KitchenAid KUDS40FVSS Support Question
KitchenAid KUDS40FVSS Support Question
Find answers below for this question about KitchenAid KUDS40FVSS - 24" Dishwasher.Need a KitchenAid KUDS40FVSS manual? We have 3 online manuals for this item!
Question posted by roger63693 on June 9th, 2015
Reboot Sequence For Kuds40fvss
I'm looking for the reboot sequence for my Kitchenaid KUDS40FVSS dishwasher. Power checks good. After resetting the breaker I select the start/resume, close the door and within 30 seconds the start/resume light starts flashing. Repeat start sequence with same results. The problem 1st occurred at the beginning of the cycle. All components seem to operate smoothly. No previous pump noises, leaks or malfunctions.Thank you!
Current Answers
Answer #1: Posted by BusterDoogen on June 9th, 2015 8:34 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,447
Member since:
October 30th, 2011 Points: 28,565,447
Go here for a possible solution.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related KitchenAid KUDS40FVSS Manual Pages
User Manual - Page 1
... This symbol alerts you to help you through any problems you need further assistance using your KitchenAid dishwasher, please contact us that can kill or hurt you what can find your convenience, we have... alert symbol. For your model and serial number on the label located near the door on your complete model and serial number ready. For additional information, you don't follow instructions...
User Manual - Page 2
... place.
■ Remove the door or lid to a grounded metal, permanent wiring system, or an equipment-grounding conductor must be run with all enclosure panels are in serious injury or cuts.
2 The dishwasher is properly grounded.
grounding conductor can result in doubt whether the dishwasher is equipped with the dishwasher; Check with a qualified electrician or...
User Manual - Page 3
...Steps
3 Select a ...door firmly closed within 3 seconds of the water - 1 Prepare and load dishwasher. MAIN WASH
WASH
Upper rack
Lower rack
■ Make sure nothing keeps spray arm(s) from the dishes. NOTE: Fill amounts shown are blocking the detergent dispenser.
■ Items should be clean. Remove labels from containers before starting a cycle.
■ Fresh automatic
A
dishwasher...
User Manual - Page 4
...30
soiled pots, pans, casseroles, repeatedly pause for good drying performance. Select Options (options vary by either using your dishwasher.
Use for hard-to "Refill" and lift off water. ■ Push door firmly closed within 3 seconds of food soil.
Select the wash cycle and options desired OR press START/RESUME to reduce excess moisture on top of door, push door firmly closed...
User Manual - Page 5
..., baked-on top of the cycle.
The dishwasher door can happen if the cycle is pressed. To run your dishes, the light flashes at least 4 seconds. If the incoming water is interrupted, the START/RESUME indicator flashes. This option with NSF/ANSI Standard 184 for licensed food establishments. OPTION SELECTIONS
OPTIONS
DISH LOAD TYPES
DESCRIPTIONS
USE WITH...
User Manual - Page 6
...Track
and out of the mid level rack. Close track stops.
5. Dishwasher Features
Your KitchenAid dishwasher may face the PROSCRUB® spray jets. Make...of the lower level rack.
SURE-HOLD® Light Item Clips The light item clips hold small items that is in the...wheels up and out of
the track.
3. NOTE: You must select the PROSCRUB® wash option to use this feature. NOTE:...
User Manual - Page 7
... track.
3.
If you have a drain air gap, check and clean it too often could be exposed to the outside of the rack into place.
2. Insert front rack rollers on both sides of the rack into the track slot and roll the rack back into dishwasher. Close track stops on each side of rack...
User Manual - Page 8
... for the dishwasher to resume the cycle by pressing START/ RESUME and closing the door within 3 seconds.
■ Cycles run too long
NOTES:
To use less water and reduce energy consumption you will encounter cycles that typically run , you will need to repeatedly pause several times during a cycle. Be sure the cycle has completed (green light is 15...
User Manual - Page 9
...lights
If the START/RESUME light is blinking, press START/RESUME and close the door within 3 seconds. Suds can cause dishes to clean.
9 To avoid rinse aid leaking from the dispenser, be sure the lid is securely attached and avoid overfilling.
■ Tub is discolored
NOTES:
■ High iron content in a dishwasher...soil to etching (see "Dishwasher Use.")
Select the proper cycle and options...
User Manual - Page 10
...dishwasher interior.
YOUR SOLE AND EXCLUSIVE REMEDY UNDER THIS LIMITED WARRANTY SHALL BE PRODUCT REPAIR AS PROVIDED HEREIN. SECOND THROUGH FIFTH YEAR LIMITED WARRANTY ON CERTAIN COMPONENT PARTS
In the second... PN W10205938
© 2008. KITCHENAID® DISHWASHER WARRANTY
LIMITED WARRANTY
For one year...the major appliance is inconsistent to KitchenAid within 30 days from defects in accordance ...
Installation Instructions - Page 2
... Installation 24 Check Operation 26 If Dishwasher Does Not Operate 26 Additional Tips 26
DISHWASHER SAFETY
Your safety and the safety of injury, and tell you and others are not followed.
WARNING
Tip Over Hazard Do not use dishwasher until latched.
• Observe all governing codes and ordinances.
• Install this manual and on open dishwasher door...
Installation Instructions - Page 3
..., Torx®† T15 screwdriver
*Must be made by a licensed electrical installer. Check existing electrical supply.
NOTE: Moisture barrier tape is a registered trademark of Acument Intellectual ... CSA Approved strain relief
hole
For Power Supply Cord: use UL Listed power supply cord kit marked for purchase in dishwasher
Other useful items you may need:
...starting installation.
Installation Instructions - Page 4
....
If dishwasher will be securely attached to water, electricity and drain.
• convenient access for a period of the dishwasher door and the...Check location where dishwasher will be installed must be left unused for loading and unloading dishes.
Shelter dishwasher and water lines leading to order.
The location where the dishwasher will be needed to level dishwasher...
Installation Instructions - Page 6
...8226; Use ¹⁄₂" minimum I.D. We recommend:
• a time-delay fuse or circuit breaker.
• a separate circuit. copper tubing with compression fitting or
flexible braided water supply line (Part ... tubing is recommended that meets the wiring requirements for use a new drain hose with dishwasher.
• Power supply cord must have:
• 120-volt, 60 Hz, AC-only, 15-...
Installation Instructions - Page 11
...end
1. If the drain hose
was cut ribbed section.)
4. Prepare Dishwasher
Tip Over Hazard Do not use dishwasher until completely installed. Use pliers to air gap with air gap
Waste... disposer - Make sure the area under a wood countertop)
Moisture barrier
1.
Attach drain hose to squeeze clamp open door...
Installation Instructions - Page 15
... for a ³⁄₄" (19.1 mm) thick wood panel. Dishwashers with control panel on the top
23¹⁄₂" (59.7 cm)
*30 76.7 cm)
(3.2 mm)
* This dimension is for reinstallation.
2 Custom...A customer-supplied full-front panel must be flush with control panel on KitchenAid custom handle selection, refer to avoid damage from both sides and all edges of the custom...
Installation Instructions - Page 19
... hole and replace the screw. 2 Move dishwasher close to
cabinet opening
4 Open and close door
Water line
Drain hose
Cable
Direct wire only
IMPORTANT: Double-check correct placement of the door panel. Grasp the sides of the dishwasher at the edges of utilities. If the door closes or falls open - Increase spring tension
When door is on the front of...
Installation Instructions - Page 23
... is equal on top of door does not contact screws, brackets, or countertop. The dishwasher must be secured to keep it does, adjust leveling legs.
5 Check inner spacing
Open door and check that top of dishwasher and secure dishwasher to countertop. Locate brackets on both sides. If spacing is opened.
4 Check door clearance
Open dishwasher door, remove lower dish rack, and...
Installation Instructions - Page 24
... Remove towel and replace
lower dishwasher rack
Bottom Sound Pad Installation (on some models)
Access panel
Lower panel
Insulation
Grounding clip
24 Complete Installation
1 Reinstall access...the dishwasher as far as shown. Visit www.kitchenaid.com/anchoring under FAQ tab. 6 Check side attachment
plastic button
If securing with a side attachment, check that sides of door do , dishwasher ...
Installation Instructions - Page 26
... the circuit breaker tripped or the house fuse blown?
• Is the door closed within 3 seconds, the Start/Resume light will run longer to calibrate to be used with rinse aid for good drying performance. If you have all parts have been installed and no steps
were skipped. If the dishwasher is working properly, disconnect power or unplug dishwasher and see...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Detergent remains in the dispenser
... not solve my problem The answer needs ...door to stick to use too much in the dishwasher... closed detergent in my dishwasher FAQs Knowledgebase search tips Dishwasher ...dishwasher. If the previous cycle did not complete, the detergent can change over a period of the dishwasher...before starting the cycle. Fresh automatic dishwasher detergent results in the dispenser after a cycle? Rate... -
Food soil left on the dishes in my dishwasher
... starting the dishwasher. Do you wash bottles and cans in the Manuals and Literature search below: Check to the "Dishwasher Use" section of 8.7%. Refer to see if the water pressure is low and a booster pump may need to increase the amount of the dishwasher and reduce washing performance. Water pressure should be at... -
Water supply hookup - Bottom freezer/French door refrigerators
... reduce the water pressure when used previously. Reverse-osmosis water filter. Tools needed : ¼" outer diameter flexible copper tubing Shutoff valve (requires a ¼" hole to depress and hold the water dispenser lever for 5 seconds, and then release it for leaks. Use copper tubing and check for 5 seconds. If you begin. To connect a refrigerator to see whether...
Similar Questions
On My Kitchenaid Washer (kuds40fvss), I Can Not
Close The Dispenser Door.
(Posted by elsmik 10 years ago)
Why Was The Kuds40fvss Model Discontinued
(Posted by dawn61212 10 years ago)
With Dishwasher Is Closed, How To Tell Mid-cycle
Great machine! With the operating buttons on the top of the closed door -how to tell it is in mid-cy...
Great machine! With the operating buttons on the top of the closed door -how to tell it is in mid-cy...
(Posted by pierce78 11 years ago)
Kitchenaid Kudk03itbl3 Starts To Fil And Stops In All Cycles
My KUDK03ITBL3 starts to fill and stops. Any ideas?
My KUDK03ITBL3 starts to fill and stops. Any ideas?
(Posted by lcone32 12 years ago)