Home » Pyle » Marine Electronics » Pyle PLCD14MRKT

Pyle PLCD14MRKT Support Question

Find answers below for this question about Pyle PLCD14MRKT.
Need a Pyle PLCD14MRKT manual? We have 1 online manual for this item!

Pyle Overview Questions Manuals Reviews Videos Research

Question posted by jimmel25 on May 19th, 2016

Blue Power Antenna Wire/amplifier

What do I connect the blue power antenna wire/amplifier connect to in waterproof box?

I Know the Answer!

I have the same question
Request More Information

Current Answers

There are currently no answers that have been posted for this question.
Be the first to post an answer!

Remember that you can earn up to 1,100 points for every answer you submit. The better the quality of your answer, the better chance it has to be accepted.

Related Pyle PLCD14MRKT Manual Pages

PLCD14MRKT Manual 1 - Page 1

PLCD13MR OWNER'S MANUAL Mobile Audio System • MP3/CD Player • PLL Synthesizer Stereo Radio • Compact Disc Player • Automatic Memory Storing • Full Detachable Panel • Preset Equalization • Electronic Shockproof (ESP) Function • Auxiliary Input Function • Remote Control www.pyleaudio.com

PLCD14MRKT Manual 1 - Page 2

... out screw before installation.........3 DIN Front-Mount (Method A 3 Installing the unit 3 Removing the unit 4 DIN Rear-Mount (Method B 5 Using the detachable front panel ......6 Wiring Connection 7 Operation 8 Location of keys 8 Switching on/off the unit 9 Faceplate release 9 Sound adjustment 9 Loudness 9 DISPLAY 9 Mute 9 Equalization 9 Display (8 9 Auxiliary input 9 Remote sensor...

PLCD14MRKT Manual 1 - Page 3

... location where the unit will go (with the unit to install the unit. 1. Disconnect the wire harness and the antenna. 3. Then slide the sleeve off , and then disconnect the cable from the vehicle battery's ...panel"). 4. The two supplied keys release tabs inside the unit's sleeve so you test all connected up properly and the unit and the system work properly. • Use only the parts ...

PLCD14MRKT Manual 1 - Page 4

... (if attached). 3. Remove the metal strap attached the back of the unit. Spring Washer Hex Nut R Key Metal Strap Mounting Bolt Plain Washer 6. Reconnect the wire harness and the antenna and be careful not to fit your vehicle's mounting area. If necessary, bend the metal strap to pinch any...

PLCD14MRKT Manual 1 - Page 7

WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR IGNITION RED SWITCH (ACC+) MEMORY BACK-UP (B+) GROUND (B-) YELLOW BLACK FUSE FUSE POWER ANTENNA FRONT Lch SPEAKER REAR Lch SPEAKER BLUE WHITE WHITE/BLACK GREEN GREEN/BLACK REAR RCA CABLE (GREY) Rch RED Lch WHITE GREY GREY/BLACK VIOLET VIOLET/BLACK FRONT Lch SPEAKER REAR Rch SPEAKER 7

PLCD14MRKT Manual 1 - Page 9

... to be connected to clean DISPLAY the socket on the front panel. swab soaked in the following reasons: - Press the function - If the unit has the electronic shockproof e.g. BEEP...display. The adjustment mode will change minutes. (except button (7) and button (4)). all wiring is pressed long (several seconds to enter into the selection for the following order: ...

PLCD14MRKT Manual 1 - Page 13

... Preset Buttons (A~R, 1~6 For MP3/WMA Operation) 12. DSP (0) Display Button (_,-,+,0 For MP3/WMA Operation) 3. VOL Volume Down Button (Character Select (A,B~8,9,0) For MP3/WMA Operation) 6. PWR Power ON/OFF Button 2. VOL Volume Up Button (Character Select (A, B~8,9,0) For MP3/WMA Operation) 5. BND (LOU/ENT) Band Select Button (When pressed shortly) Loudness Button (When...

PLCD14MRKT Manual 1 - Page 15

Bass (at 10 KHz) Maximum Output Power Current Drain : DC 12 Volts, Negative Ground : 178 (W) x 160 (D) x 50 (H) : ± 10 dB : ± 10 dB : 4 x 25 Watts : 5 Ampere (max.) CD PLAYER Signal ...87.5 to 107.9 MHz : 10.7 MHz : 4 μV : > 25 dB AM : 530 to 1710 KHz : 450 KHz : 36 dBu 15 Treble (at 100 Hz) - SPECIFICATION GENERAL Power Supply Requirements Chassis Dimensions Tone Controls -

PLCD14MRKT Manual 1 - Page 16

... skips. is not operating properly Front panel is blown. The antenna cable is not moving, switch the ignition key to the car accessory circuits, but the engine is not connected. If the power supply is connected to "ACC". Condensation. Volume is not properly connected. Wiring is in the player, loaded or ejected. the label facing upward...