Pioneer DEQ 9200 Support Question
Pioneer DEQ 9200 Support Question
Find answers below for this question about Pioneer DEQ 9200 - Equalizer / Crossover.Need a Pioneer DEQ 9200 manual? We have 1 online manual for this item!
Question posted by lindo1948 on January 15th, 2013
Pioneer Deq 9200
amigo quanto custa este aparelho pioneer deq 9200 e o frete para brasil estado de são paulo r. manuel nunes 164 vila ede mande pago aqui no local aguardo contato de vsa. parte
Current Answers
Related Pioneer DEQ 9200 Manual Pages
Owners Manual - Page 5
...PIONEER Service Station. For your nearest service center or 1-800-228-7221 for about 3 days, the settings of the position and equalizer... curves, etc.
Changing the Operation Mode
Switch the PRO/STD switch. I
Hide-away unit bottom panel Fig. 4
• When the setting of the PRO/STD switch is located on parts...16.)
5 Memory Backup
When the car battery is removed or power cord of...
Owners Manual - Page 6
... reproduced frequency ranges, level and phase of high, middle and low speaker units. • Auto-equalizing (P. 23) Measures the acoustic property in the car compartment automatically and correct the audio reproduce characteristics automatically based on the data. • Equalization (P. 29) Compensates for the acoustic property according to your preference. • Position selector (P. 32...
Owners Manual - Page 7
...and cause a very dangerous short. • Do not shorten any moving parts, such as near the heater outlet. Otherwise, auto-equalization cannot be obtained. If you do, the protection circuit may fail to... is employed in the STD mode, use the front outputs of this unit. Otherwise, auto-equalization cannot be carried out and the effects of the sound field control cannot be carried out.
...
Owners Manual - Page 14
...(Fig. 23)
• Do not touch the pin located above the mounting base contacts. This switches the sound alternately between stereo and monaural. Precautions When Handling the Front Panel
• Do not leave the front panel in poor electrical contact.
While holding... contacts, wipe them with the surface of buttons [9] depressed, switch the car ignition switch from the left and right).
Owners Manual - Page 15
... is performed, the obtained auto-equalizer curve is not input for more than 20 seconds, the display automatically switches to this unit. The display is restored when an audio signal is pressed, the operation display [15] changes in the sequence from A, B then C.
Basic Operations of the Unit
Parts Identification
Fig. 1 [4] Mode shift...
Owners Manual - Page 16
...of A, B, C then D. am on ma
3 15*
C: Time Alignment Mode
■■
0*
B: Equalizer Adjustment Mode
Example 1: Nuance Control Mode
"of a pen, etc. (Fig. 24)
Hide-away unit
Clear ...micro-processor. Press the Clear button [14] with the tip of
a
Example 2: 3-band Parametric Equalizer Ad.ustment Mode
„.. Each time button (4) is a misoperation. • When the display indicates...
Owners Manual - Page 21
Parts Identification
Fig. 1 [4] Mode shift button [5] Frequency up/down buttons [6] Level up/down .) • Each speaker ...the button depressed again for about 3
seconds. 3. "STEREO" or "MONO" will be adjusted. The muting can be muted separately. Press (41) or (►) side of buttons [5] to adjust the cutoff frequency (crossover frequency) of the muted speaker unit displayed in PRO...
Owners Manual - Page 23
... outputs, the speaker may be damaged. - If a high-range speaker unit is output from the speakers to measure the acoustic property in the car compartment. o. Note: • The equalizer curves displayed above
are only for reproduction of the speaker unit?
23
Before operate the autoequalization
To avoid traffic accident
• Never attempt...
Owners Manual - Page 24
... unit. - Other microphones may not be capable of performing auto-equalization or measuring the acoustic property in the car compartment.
• The auto-equalization cannot be created. In case auto-equalization is performed while there has already been an auto-equalizer curve, the previously created auto-equalizer curve will be cleared from the surroundings of the...
Owners Manual - Page 25
... air conditioner or heater of driver's seat securely by installing the microphone on the microphone installation position. Switch the car ignition switch to perform auto-equalization by pointing it off. Parts Identification
Fig. 1 [2] Auto-equalization button [5] Frequency up/down buttons PRO [6] Level up/down buttons PRO [7] Position selector button [9] Function buttons
(F1) DYNAMIC (F2...
Owners Manual - Page 26
..., check the error content by referring to the output sound.
15.Remove the microphone and belt from each speaker.
• To cancel the auto-equalizing in the car compartment, measurement tone sounds repeatedly and an error code (example: AEQ Err E 2) is installed. (Refer to quit autoequalization mode. For the operating procedure, refer...
Owners Manual - Page 27
... of each frequency band can be fine-adjusted. (The selected band blinks.)
4. Adjust other bands. The greater the value, the sharper the equalizer curve characteristics. Press (A) or (V) side of the equalizer curve). Q factor Set values: 1.2 or 2.6 dB/oct. Press (F4) of buttons [9] to adjust the level. (Numeric display [17] shows "-10 dB...
Owners Manual - Page 28
... codes is not connected.
Each press of the button alternates between ON and OFF. (When the auto-equalizer is too high.
Park the car in the supplied microphone securely into the jack.
The auto-equalizing function does not work properly if the speakers mentioned on the left are not connected.
Switching the Auto...
Owners Manual - Page 29
...Parts Identification
Fig. 1 [4] Mode shift button [5] Frequency up/down buttons [6] Nuance control up/down buttons
Level up/down buttons [8] User's curve memory buttons [9] Function buttons
(F1) ROCK (F2) POP (F3) JAZZ (F4) VOCAL (F5) SOFT (F6) FLAT [10] 3-band parametric equalizer...preset in the car compartment corrected by switching alternatively between FLAT and a set equalizer curve.
----a
3...
Owners Manual - Page 30
... as the setting value for than FLAT (F6) is recalled, and the 3-band parametric equalizer adjustment mode is recalled.
3. Pressing the (A) side increases the amount of compensation (increases...when a factory curve other than curve. Nuance Control
1. Recall a factory curve or user's curve (equalizer curve created and stored in this unit by yourself (next page)). (Refer to "Recalling a Factory ...
Owners Manual - Page 31
... side of this unit by the user can be stored as desired. (Refer to the 3-band parametric equalizer adjustment mode. Press (A) or (V) side of buttons [6] to 5 for more than 2 seconds. (... after completion of less than 2 seconds to select the band to be obtained.
7. Store the adjusted equalizer curve in Memory
1.
Repeat steps 3 to adjust the level. (Numeric display [17] shows "-10 ...
Owners Manual - Page 32
...selected user's curve lights up.) • User's curves cannot be recalled as follows. Parts Identification
Fig. 1 [4] Mode shift button [5] Fader control buttons im [6] Balance control ...number of people in the
auto-equalization mode (P. 25). Recalling a User's Curve
The equalizer curves stored under buttons [8] (user's curves) can be recalled in the car and allows to the position(s)...
Owners Manual - Page 34
...position in outdoor stadiums. Reflection from the walls and reverberation.
STUDIO/STUDIO (F1) Localizes the sound image to reproduce a dynamic sound field. STADIUM/STADIUM (F4) Reproduces .... Sound Field Programs Preset in the car compartment.
HALL/CONCERT (F3) Reproduces music performed in its rear part. Wide and deep sound can be enjoyed through reflection and reverberation....
Owners Manual - Page 36
...using the
remote controller unit only.
36 In the equalizer adjustment mode: Used to recall the sound filed program. B
O
LIM
•
Fig. 28
Parts Identification and Function
[23]
•
VOL CO
...4 SOFT -) FLAT -> ROCK.... Each time the button is pressed, the selected factory preset equalizer curve changes in the sequence of its original level. • This function is displayed in ...
Owners Manual - Page 37
...Hz - 160 Hz, 1/3 oct. Level
+6 dB - -10 dB
Q factor
1.2, 2.6
Auto-equalizer (PRO mode)
(4-band parametric)
Frequency
80 Hz - 20 kHz, 1/3 oct.
Slope: -6, ...(H) x 135 (D) mm [7-1/4 (W) x 1-1/8 (H) x 5-3/8 (D) in accordance with specification standards established by the Ad Hoc Committee of Car Stereo Manufacturers. Slope: -6, -12, -18 dB/oct. Slope: -12, -18, -24 dB/oct Level: +6 - -24 dB...
Similar Questions
Is Thi Deq P800 Processor Compatible With Avh-p4450bt
(Posted by mohitkhatana555 2 years ago)
Where Can I Buy A Pioneer Deq 9200 Now That They Are No Longer Being Made?
(Posted by lenandmarylou 10 years ago)
Where Can I Find A Manual To Operate A Pioneer Deq 9200?
I install one of those unit for a friend's car. Where were trying to find the full use of this unit?
I install one of those unit for a friend's car. Where were trying to find the full use of this unit?
(Posted by BUGORISK 12 years ago)
Need To Get Repair On My Deq-9200 At This Time Its At Geis Audio In Greenville O
(Posted by flyfly123 12 years ago)
Loss Of Sound In Car, Stereo Channel Not Playing
can anybody tell me if you have had a problem with pioneer 7600 digital car sound processor
can anybody tell me if you have had a problem with pioneer 7600 digital car sound processor
(Posted by georgestephens 13 years ago)