Pyle PLMR87WB Support and Manuals
Get Help and Manuals for this Pyle item
View All Support Options Below
Free Pyle PLMR87WB manuals!
Problems with Pyle PLMR87WB?
Ask a Question
Free Pyle PLMR87WB manuals!
Problems with Pyle PLMR87WB?
Ask a Question
Most Recent Pyle PLMR87WB Questions
What Is The Power Antenna /amplifier Turn On Lead Connected To?
(Posted by martens6259 8 years ago)
Popular Pyle PLMR87WB Manual Pages
PLMR87WB Manual 1 - Page 1
CH6
6DIR+
AS/PS BAND DSP/0
MUTE CH7/EQ
www.pyleaudio.com
1
CH1
1
CH2
2INT
CH3
3RPT
CH4
4RDM
CH5
5DIR-
PLMR87WB
OWNER'S MANUAL
Mobile Audio System
7/ MOD
8/
9/ AUX IN RESET
VOL + SEL VOL -
PLMR87WB Manual 1 - Page 2
... 3 Take out screw before installation...........3 DIN Front-Mount (Method A 3
Installing the unit 3 Removing the unit 4 DIN Rear-Mount (Method B 4 Wiring Connection 6 Operation... station 8
Automatic memory storing& program scanning 8
Station storing 8 USB play operation 8 Supported MP3/WMA decoding modes 9 SD/MMC operation 9 Remote Control 10 Specification 11
Trouble shooting 12
2
PLMR87WB Manual 1 - Page 3
... and the unit and the system work properly. Use only the parts included with the unit to ensure proper installation. Disconnect the wire harness and the antenna. 3. Lift the top of the... back of the unit.
Avoid installing the unit where it would be subject to remove it. 4. The use of unauthorized parts can be installed in the driver's way and cannot injure the passenger if ...
PLMR87WB Manual 1 - Page 4
...If necessary, bend the metal strap to a solid metal part of the unit to fasten the unit to secure the ... mounting bolt on both of the unit in place. Then replace the outer trim ring. Remove the metal strap attached the ... instructions. DIN REAR-MOUNT (Method B) If your vehicle is turned off, then
disconnect the cable from the vehicle battery's negative (-) terminal. 2.
INSTALLATION
...
PLMR87WB Manual 1 - Page 5
... the unit to loose the hook's
screws on each side. Note: the outer trim ring, sleeve and the metal strap are not used for method B installation.
5 Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws (5x5mm) on the front left and...
PLMR87WB Manual 1 - Page 7
... INPUT The unit can connect an USB driver through the AUX IN jack (21).... an USB interface (11). All the function buttons do not operate.
- Error symbol on the display (5).
SOUND ADJUSTMENT Press SEL button (3) shortly to change...; BAL → FAD → EQ → VOL
By pressing the vol+/- Initial installation of the unit, there is to be connected to current state after 5 seconds. CH1...
PLMR87WB Manual 1 - Page 8
... selected. If in other mode, you connect an USB driver through this interface . EQUALIZATION Press EQ button (10) ...until "MANUAL" appears on equalization function and to turn on the display, the manual tuning... the radio mode appears in the USB driver and start to scan preset station which ...SCANNING -
When you can connect an USB driver through the interface, the unit will change ...
PLMR87WB Manual 1 - Page 11
SPECIFICATION
GENERAL
Power Supply Requirements
: DC 12 Volts, Negative Ground
Chassis Dimensions
: 178 (W) x 107 (D) x 50 (H)
Tone Controls
- Treble (at 100 Hz)
: ±10 dB
- Version Y
: 4x50 ...
PLMR87WB Manual 1 - Page 12
...
The fuse is not on.
Replace the fuse.
The radio does not Work.
The built-in minimum
Wiring is not moving, switch the ignition key to noise. TROUBLE SHOOTING
Before going through the checklist... are too weak.
If any of the problems persist after checklist has been made, consult your nearest service dealer. Select a station manually.
12 Insert the antenna cable firmly.
Pyle PLMR87WB Reviews
We have not received any reviews for Pyle yet.