Jenn-Air JDS8850CDS Support Question
Jenn-Air JDS8850CDS Support Question
Find answers below for this question about Jenn-Air JDS8850CDS.Need a Jenn-Air JDS8850CDS manual? We have 5 online manuals for this item!
Question posted by GNULL on March 5th, 2014
Setting The Clock On The Jennair Jds8850cds Range
How Do You Reset The Clock On This Range
Current Answers
Answer #1: Posted by Rotiform662 on March 5th, 2014 12:02 PM
Rotiform662
Member since:
March 5th, 2014 Points: 10,110
Member since:
March 5th, 2014 Points: 10,110
To Set Clock:
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Select TIME using the left Quickset pad.
4. Enter the time using the number pads.
5. Press ENTER on the number pads.
6. Select AM or PM in 12-hour mode. (For 24-hour clock, see
following.)
7. To exit the Setup mode, press SETUP.
Entering the Day of the Week:
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Press the right Quickset pad to scroll until DAY is displayed.
4. Select DAY using the left Quickset pad.
5. Use right Quickset pad to scroll through the days.
6. Select the day desired using the left Quickset pad.
7. To exit the Setup mode, press SETUP.
To Set the Clock for a 12- or 24-Hour Format:
The clock can be set to display time in either a 12-hour or
24-hour format.
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Use right Quickset pad to scroll to 12/24 HOUR.
4. Press the left Quickset pad to select 12/24 HOUR.
5. Select 12 HR or 24 HR using the right or left Quickset pad.
6. To exit Setup mode, press SETUP.
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Select TIME using the left Quickset pad.
4. Enter the time using the number pads.
5. Press ENTER on the number pads.
6. Select AM or PM in 12-hour mode. (For 24-hour clock, see
following.)
7. To exit the Setup mode, press SETUP.
Entering the Day of the Week:
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Press the right Quickset pad to scroll until DAY is displayed.
4. Select DAY using the left Quickset pad.
5. Use right Quickset pad to scroll through the days.
6. Select the day desired using the left Quickset pad.
7. To exit the Setup mode, press SETUP.
To Set the Clock for a 12- or 24-Hour Format:
The clock can be set to display time in either a 12-hour or
24-hour format.
1. Press SETUP.
2. Select CLOCK using the left Quickset pad.
3. Use right Quickset pad to scroll to 12/24 HOUR.
4. Press the left Quickset pad to select 12/24 HOUR.
5. Select 12 HR or 24 HR using the right or left Quickset pad.
6. To exit Setup mode, press SETUP.
Related Jenn-Air JDS8850CDS Manual Pages
Dimension Guide - Page 1
...(76.2 cm) Slide-In Dual Fuel Range
PRODUCT MODEL NUMBERS
JDS8850CD GAS SUPPLY REQUIREMENTS
JDS8860BD
Type of Gas Natural gas: This range is design-certified by CSA International for ...a 24" (61.0 cm) base cabinet with the range connection. B C
ELECTRICAL REQUIREMENTS
To properly install your model.
Ref. q This range is factory set for use with leveling legs screwed all the way in...
Dimension Guide - Page 2
....7 cm)
I F
G
A. 13" (33.0 cm) upper cabinet depth
B. 30" (76.2 cm) min. Cabinet door or hinge should not extend into cutout.
from both sides of 2
Ref. A
B
C
Range may be flush mounted.
For minimum clearance to combustible construction at the
rear and on the sides below the cooktop.
For complete details, see NOTE...
Installation Instruction - Page 2
... tell you what can kill or hurt you use any other appliance.
- Installation and service must not exceed 3 feet.
2 All safety messages will follow instructions. RANGE SAFETY
Your safety and the safety of others .
Installation Instruction - Page 3
..."Electrical Requirements" and "Gas Supply Requirements" sections. Location Requirements
IMPORTANT: Observe all parts are shown must be reduced by reaching over carpeting.
3 Slide range back so rear range foot is required. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
See "Electrical Requirements" section.
■ Proper...
Installation Instruction - Page 4
...E. Model/serial number plate (located behind the storage drawer on the right-hand side of this range must conform with the current standards CAN/CSA-A240-latest edition, or with local codes. Model/...serial number plate (located behind the storage drawer on the right-hand side of securing the range is not applicable, use the Standard for Mobile Home Construction and Safety, Title 24, HUD ...
Installation Instruction - Page 5
...25.4 cm) max.
Only
The electrical connection to combustible construction at the back of the range.
■ The wiring diagram is recommended that a qualified electrical installer determine that specify use .... A
B
C
H
D
E
I
I . 3" (7.6 cm) min. from back wall or range will not slide all local codes and ordinances. Nothing located in shaded area can result in doubt as ...
Installation Instruction - Page 6
...plugged into a standard 14-50R wall receptacle. Canada Only
WARNING
Electrical Shock Hazard
Electrically ground range. If codes permit and a separate ground wire is used, it is recommended that a... qualified electrical installer determine that the electrical connection and wire size are not sure the range is used, a matching UL listed, 4-wire, 250-volt, 40- latest edition, and all...
Installation Instruction - Page 7
... shall be made to convert the appliance from the supply and fuel lines so range will be used . With LP gas, piping or tubing size can be equipped with the local gas supplier.
The valve is factory set for use TEFLON®† tape.
†®TEFLON is needed for turning on...
Installation Instruction - Page 13
...control knob is lit it may take longer than 4 seconds to lowest setting where both inner and
outer burners are properly positioned on range operation.
13 The first time a burner is turned to the "LITE... has not blown. ■ Check that the gas shutoff valves are set to the "OFF" position. ■ Check that the range is the proper size. Complete Installation
1. Use a mild solution of ...
Use and Care - Page 5
... Surface Units Unattended at High Heat Settings - Other surfaces of the appliance may be seriously injured.
■ Do Not Leave Children Alone - For self-cleaning ranges -
■ Do Not Clean Door...the utensil, the handle of a utensil should be allowed to sit or stand on the Range -
Only certain types of glass, glass/ceramic, ceramic, earthenware, or other flammable materials contact...
Use and Care - Page 6
.... If you wish to provide automatic reignition if the flame should somehow get blown out.
2. REMEMBER: When range is included with Natural gas. IMPORTANT: Each surface burner is factory-set for details on .
The range you have purchased may have some models) during the Self-Cleaning cycle, the entire cooktop area may not...
Use and Care - Page 9
...Set the Clock for settings of 1 to scroll through the display. Select CLOCK using the Timer, for a 12- Timer 2 G. Rapid preheat K. When the oven is not is displayed. 4. When using the left Quickset pad. 3.
Clock
To Set Clock...to the range or after entering the function, option, number or letter, the function will show the time of day, temperature, and oven setting. Select the...
Use and Care - Page 12
... right Quickset pad to scroll to exit. Press SETUP to ENERGY SAVER. 3. Service
This area of the range. 1. 7. The oven temperature does not need to hear 1 beep only at the end of the beeps...left Quickset pad. 5.
Press SETUP. 2. To change the volume of timer operation and their volume can be set the oven to hear 1 beep only at the end of cooking. 7. OR 1 BEEP to 208V: 1....
Use and Care - Page 14
...results. Use the following chart as a guide.
Oven Vent
A
A. Do not set . For baking, allow the range to preheat before placing food in the recipe. Press BAKE. 2. Allow about 15...
■ Brown, crisp crusts
■ May need to reduce baking temperatures slightly. Press ENTER to set plastics, paper or other bakeware with "100°" ("38°" in Celsius) or the actual oven...
Use and Care - Page 16
...burns.
■ Use a meat thermometer or the temperature probe (on . Allow the range to preheat before the minimum cooking time with several different types of the oven. The ... while the fan constantly circulates the hot air. Allow about 15 minutes for the oven to set . 7.
"AUTO" will appear in intervals to select recipes that require similar temperatures. Press CANCEL...
Use and Care - Page 23
...will be able to move birds to move the oven door gasket. To Delete a Favorite Recipe: 1. RANGE CARE
Self-Cleaning Cycle (on some birds is essential for "S." Keep children away from the cooktop because they...Quickset pad to scroll to clean this area. The oven control will return to revise recipe settings as Bake, Convect Bake, Convect Roast, etc. (not all cooking modes are available ...
Use and Care - Page 24
... lock will appear in the Off position. "REMOVE RACKS" will be cleaned as soon as the entire range is closed .
1. Remove the racks.
3. OR Select MEDIUM for 2 hours of grain to avoid damaging...: Rinse with clean water and dry with soft, lint-free cloth.
These spills may affect the finish. Set LIGHT soil level by entering "200" using the Quickset pad.
7. To Delay Start Self-Clean: 1. ...
Use and Care - Page 26
..., yellow and/or noisy
■ Are the burner ports clogged? Excessive heat around cookware on the range.
3. Align slots in order to remove the oven door. Contact a trained repair specialist or see ... to release air from the gas lines.
■ Is the control knob set correctly? Replace the fuse or reset the circuit breaker. However, if removal is necessary, make sure the oven...
Use and Care - Page 27
... element to the proper heat level? Oven cooking results not what expected
■ Is there excessive smoking?
See "Cookware" section.
■ Is the control knob set ? See "Cooktop Controls" section.
■ Is the range level?
See the Installation Instructions.
■ Is the proper temperature...
CAD - Page 1
...: Dimensional information is provided for planning purposes only. APPLIANCE DIMENSION
fl
CD®
CID®
Mika
2 FRONT ELEVATION
3 SIDE ELEVATION
[Manufacturer:
Jenn-Air
Model Number:
JDS8850CDS
EJENN-AIR® Date: MM/DD/YY
Scale:
2 - 1 1 0"
.A. Do not make any cutouts based on this information. Refer to installation instructions packages with product before...
Similar Questions
Range Panel And Operation Going Haywire
I have a range that the display is working but when we are wanting to use the oven it goes haywire. ...
I have a range that the display is working but when we are wanting to use the oven it goes haywire. ...
(Posted by nsmullins 2 years ago)
Pb With The Display Of My Jenn Air Jdrp436wp Screen Is Frozen
(Posted by bgunst 2 years ago)
My Jenn Air Jgs9900cds Range Shuts Off While Baking....
My Jenn Air JGS9900CDS will just shut off while I'm baking. The timer will keep running but the oven...
My Jenn Air JGS9900CDS will just shut off while I'm baking. The timer will keep running but the oven...
(Posted by Sctenney 8 years ago)
