Pfaff hobbylock 794 Support Question
Pfaff hobbylock 794 Support Question
Find answers below for this question about Pfaff hobbylock 794.Need a Pfaff hobbylock 794 manual? We have 1 online manual for this item!
Question posted by Cpohling on November 9th, 2018
Unable To Turn Hand Wheel.
I am unable to turn the hand wheel.
Current Answers
Related Pfaff hobbylock 794 Manual Pages
Owner's Manual - Page 2
... down movement of
the light bulb is 15 watts.
D) The drive belt must be adjusted by anyone but an authorized Pfaff agent.
B) When leaving the machine, changing parts or accessories, the machine must never be disconnected from the power source. Notes on safety
A) Due to avoid injury and observe the...
Owner's Manual - Page 3
... sewing machine Accessory box Electrical connection Foot control Preparing for threading Threading, 4-thread double-overedge seam Threading right looper Threading left looper Threading the needles Inserting the lint box Sewing test Points to observe during sewing Securing the seam Checking and adjusting thread tension 3-thread overedge seam Thread chart Adjusting the stitch length on 794...
Owner's Manual - Page 5
Controls of the sewing machine
1 Foot pressure regulating dial 2 Thread guide 3 Carrying handle 4 Left needle thread tension dial 5 Right needle thread tension dial 6 Right looper thread tension dial 7 Left looper thread tension dial
cover
11 Presser foot lifter lever 12 Hand wheel and feed regulator 13 Looper cover 14 Looper cover lever 15 Work support...
Owner's Manual - Page 6
... accessory box, slide it locks. Attaching the toot control: Insert the plug of the control into the grooves and push it until it into the machine plug socket. The accessories are illustrated on the foot control. Then connect the mains plug to the left and pull out the accessory box.
Accessory...
Owner's Manual - Page 7
... and OFF Power and sewing light are switched off.
Machine and sewing light are switched on and off : Press switch again.
when Pressing.... Electronic foot control
Maximum speed is regula as follows:
When press,g the foot Control gently the machine will run at low Speed. Machine and sewing light are switched on the foot control
Pos,ho,,
= Half Speed
Posillon 4 = Full speed ...
Owner's Manual - Page 12
... the eye of the needle. (The thread path is marked green.) Make sure to thread point 4 with special care; The diagram shows the correctly threaded machine.
insert the thread behind hook A of the thread guide plates fitted on both sides.
Threading the right needle: Thread the right needle in sequence 1 to...
Owner's Manual - Page 14
Raise presser foot lever, as shown in illustration. Hold thread ends with your left hand while turning hand wheel counter clockwise with your right hand. Make sure that threads have interlocked correctly. In doing so, the threads must be sewn. Sewing a test sample After threading, a test sample should be guided to the rear, under the presser foot...
Owner's Manual - Page 15
... pull or push the fabric. Sew the first stitches slowly. Finishing seam Sew approximately 5 cm beyond the end of the seam and use the thread cutter (1) behind the presser foot to sew. (Also after the machine has been re threaded). Use your hand for guiding only. Points to observe during sewing Place the fabric completely under...
Owner's Manual - Page 16
... knit fabrics, a crochet needle can be used to very heavy fabrics. Lower presser foot and sew over . Note:
When sewing thin fabrics, loosen the upper knife screw after sewing on heavy fabrics. (See illustration). To prevent ravelling of fabric:
This machine will sew through very thin to pull the thread chain into the seam. When...
Owner's Manual - Page 18
... loose (orange thread tension).
The right needle thread is too tight (orange thread tension) or the right looper thread too loose (red thread tension).
When turned in (+) direction, the tension is increased. Incorrect thread tension; The left needle thread is too tight (red thread tension) or the left looper thread is...
Owner's Manual - Page 20
..., lining materials. Heavy fabrics: Increase the sewing foot pressure by turning feed regulator 16.
The numbers indicate the stitch length in mm which normally is normally reset only for very thin or heavy fabrics. It is N (3 mm). Stitch Ienght setting on 794
The stitch length is the standard sewing foot pressure. A = setting mark. Thin...
Owner's Manual - Page 21
... lateral swivel table 15. Press stop of main feed dog (see arrow) fully downwards and hold it snaps into place. The stitch length is N = 3 mm. Turn handwheel 12 in mm which normally is set firmly as soon
as may be required (point of arrow).
/
The numbers indicate the stitch length
in...
Owner's Manual - Page 24
... width, always disengage the upper knife. Sew a test sample. Note: After adjusting the seam width, it clicks. The seam width can be necessary to 6.5 mm. To disengage upper knife, open looper cover.
Normal stitch width is 3.5 mm. Reset the upper knife to the far right. Turn knurled knob (2) clockwise until it may...
Owner's Manual - Page 25
Push the presser foot lever down and with the other hand gently push lever A up slightly (Fig. 1), and the presser foot will snap out. Place the foot under the presser foot holder so that crosspiece B of the rolled hem foot engages in groove C of the holder (Fig. 2). Changing the sewing feet Push lever A up until the foot snaps on.
23
Owner's Manual - Page 27
... be rolled. Thread a satin
the above three threading paths with Mez Alcazar Or use regular sewing thread,
Mez Alcazar woolly nylon
rayon thread or any other
for a hem with the letter ... a rolled hem is to roll the fabric between Hobbylock will quickly produce a professional
quick test to thumb and rolled hem.
The Pfaff Hobbylock 794 is suitable it rolls, the Pfaff
1. Set orange...
Owner's Manual - Page 28
... thread used with the allen wrench and pull the needle Out. Always turn the knob clockwise until it will cause thread breakage and skipped stitches. Turn the hand wheel counter-clockwise to raise the needle bar to the far right and turn the machine OFF when changing needles. An incorrectly inserted needle will go and tighten...
Owner's Manual - Page 29
Push upper knife to the right and turn to the front until it snaps into the groove of the lower knife holder with the surface of the needle
-
-
1
Tighten the lower knife clamp ...
Owner's Manual - Page 30
... holder. Screw it clicks.
Turn the hand wheel counterclockwise until the upper knife arm is carbide tipped and will not need to the far right and turn the knob clockwise until it into threaded hole (2) of the knife. Unscrew the knife retaining screw and remove upper knife. Unplug the machine. Push the upper knife holder...
Owner's Manual - Page 31
Changing the light bulb: Unplug the machine. Turn the bulb in direction (1) and remove it in direction (2).
Caution: Use a 15 watt bulb only.
Push bulb up and turn it . Use the brush provided with pins into slots (3). Cleaning thread tensions: Flip the tension cover down. Replace cover.
Close the tension cover.
29 Insert ...
Owner's Manual - Page 33
... weak
Insert new needle. Incorrect setting of simple adjustment errors. ewing problems and solutions hs machine is not fed correctly Needle breakage
Thread breakage
Skipped stitches
Incorrect stitch formation Puckered seams
Sewing foot pressure too weak
Turn sewing foot pressure screw clockwise to incorrect threading
Reduce thread tension (espe cially for light materials) pages...
Similar Questions
Je Cherche Une Pédale Avec Cordon D'alimentation
J'aimerais acheter une pédale avec cordon d'alimentation pour la surjeteuse hobbylook 794
J'aimerais acheter une pédale avec cordon d'alimentation pour la surjeteuse hobbylook 794
(Posted by lablanchetour 3 years ago)
I'm Trying To Make A Button Hole, The Sewing Machine Is Not Advancing The Fabric
(Posted by paulinegp22 3 years ago)
I Am Having Problems Turning The Regulating Wheel For The Sewing Foot Pressure.
I can not turn the Regulating sewing foot pressure wheel. It is on 1 now and I want to turn it to N ...
I can not turn the Regulating sewing foot pressure wheel. It is on 1 now and I want to turn it to N ...
(Posted by Gschoepf 7 years ago)
Pfaff 259 Sewing Machine Won't Run With Foot Petal
I have a pfaff 259. When I push on the foot petal the motor runs but the machine itself doesn't run....
I have a pfaff 259. When I push on the foot petal the motor runs but the machine itself doesn't run....
(Posted by Aemazing 8 years ago)
