GE GFC720F Support Question
GE GFC720F Support Question
Find answers below for this question about GE GFC720F - 3/4 HP Continuous Feed Disposer.Need a GE GFC720F manual? We have 1 online manual for this item!
Question posted by Anonymous-60916 on May 30th, 2012
Reset Botton On G E Gfc720f Garbage Disposal
The person who posted this question about this GE product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related GE GFC720F Manual Pages
Use and Care Manual - Page 1
... 2
Installation Instructions
Attaching the Discharge Elbow 6 Components and Installation of Sink Flange 5 Connecting Disposer to Sink Flange 7 Dimensions/Typical Installations 8 Dishwasher Connection 6
Operating Instructions
Batch Feed Models 9 Care and Maintenance 10 Continuous Feed Models 9
Troubleshooting Tips
Before You Call for Service . . . . . .11
Consumer Support
Warranty 12...
Use and Care Manual - Page 2
...I Turn the power switch (normally a wall switch) to remove objects from the disposer. b) Caustic drain cleaners or similar products.
I Use this appliance only for electric ... of objects falling into a disposer:
a) Clam or oyster shells.
d) Large whole bones.
The batch-feed or "TC" model
connects to the hot side, while the continuous feed
model connects to loosen a ...
Use and Care Manual - Page 3
... the continuous feed model connects to the OFF position or remove the fuse. DANGER: Improper connection of the
equipment-grounding conductor can result in your power supply does not include a ground wire, you use a three-prong plug. A. B. Check with all local codes and ordinances. GEAppliances.com
WARNING! To Wire Your Disposer Directly into...
Use and Care Manual - Page 4
... (Part Number PM3X215)
4 Keep these instructions completely and carefully.
• IMPORTANT - Observe all governing codes and ordinances.
• Note to disposer. 2. Remove old disposer or sink flange assembly. 3.
PREPARATION
1.
Installation Instructions
Disposer
If you have questions, call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com
BEFORE YOU BEGIN...
Use and Care Manual - Page 5
...flange through the rubber gasket into the sink opening .
Unscrew the support ring from the disposer by the factory.
Use putty sparingly on the inside of the sink flange. Do ... Hopper
Dishwasher Discharge Inlet
Elbow Gasket
Disposer
End Bell (Electrical Connections)
Elbow Flange
Rating Label in This Area
*Not used with batch feed model
Screws
Discharge Elbow
INSTALLATION OF SINK...
Use and Care Manual - Page 6
...
Connect the dishwasher hose using a hose clamp.
Hose Clamp
Stepped Rubber Adapter
3 ATTACHING THE DISCHARGE ELBOW
CONNECT DISCHARGE ELBOW
Connect the discharge elbow to the disposer.* Make sure all plumbing connections are connecting to grind, over the course of a flexible drain pipe.
Do not use of several
uses. Installation Instructions
2 DISHWASHER...
Use and Care Manual - Page 7
... the extreme left of petroleum jelly or liquid soap to the right until the disposer discharge elbow lines up the disposer under the sink flange. If the mount ring is temporarily supported. Guide the... leaks.
2 LINE UP WITH OUTLET PIPE
Turn the mount ring and the disposer until it locks up tight.
Run water and check for leaks 24 hours after installation and first operation...
Use and Care Manual - Page 8
...
4 1/2" 11/2"
GFC720 Model Series
8 1/2"
93/8"
165/8"
5 9/16"
4 1/2" 11/2"
GFB760 Model Series Batch Feed Operation
8 1/2"
7 1/4"
161/16"
5 9/16"
4 1/2" 11/2"
GFC1020 Model Series
SOME TYPICAL INSTALLATIONS
Direct replacement ...;, depending upon the models listed above, to avoid standing water in disposer motor housing.
**Flexible drain pipe may be necessary for Model Series GFB760...
Use and Care Manual - Page 9
...
shredding stops.
B. To speed up food waste disposal, cut or break up with the switch
plunger. This assures that all waste is thoroughly flushed through the trap and drain. C.
This assures that all
waste is thoroughly flushed through
Small
the trap and drain. Continuous Feed Models
A.
Do not be accidentally
dropped into place...
Use and Care Manual - Page 10
... stopper in the drain when not in the trash can drain properly. D.
The disposer is equipped with a removable splash guard for the Batch Feed model, is self cleaning and scours itself with a little household scouring powder will not grind and dispose such items as they cause serious corrosion of metal parts. I NEVER put...
Use and Care Manual - Page 11
...leak is red and located opposite the discharge elbow, near the bottom of elbow flange screws.
*Batch Feed does not include splash guard.
11 Turntable cannot rotate.
• If the turntable does not turn... the turntable moves freely, replace the splash guard* and check the reset button to the disposer. Support ring not tightened properly. 3. Review the chart on this page first and you ...
Use and Care Manual - Page 12
...To know what your legal rights are excluded).
I Replacement of house fuses or resetting of the original purchase date is extended to the original purchaser and any succeeding... Two Years From the date of incidental or consequential damages.
I Service trips to the replacement disposer. This warranty gives you specific legal rights, and you how to functional parts only (appearance ...
Similar Questions
Reset Button
where do i locate the reset button on my ge gfc720f garbage disposal
where do i locate the reset button on my ge gfc720f garbage disposal
(Posted by marilynkern01 6 years ago)
Where Is The Ge Garbage Disposal Gfc325f Reset Button?
(Posted by buhaDi 9 years ago)
How Do I Remove Ge Garbage Disposal Gfc 530?
I tried to remove the disposal mounting ring with a flat screw driver, but it just does not turn. Ho...
I tried to remove the disposal mounting ring with a flat screw driver, but it just does not turn. Ho...
(Posted by nalindamani 11 years ago)
