ....... 19 Electric Griddle (some models 21 Griddle Cooking Recommendations 22 Using the Oven 23 Oven Controls 23 Kitchen Timer 23...
Use and Care Manual - Page 6
...all THERMADOR PROFESSIONAL® ranges.
When using your gas supplier
from the back to children and adults. A child or adult can result in a number of each range....Range should not move more than 1 inch (2.5cm). All models feature a gas cooking surface with a professional size, electric convection, self-cleaning oven with broil capability. Failure to each range. The model number...
Use and Care Manual - Page 8
... gas to children above or at least 5 minutes before lighting the burner manually. DO NOT attempt to dissipate.
When properly cared for, your local building codes for Household Cooking
Ranges • CAN/CGA 1.1-M81 Domestic Gas Ranges
Check your new THERMADOR PROFESSIONAL® range has been designed to ensure that they are in safe practices...
Use and Care Manual - Page 13
... the front of the rail guides. When placing food on Page 41).
Rack position 3 is located on the right side of the range between the oven cavity and side panel (see Figure 35 on a rack, pull the rack out to the indicated address.
3. Please, recycle the packaging material as all THERMADOR® packaging is cooling...
Use and Care Manual - Page 14
... the rack from the kitchen area.
6. Ensure that the burner caps are correctly seated on the burner bases of manufacturer. See "Flame Description" on to the odors created during any new oven regardless of the range's cooktop (see "Self-Cleaning the Oven(s)" on page 34 before cleaning the oven racks.
- Lift up the front of the two...
Use and Care Manual - Page 17
... XLO
XLO Left Front
Center Front
XLO XHI
Right Front
Figure 10: Cooktop Symbols
Operation of the Burners
• Press in on the control panel, directly in the OFF position.
Control Knobs
Typically, a pair of control knobs is in front of the pair of 48" range models.
English 12
It is off when...
Use and Care Manual - Page 37
... during broiling. • Steaks should be closed throughout the broil cycle. • Your THERMADOR PROFESSIONAL® range comes with a large two-piece broiler pan. Use convection broil if steaks are over 11...Selector Knob to BROIL setting.
• The temperature indicator will move to BROIL after the oven reaches 425°F/ 218°C, while heating up to turn very thin foods (ham slices,...
Use and Care Manual - Page 44
.... Support the glass lens cover with a recommended light bulb designed for your range's model number and serial number. Press down to handle halogen light bulbs. Do-It-Yourself Maintenance
Oven Light Bulb Replacement
CAUTION:
Before replacing the light bulb, be certain the Oven Light Switch is in the off circuit breaker. 2. Let bulb and cover...
Use and Care Manual - Page 48
...THERMADOR®, OR OTHERWISE. Register your product related information. You may register your product online at 1-800-735-4328.
We reserve the right... Product; Products on which the serial numbers have any liability or responsibility whatsoever for...without limitation, any alterations including without notification. correction of installation problems (you how to surrounding ...
Similar Questions
Need Oven Rack For Prd4866jdgu103 Thermador
Need oven rack for prd486jdgu/03. Thermado
Need oven rack for prd486jdgu/03. Thermado
(Posted by thetimsphs 1 year ago)
Hi,the Two Center Burns Work, The Grill Works. Ovens And Other Burners Do Not.
(Posted by xtreemrr 1 year ago)
The Ignitor On My Thermador Prg486jdg Constantly Keeps On Clicking On Its Own
The ignitor on my thermador prg486jdg constantly keeps on clicking on its own
The ignitor on my thermador prg486jdg constantly keeps on clicking on its own
(Posted by garzaericac1980 2 years ago)
My Two Left Burners Are Not Working.
The ignition starter is clicking but no gas is coming out of the gas valves. I had mice in the stove...
The ignition starter is clicking but no gas is coming out of the gas valves. I had mice in the stove...
(Posted by scaref 6 years ago)
Small Oven Not Working. The Ignitor Is Ok. What Is The Problem?
(Posted by euromehran 10 years ago)