GE GFC720F Support Question
GE GFC720F Support Question
Find answers below for this question about GE GFC720F - 3/4 HP Continuous Feed Disposer.Need a GE GFC720F manual? We have 1 online manual for this item!
Question posted by marilynkern01 on July 11th, 2017
Reset Button
where do i locate the reset button on my ge gfc720f garbage disposal
Current Answers
Answer #1: Posted by Odin on July 11th, 2017 2:26 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,670
Member since:
April 10th, 2010 Points: 41,236,670
See the picture in the second column of https://www.manualslib.com/manual/57887/Ge-Disposall-Gfb760-Series.html?page=3&term=reset.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related GE GFC720F Manual Pages
Use and Care Manual - Page 1
... 2
Installation Instructions
Attaching the Discharge Elbow 6 Components and Installation of Sink Flange 5 Connecting Disposer to Sink Flange 7 Dimensions/Typical Installations 8 Dishwasher Connection 6
Operating Instructions
Batch Feed Models 9 Care and Maintenance 10 Continuous Feed Models 9
Troubleshooting Tips
Before You Call for Service . . . . . .11
Consumer Support
Warranty 12...
Use and Care Manual - Page 2
... breakdown, grounding provides a path of electric shock. Most houses have a proper outlet installed by a waste disposer, do not put fingers or hands into the disposer. The batch-feed or "TC" model
connects to the hot side, while the continuous feed
model connects to reduce the risk of least resistance for its intended purpose as bottle...
Use and Care Manual - Page 3
... Reset Button
Ground Screw
To House Current or Power Cord
Wire Nuts
Remove Cover Plate
Bottom of electric shock.
NOTE: Disconnect electric power to white lead of the disposer (end bell). Turn the circuit breaker to exceed 36″ in a risk of electric shock.
To Wire Your Disposer Directly into the House Current:
GE recommends...
Use and Care Manual - Page 4
...heavily coated with hardened
grease and accumulations, rout out with the Consumer.
• Note to disposer. 2. Installation of this appliance requires
basic mechanical skills. • Completion time - 1 hour ...and gasketing from sink opening, both top and bottom. Installation Instructions
Disposer
If you have questions, call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com...
Use and Care Manual - Page 5
...Groove Hopper
Dishwasher Discharge Inlet
Elbow Gasket
Disposer
End Bell (Electrical Connections)
Elbow Flange
Rating Label in This Area
*Not used with batch feed model
Screws
Discharge Elbow
INSTALLATION OF SINK...with the bottom edge of the sink flange.
Unscrew the support ring from the disposer by the factory. With
arrows pointing up and down
Groove Bottom Bead
Cushion Mount...
Use and Care Manual - Page 6
If a dishwasher is not to be connected, go on to the disposer.* Make sure all plumbing connections are connecting to grind, over the course of a flexible ... stepped rubber adapter.
Installation Instructions
2 DISHWASHER CONNECTION (IF REQUIRED)
If you will not damage the disposer in any way, but may require the use a
screwdriver or sharp instrument. When knockout
plug falls into...
Use and Care Manual - Page 7
...extreme left of petroleum jelly or liquid soap to the hopper projection. Installation Instructions 4 CONNECTING DISPOSER TO SINK FLANGE
1 ATTACH TO SINK FLANGE
Line up tight. Mount Ring Slot
Hopper .... Turn the mount ring about 1/4″ to the right so that the disposer is hard to the right until the disposer discharge elbow lines up with the outlet pipe (see page 8). Run water and...
Use and Care Manual - Page 8
... upon the models listed above, to avoid standing water in disposer motor housing.
**Flexible drain pipe may be necessary for Model... 9/16"
4 1/2" 11/2"
GFC720 Model Series
8 1/2"
93/8"
165/8"
5 9/16"
4 1/2" 11/2"
GFB760 Model Series Batch Feed Operation
8 1/2"
7 1/4"
161/16"
5 9/16"
4 1/2" 11/2"
GFC1020 Model Series
SOME TYPICAL INSTALLATIONS
Direct replacement for most makes...
Use and Care Manual - Page 9
... switch plunger inside the neck of cold water. E. When the medium-sized slot in food waste. Continuous Feed Models
A. C. Before turning the disposer off . Remove the sink stopper and turn on a medium flow of cold water. The disposer is actually increasing torque (grinding power) and is lined up large bones, rinds and cobs. Scrape...
Use and Care Manual - Page 10
... before using the dishwasher so it will also work.
10
TO SPEED UP FOOD WASTE DISPOSAL...Cut or break up large bones, melon rinds, grapefruit skins and corn cobs. Care and maintenance.
I Your disposer, except for the Batch Feed model, is ruggedly built to give you may want to leave the stopper in...
Use and Care Manual - Page 11
... occur. When overloaded, the motor will move freely using a broom handle.
The reset button is red and located opposite the discharge elbow, near the bottom of sink flange (gasket choice, putty ... and check the reset button to see SAFETY NOTE above.
Improper seating of the disposer. Problem
Loud noises (other than those during grinding of elbow flange screws.
*Batch Feed does not include...
Use and Care Manual - Page 12
... or the shortest period allowed by possible defects with the replacement disposer within the USA. Additional Two Years From the date of the original purchase
Model Line Series GFC520: If there is located in materials or workmanship relating to an Authorized GE Service Location for service.
This warranty gives you specific legal rights, and...
Similar Questions
Where Is The Reset Button?
(Posted by laleiner 1 year ago)
Where Is The Ge Garbage Disposal Gfc325f Reset Button?
(Posted by buhaDi 9 years ago)
Reset Botton On G E Gfc720f Garbage Disposal
(Posted by Anonymous-60916 11 years ago)
