Panasonic VL-GC002A-W Support Question
Panasonic VL-GC002A-W Support Question
Find answers below for this question about Panasonic VL-GC002A-W - Video Door Camera.Need a Panasonic VL-GC002A-W manual? We have 1 online manual for this item!
Question posted by fallsong3 on July 2nd, 2013
Camera Control
Are there any adjustment of camera:
1) Manually at time of installation such as pan or tilt ?
2) Remote control of camera from the site of the video screen ?
Current Answers
Related Panasonic VL-GC002A-W Manual Pages
Door Station White - Page 1
Please read this Installation and Operation Guide before using the unit and save for purchasing a Panasonic Door Station. VL-GC002A
Thank you for future reference. Video Intercom System
Door Station
Installation and Operation Guide
Model No.
Door Station White - Page 2
... Information
Important Information
FCC and Other Information 2 Important safety instructions 3 Additional safety information 4 For best performance 4
Introduction and Installation
Included items ...5 Location of controls 6 Before installation ...7 Installing the door station 8
Help
Cleaning ...12
General Information
Technical data about this product 13
FCC and Other Information
This device...
Door Station White - Page 3
..., or near a swimming pool, and the like.
6) Clean only with the manufacturer's instructions. Install in accordance with dry cloth. The safety and operating instructions should be adhered to.
4) Follow all....
All warnings on a bed, sofa, rug, or other similar surface.
8) Do not install near water. This product should never be followed.
5) Do not use liquid cleaners or aerosol...
Door Station White - Page 4
...smoke has stopped and contact an authorized service center. Confirm that they contain AC voltage. Install the unit where no one can cause electric shock when the unit is subsequently used ...Make sure the plug is allowed to connect a power cable to endure the mass. 15. Never install wiring during a lightning storm. 13. Use only the specified AC adaptor. 3. Opening or removing ...
Door Station White - Page 5
Item
Door station
Quantity 1
Notes ------ Mounting base Wood screws Button cover
1
------
2
4 mm x 20 mm (3/16″ x 13/16″)
1
------
5
No. Included items
Introduction and Installation
• The Mounting base comes preattached to the Door station.
Door Station White - Page 6
...
Microphone
Speaker
Call Button* • A visitor can be adjusted when installing the door station (page 9). Water drain holes (4 places) • These holes allow rainwater to the Call Button before using it. (The diagram shows the button cover installed.) (Page 11.)
6
Introduction and Installation
Location of controls
Front view
Camera • When a visitor presses the Call
Button, the...
Door Station White - Page 7
... conditioner or any other electrical device. Places where a high concentration of impact occurs. - Note: • Be sure to install the monitor station and sub monitor station more than 5 m
(16′5″) away from the door station.
7 Places where vibration or any
other kind of dust, hydrogen sulfide, phosphorus,
ammonia, sulfur, carbon, acid...
Door Station White - Page 8
..., there are holes to allow water to a wall using the attached wood screws.
(4 mm x 20 mm, 3/16″ x 13/16″). Introduction and Installation
Installing the door station 1 Loosen the mounting screw, and then remove the mounting base.
Important information: On the bottom surface of
995 mm ~ 1795 mm from the ground ...
Door Station White - Page 9
...
Left direction (maximum 16°)
Right direction (maximum 16°)
Upward direction (maximum 16°)
* Be sure to install the adjustment cover after adjusting the angle of the camera lens. Where most of the door station is not subject to the left. Where direct sunlight will reflect off it. - Wire type and distance • Wire...
Door Station White - Page 10
Tighten with screws
Wall Wire (Not included)
Door station (rear) Microphone
Connect to the terminal. Introduction and Installation
4 Attach the wire to terminals D11 and D12 (D21 and D22) of the monitor station.
Speaker Screwdriver
Mounting base Wall
Door station
5 Secure the door station to the mounting base.
• Tighten the mounting screws.
10
Door Station White - Page 11
... it, to stop it into the slot.
2 Remove the button
cover. Slot
Screwdriver
Screwdriver
Slots
* Press against the button cover gently with base. Introduction and Installation
6 Attach the button cover.
• Align the inside of the button cover base with the bottom of the call button, and then push the top...
Door Station White - Page 13
... illustrations in these instructions may vary slightly from the monitor station.
Note: • Design and specifications are subject to 90 % RH
(Relative Humidity) non condensing
Installation method: Wall mount (Wall mounting base included)
External material:
Flame retardant ABS resin (panel: acrylic resin)
*1 Supplied from the actual product.
13
Similar Questions
Search Camera Password
(Posted by jitendradangi117 2 years ago)
Reset Login Details
Hi, I have BL-C111A network camera. I had setup the username password for acessing but now i have...
Hi, I have BL-C111A network camera. I had setup the username password for acessing but now i have...
(Posted by vidhey 11 years ago)
Ty-cc20w Camera
I have TY-CC20W camera and wish to connect to Panasonic TLX L37DT30B television purchased late 2011....
I have TY-CC20W camera and wish to connect to Panasonic TLX L37DT30B television purchased late 2011....
(Posted by sjp 11 years ago)
No Connection Suddenly With Camera From Desktop
We just bought the brand new camera about 2 months ago and install in our new condo in Naples, Flori...
We just bought the brand new camera about 2 months ago and install in our new condo in Naples, Flori...
(Posted by mikechiu 12 years ago)
How Do I Use The Mediaelementcontrol In Silverlight To Tap Into A Direct Feed?
I purchased the Panasonic Wireless IP Camera 802.11g : BL-C121A WLS, and would like to know if it is...
I purchased the Panasonic Wireless IP Camera 802.11g : BL-C121A WLS, and would like to know if it is...
(Posted by ericsack 13 years ago)