Hoover C1404 Support Question
Hoover C1404 Support Question
Find answers below for this question about Hoover C1404 - Commercial Elite Upright.Need a Hoover C1404 manual? We have 1 online manual for this item!
Question posted by drp225 on July 27th, 2013
1hoover C1404 On-off Switch.how To Replace And Where To Get It? How Much It Cost
I have Hoove C1404 and need to replace Belt and ON-OFF switch. Pl guide me. Thanks
Current Answers
Related Hoover C1404 Manual Pages
Manual - Page 1
... Service 9 Replacing Agitator 8 Replacing Belt 7-8 Replacing Filter Bag 6-7 Unpacking Cleaner 2
DOUBLE INSULATED: When servicing, use as described in the instructions. Lightweight Commercial Cleaner
Operating ... Do not allow vacuum cleaner to a Hoover Factory Service Center or Authorized Hoover Commercial Warranty Service Distributor. • Use vacuum cleaner only for servicing...
Manual - Page 2
... will look like this drawing. STEP 1 Unpack carton
1
AB E
C F
1 A.Upper handle
B.Lower handle
D
C. Filter bag
G.Handle bolt and nut packet G
(One extra nut included)
H. Extra belt (One installed on cleaner)
H
Remove all parts, especially small items, such as G and H, are located before disposing of cardboard packing.
2
Cleaner body
D. Make sure all...
Manual - Page 3
...on sides of handle, with hands on a
flat surface, aligning rod sections (D).
However, do not remove the switch lock until assembly is completed. STEP 3 Attach cord
3
"UP"
F
4 F
UP
E
G
3 Insert...not press against the rod extending from the lower handle (Fig. 3, "E"). tinued if the switch lock is pushed into place at each of the three notches indicated and note correct positioning of...
Manual - Page 4
...place assembled handle onto handle base (J) of cleaner body.
Note: If tab has come off during assembly, make sure switch is not pushed completely down firmly to the operat- Note: Only one nut is pulled tight and pressed into slot .... Hold nut
in place while tightening bolt securely with a screw driver.
Be sure that power cord is needed on this model. ing or middle position.
Manual - Page 5
...To reduce the risk of cleaner is lifted off , push switch down.
18
19
20
21
18 Plug cord into electrical outlet. upright for storage. operating for height of cleaner.
zip outer bag...handle: located on bottom of carpet being cleaned
9. Step on , push switch up. If the plug does not fit fully in the upright position.
This insures that the filter bag is wider than the other). ...
Manual - Page 6
...knob to the desired setting.
Do not operate without filter bag in the upright position.
The filter bag
When to replace
Check filter bag from electrical outlet before attempting to service it in carpet near...the filter bag frequently when using cleaner on new carpet due to edge of dirt. Guide either side of nozzle parallel to rapid accumulation of carpet and rugs takes place at peak...
Manual - Page 7
... agitator.
Note: Do not clean out old filter bag and reuse. Place handle in belt guide (C).
side of
cleaner body. Snap bottom plate into slots in filter bag with steps ...three arrows. Pry outward to align flat sides of projection (D) on belt end of filter bag collar (A) and pull collar from electrical outlet. Replace belt if it is important for part No. 38528040.
31
28 Hold new...
Manual - Page 8
... cleaner over and lift off motor pulley as shown in Fig. 29 of "How to replace belt".
If the agitator does not turn, remove bottom plate and reposition belt in the belt guide.
36 Place hood on hood slightly to replace
Disconnect cleaner from electrical outlet. How to make sure all four
latches. To check condition...
Manual - Page 9
...of authorized service outlet locations (U.S. only).
Always identify your cleaner to those parts being replaced. In Canada, contact Hoover Canada, Carson Building, 100 Carson Street, Etobicoke, Ontario...the system, and should a means for an automated referral of doubleinsulated appliances
This vacuum cleaner is needed, call 1-800-263-6376 to speak with the words "DOUBLE-INSULATION" or ...
Similar Questions
My Hoover Steamvac Spinscrub Makes Streak Lines On Carpet When Using.one Of The
the middle brush under neath my hoover steamvac spinscrub keeps falling out when i pick cleaner up t...
the middle brush under neath my hoover steamvac spinscrub keeps falling out when i pick cleaner up t...
(Posted by roseannkelly32 8 years ago)
I Have The Hoover Uh70040w Mach Cyclonic Upright Vacuum Cleaner Its Sliver And I
I have the hoover cyclonic upright vaccume cleaner it is making a very lound grinding like noise whe...
I have the hoover cyclonic upright vaccume cleaner it is making a very lound grinding like noise whe...
(Posted by dorkylilrawr 9 years ago)
Hoover Elite Commercial Vacuum Model 1404
I have a Hoover Elite Commercial vacuum model 1404, what hose fits this?
I have a Hoover Elite Commercial vacuum model 1404, what hose fits this?
(Posted by chenriques 11 years ago)