Kenmore 6972 Support Question
Kenmore 6972 Support Question
Find answers below for this question about Kenmore 6972 - 700 7.5 cu. Ft. Capacity Electric Dryer.Need a Kenmore 6972 manual? We have 2 online manuals for this item!
Question posted by wolfette on September 28th, 2013
What Wattage Is A 697267 Dryer???
The person who posted this question about this Kenmore product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Kenmore 6972 Manual Pages
User Instructions - Page 1
®
Dryer Secadora
Table of Contents / Jndice 2
W10034880
Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com
User Instructions - Page 2
...of injury, and tell you to the Warranty and the back page of Contents/indice
DRYER SAFETY 2 DRYER USE 5 DRYER CARE 6 TROUBLESHOOTING 8 PROTECTION AGREEMENTS 10 WARRANTY 10 SERVICE NUMBERS BACK COVER
SEGURIDAD DE ...this manual and on the model and serial number label, located at the top inside dryer door well. You can kill or hurt you contact Sears concerning your appliance. Always ...
User Instructions - Page 3
... the following:
[] Read all occupants. • Immediately call the fire department.
- IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer.
[] Do not place items exposed to cooking oils in your gas supplier, call your safety, the information in this or any...
User Instructions - Page 4
...cm)
metal or flexible metal vent. See the Installation Instructions for satisfactory drying results. If the dryer is not properly installed and vented, it was a paid for final product check. Good
Better
... use a metal foil vent. Failure to follow the Installation Instructions supplied with your dryer in a new location.
Use the straightest path possible when routing the vent. See...
User Instructions - Page 5
...before each load.
Fire Hazard
No washer can result in the cycle.
Do not pack the dryer. When you are unable to follow these instructions can completely remove oil. If desired, add... Selector Control should be dried on load type and load size.
To stop your dryer Open the dryer door or turn the Cycle Selector Control to the recommended setting for an Automatic Drying...
User Instructions - Page 6
... of combustion and ventilation air. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from items that would obstruct the flow of the dryer. L_t c>o_})®n
Clean the lint screen before each load. Push the lint screen firmly back into place. Roll lint off the screen with your...
User Instructions - Page 7
... line pipe and remove fittings attached
to secure dryer door.
1. Use masking tape to dryer pipe. 4. Unplug dryer or disconnect power. 2. Plug in dryer.
1.
See "Cleaning the Lint Screen." Electric Dryers
For power supply cord-connected dryers: 1. Use masking tape to secure dryer door. For direct-wired dryers: 1. Remove the cover.
3. Turn bulb counterclockwise. Replace the...
User Instructions - Page 8
...If the problem continues, call an electrician.
• For gas dryers, is mostly dry. Electric dryers use it a gas dryer? Unusual sounds
• Has the dryer had a period of non-use a plastic vent. The gas valve... suggested here and possibly avoid the cost of the drum for small objects. Electric dryers require 240 volt power supply. Fire Hazard Use a heavy metal vent. If...
User Instructions - Page 9
... area where your garments. ExplosionHazard
Keep flammable materials and vapors, such as gasoline, away from the area, rewash and dry the clothing.
• Is the electric dryer being dried.
• Is the load too large and heavy to dry quickly? See the Installation Instructions.
• Has an air dry cycle been selected...
User Instructions - Page 10
... not installed, operated or maintained according to all that can count on products requiring in-home repair, plus convenient repair scheduling
v' Power surge protection against electrical damage due to power fluctuations
v' Rental reimbursement if repair of your new purchase for other rights which vary from state to state. That's the kind...
Installation Instructions - Page 1
... symbol alerts you to reduce the chance of Contents/Jndice
DRYER SAFETY 1
INSTALLATION INSTRUCTIONS 2 Tools and Parts 2
Location Requirements 3 Electrical Requirements 4 Gas Supply Requirements 4 Venting Requirements 5 Plan Vent System 6 Install Vent System 8 Install Leveling Legs 8 Level Dryer 8 Make Gas Connection 9 Connect Vent 9 Complete Installation 9 SERVICE NUMBERS BACK...
Installation Instructions - Page 2
...
Adjustable wrench that opens to 1" (2.5 cm) or hex-head socket wrench (for adjusting dryer feet)
Level
• ¼"nut driver orsocket wrench
• Knife • Vent clamps...needed:
Check local codes and with gas supplier, check existing gas supply, electrical supply and venting, and read "Electrical Requirements," "Gas Supply Requirements" and "Venting Requirements" before purchasing parts....
Installation Instructions - Page 3
...." See "Venting Requirements."
• A grounded electrical outlet located within 2 ft (61 cm) of either side of an automatic cycle. The combined weight of a companion appliance should also be installed in death, explosion, or fire,
You will be considered. Drying times can be large enough to allow the dryer door to do not permit...
Installation Instructions - Page 4
... properly grounded. If this dryer be electrically grounded in accordance with appropriate conversion. • Your dryer must be provided. Gas Supply Line: • 1/2"IPS pipe is recommended.
• 3/8"approved tubing is recommended that is required.
It is acceptable for lengths under 20 ft (6.1 m) if local codes and gas supplier permit.
• Must include Ys...
Installation Instructions - Page 5
... installed above sea level at the B.T.U. Do not use duct tape. Use an elbow and a %" flare x %" NPT adapter fitting between dryer pipe and %" approved tubing.
• Lengths over 20 ft (6.1 m) should use larger pipe. Dryer Gas Pipe • The gas pipe that resist the action of connection. Gas Supply Pressure Testing • The...
Installation Instructions - Page 6
... and lint to woodwork, furniture, paint, wallpaper, carpets, etc=
[] Housecleaning problems and health problems.
Use a heavy metal vent.
Typical exhaust installations Typical installations vent the dryer from entering the home. Elbow C. Left or right side exhaust installation C. Select the type best for close -clearance installations are possible. A
B
A. Rigid metal vent is...
Installation Instructions - Page 7
...one 90 ° turn inside the dryer. IMPORTANT: Do not use . ...ft (16.5 m) 48 ft (14.6 m)
Flexible metal 31 ft (9.4 m) 23 ft (7 m)
2
Rigid metal
44 ft (13.4 m) 38 ft (11.6 m)
Flexible metal 27 ft (8.2 m) 19 ft (5.8 m)
3
Rigid metal
35 ft (10.7 m) 29 ft (8.8 m)
Flexible metal 25 ft (7.6 m) 17 ft (5.2 m)
4
Rigid metal
27 ft (8.2 m) 21 ft (6.4 m)
Flexible metal 23 ft (7 m)
15 ft...
Installation Instructions - Page 8
...For mobile home use
See"DeterminVeenLt engthA."void90°turnsU. devicetshatextendintotheinterioorfthevent o secure
vent.
Mobile home installations require a Mobile Home Installation Kit. If the dryer is not level, prop up or down and check again for ordering information. Screw the legs into its final position.
4. ConnecvtentoexhaushtoodV. RunventodryelrocationU.sethestraightepsat...
Installation Instructions - Page 9
... tighten, connect the gas supply to the supply line type, size and location.
! NOTE: For L.R gas connections, you have all of L.R gas. Shown following :
• Dryer is plugged into a grounded 3 prong outlet.
• Electrical supply is connected.
• House fuse is intact and tight, or circuit breaker has not tripped.
•...
Similar Questions
How To Open Front Panel
How do you open the front panel of Kenmore gas dryer 98042
How do you open the front panel of Kenmore gas dryer 98042
(Posted by 2rnzrus 1 year ago)
Dryer Vent Positioning
Where is the vent positioned on the back of an 8787 HE3 7.0Cu Ft Electric Dryer?
Where is the vent positioned on the back of an 8787 HE3 7.0Cu Ft Electric Dryer?
(Posted by monte20536 1 year ago)
Diasble Buzzer On Kenmore 8041
How do I go about diabling the buzzer on the Kenmore 8041 5.8 CU FT electric dryer?
How do I go about diabling the buzzer on the Kenmore 8041 5.8 CU FT electric dryer?
(Posted by dhuard22 9 years ago)
Kenmore 80272 Dryer Question
We are looking at this dryer, but I am concerned because I use "air dry" alot, so I am wondering......
We are looking at this dryer, but I am concerned because I use "air dry" alot, so I am wondering......
(Posted by jwhall15 12 years ago)