KitchenAid KGSS907S Support Question
KitchenAid KGSS907S Support Question
Find answers below for this question about KitchenAid KGSS907S - 30" Slide-In Gas Range.Need a KitchenAid KGSS907S manual? We have 2 online manuals for this item!
Question posted by Jpartridge99555 on September 2nd, 2013
Kitchen Aid Model Kgrs807, How Do I Remove Probe?
I've got a message on my range that appeared when I was heating soup on one burner.
there was a beep sound and message read:
ENTER PROBE TIME OR REMOVE PROBE
I've never even used the probe.
The alarm that beeps is becoming very annoying! Ugh...
Thank you for your help! Julie
Current Answers
Related KitchenAid KGSS907S Manual Pages
Use and Care Guide - Page 5
... (12,500 Btu/h)
Glass Touch-Activated Electronic Oven Control Panel with Triple Tier® Burner (Models KGRS807 and KGSS907)
A
B
MED LOW HI
ON
F C
CONTROL LOCKED
CLEAN TIME PROBE TEMP
HR MIN COOK TIME
NIGHT LIGHT DELAY
MIN HR SEC MIN
START TIME
STOP TIME
C
D
E
F
G
A. Surface burner locator B. Left front control knob (14,000 Btu/h) E.
Oven display C. Right rear...
Use and Care Guide - Page 11
...1 (Models KGRS807 and KGSS907)
C
D
E
F
G
B
A
A. Oven settings B. Start (control lock) F. Options selection pad H. Cook time (length of
cooking time) O. If "Err" appears on /off )
Electronic Control Pads
When pressing any control pad function on the Electronic Oven Control, use , this display also shows a timed countdown and the stop working. Stop time N. When entering...
Use and Care Guide - Page 12
... 1 on convection models. To convert back to ON, but can be reset during cleaning).
Timer Completion Tones Three chimes sound when the timer reaches zero. Cooking Time Completion Tones Three beeps indicate the end of day. 3.
All Tones ON/OFF All tones are audible signals, indicating the following:
One beep s Function has been entered
Three beeps s Invalid...
Use and Care Guide - Page 15
...176;F and 190°F (54°C and 88°C).
2.
It should be set oven temperature will appear on convection models)
WARNING
Burn Hazard Use an oven mitt to determine doneness. s Use suggested baking time. B
A
Meat Thermometer
On models without a temperature probe, use temperature recommended in the recipe. Bakeware
The bakeware material affects cooking results. s Insert the...
Use and Care Guide - Page 16
...burner will turn off automatically and "End" will appear on each rack. To Bake or Roast: Before baking and roasting, position racks according to clean probe. Press BAKE once for baking, roasting or heating foods. When the set probe temperature is reached, the oven will shut off in the oven. After cooking, unplug the probe and remove...in 30 seconds to enter the desired temperature.
2. Use the...
Use and Care Guide - Page 20
... pads to enter time of boiling water in oven-safe container. Press the number pads to enter a temperature other than the one hour before or after 5 seconds.
3. "DELAY" and the stop time is ideal for warming breads and pastries. When the stop time will appear on some models, the start should not be used for more than 30 minutes...
Use and Care Guide - Page 21
...Use a damp cloth to slide. Use the following chart as a guide when selecting a different temperature other than "Low."
enter slots on your model...MED HI
Soft Rolls
LOW
RANGE CARE
Self-Cleaning Cycle
WARNING...Keep the kitchen well-ventilated during self-cleaning to remove soil. s Remove oven ...by pressing WARMING DRAWER ON additional times. s Remove all items from the cooktop ...
Use and Care Guide - Page 22
...It will also appear on the display. Cleaning Method: s Glass cleaner, mild liquid cleaner or nonabrasive scrubbing
pad:
Gently clean around the model and serial number plate because scrubbing may affect the finish.
These spills may remove numbers. CLEANING LEVEL
TOTAL CLEANING TIME (includes a 30 minute cool down time)
1 (Quick)
2 hours 30 minutes
2
3 hours
3 (Regular...
Use and Care Guide - Page 28
...GAS RANGE...installation not in materials or workmanship:
s Any gas burner
s Solid state touch control system parts
ITEMS KITCHENAID...States and Canada, this information on the model and serial number label located on the...or repair
house fuses or to use of the Use & Care Guide.
Pickup and ... when your appliance if it . The removal and reinstallation of your major appliance is designed...
Installation Instructions - Page 4
... where range is a registered trademark of combustion and ventilation air.
■ It is located inside the oven door on the model/serial rating plate.
See "Electrical Requirements" and "Gas Supply Requirements" sections. Location Requirements
IMPORTANT: Observe all parts are shown must be used to be provided, the risk can be reduced by reaching over heated...
Installation Instructions - Page 5
..."Gas Supply Requirements" section.
■ Contact a qualified floor covering installer to the standards listed above. Freestanding Range
Product Dimensions Slide-in Range
B A
A
F
C
D*
B*
C E
D
F**
E**
A. 5³⁄₄" (14.6 cm)
B. 30"...beyond 24" (61 cm) base cabinet. Mobile Home - Model/serial number plate (located on the right-hand side oven door trim)
F. 27¹⁄...
Installation Instructions - Page 6
...) min. clearance from both sides of rigid gas pipe. A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33 cm) upper cabinet depth C. 30" (76.2 cm) min.
clearance for model KGSK901 M. 22 58.3 cm) opening dimensions shown are for dimensional clearances above the cooktop surface. Freestanding Ranges
Slide-In Ranges
M N
M
O
A. 18" (45.7 cm) upper cabinet to countertop...
Installation Instructions - Page 8
... on the model/serial rating plate are for testing regulator must be used for connecting range to the gas supply line.
■ A ½" (1.3 cm) male pipe thread is greater than ½ psi (3.5 kPa). Gas supply line B. Burner Input Requirements
Input ratings shown on or shutting off gas to back.
Tile countertops may be level.
To range
Gas Pressure Regulator...
Installation Instructions - Page 9
... from the top of the countertop to the floor. Range side frame
3. Measure from the floor to the underside of range cooktop
B. Measure the distance of the range cooktop trim to the floor. C D
A B
A
A. Remove shipping materials, tape and film from inside oven.
2. Grate
C.
Slide-In Ranges:
1. Measure at locations marked A, B, C, D.
9 Measure at all 4 locations...
Installation Instructions - Page 11
... can result in death, explosion, or fire. Make Gas Connection
WARNING
A
A. Level Range
1. Use a wrench or pliers to adjust leveling legs up the back of the range, first
side to the existing gas line. Union E.
To Remove Warming Drawer: 1.
Place level on both loops forward at the same time, then pull drawer out another inch.
4. Failure to...
Installation Instructions - Page 13
... time a burner is turned to "HI,"
checking the flame at each setting.
13
Test the flame by turning the control from "LO" to "LITE." The cooktop "low" burner flame should light within 4 seconds. Do not remove ground prong.
Plug into a grounded 3 prong outlet. Electronic Ignition System
Initial lighting and gas flame adjustments Cooktop and oven burners use...
Installation Instructions - Page 17
...and keep with the correct LP gas orifice spud. A
A
A. Set internal gas orifice spud aside.
5. Use a 7 mm combination wrench to remove.
Igniter electrode B. Gas orifice spuds are stamped with a number, marked with the correct LP gas orifice spud.
3. Replace burner plate, head and cap.
8. Remove the plate on some models). Internal gas orifice spud
IMPORTANT: The...
Installation Instructions - Page 18
...conversion is not made . See "Adjust Oven Broil Burner Flame" in the "Electronic Ignition System" section. Orifice hood
2. Unplug range or disconnect power. See the "Remove Warming or Storage Drawer" section for instructions. A
A. See "Adjust Oven Bake Flame" in the "Electronic Ignition System" section.
Natural Gas Conversion
WARNING
A
A.
See the "Replace Oven Racks...
Installation Instructions - Page 19
... with a number on the external gas orifice spud. Remove burner cap. 2. Igniter electrode B.
Washer E. Using a T20 TORX® screwdriver, remove the burner base. 3.
Burner cap D. Internal gas orifice spud
19 Turn gas pressure regulator cap (marked "LP" on some models). See "To Convert TripleTier® Flame Burners" section.
A
B
C D
B
A. Remove the plate on the side...
Installation Instructions - Page 20
...the plate.
IMPORTANT: You may have yellow tips. A
B
C
To Convert Oven Bake Burner
1. Remove oven racks. 2. Use a 7 mm combination wrench to the following chart for future use and keep with the correct Natural gas orifice spud. Orifice hood
2.
A. Set external gas orifice spud aside.
6.
Use a ½" combination wrench to loosen the orifice hood away from the pin...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
General cleaning tips for my electric or gas range
... product label instructions. Use glass cleaner and a soft cloth or sponge. Apply glass cleaner to slide. To clean the oven roasting racks Remove racks or they will help them . To clean...gas range? To clean the storage drawer (on both loops forward at the same time; Slide the drawer closed. Locate the black loops on some models) Make sure the drawer is properly seated on some models... -
Tips for using the Self-Cleaning feature - Ranges and built-in ovens
...-oven models, only one oven can result. Model Number | Help me locate my model number Please enter at a time. Remove oven racks to 5 years Greater than one oven is extremely sensitive to move the oven door gasket. The door gasket is closed and well-ventilated room. Air must be improved Thank you Not Helpful Helpful Answers others found helpful General... -
Temperature probe - Architect Series II - gas and electric ranges
.... Press Bake, Convect Bake or Convect Roast. "Lo" will sound. If enabled, end-of-cycle tones will appear as the probe temperature until the probe is unplugged. After cooking, unplug the probe and remove food from the oven when removing food. gas and electric ranges How do I use : Before using, insert the probe into the center of the thickest portion of meat...
Similar Questions
Gas Range # Kgss907: Oven Fan Sometimes Cycles On & Off When Using Stove Top?
KitchenAid: Gas Range Model # KGSS907: Issue ~ Oven fan sometimes cycles on & off when using sto...
KitchenAid: Gas Range Model # KGSS907: Issue ~ Oven fan sometimes cycles on & off when using sto...
(Posted by sfmanley 9 years ago)
Kitchenaid Model Kems306bwh1 Builtin Oven Combination
I need replacement knobs for this model. The part numbers are: Right Knob 3149106 Left Knob 3149116 ...
I need replacement knobs for this model. The part numbers are: Right Knob 3149106 Left Knob 3149116 ...
(Posted by LStealey 10 years ago)
Kitchen Aid Gas Range Model Kgra806 I Need Control Panel
i need control panel for my gas range Kitchen Aid moder KGRA806
i need control panel for my gas range Kitchen Aid moder KGRA806
(Posted by black2stars 11 years ago)
Kitchen Aid Kgss907s
i need the installation cutout please in order t o have our forman install it properly -electrical c...
i need the installation cutout please in order t o have our forman install it properly -electrical c...
(Posted by officemanager72410 11 years ago)
I Am Having Trouble With My Kitchen Aid Oven.
i am having trouble with my Kitchen aid oven. but my stove has been working, and there were error co...
i am having trouble with my Kitchen aid oven. but my stove has been working, and there were error co...
(Posted by kachi428 13 years ago)