Dell PowerEdge 2900 Support Question
Dell PowerEdge 2900 Support Question
Find answers below for this question about Dell PowerEdge 2900.Need a Dell PowerEdge 2900 manual? We have 9 online manuals for this item!
Question posted by ejazrasheedbajwa on March 24th, 2014
I
I want to use cpu2 becouse cpu1 not working
Current Answers
Answer #1: Posted by MWatDell on March 24th, 2014 1:43 AM
MWatDell
Member since:
November 17th, 2011 Points: 306,490
Member since:
November 17th, 2011 Points: 306,490
Hi ejazrasheedbajwa
You can either use 1 cpu or 2 cpus for your Dell PowerEdge 2900.
If you want to use only 1 cpu then you will have to occupy cpu1 slot.
You cannot start the server with 1 cpu on cpu2 slot.
If your cpu1 is not working and you would like to use cpu2.
Please remove cpu1 and swap cpu2 into cpu1 slot.
Please refer to this manual for your reference:-
ftp://ftp.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_poweredge/poweredge-2900_owner's%20manual_en-us.pdf
Hope this helps.
MW@Dell
Related Dell PowerEdge 2900 Manual Pages
Installing a SATA Optical Drive - Page 3
....
5 Disconnect the data and power cables from the front of the optical drive.
6 PowerEdge 2900 and 1900 systems only: Perform the following steps. c Release the spring latch at the back...
3 Remove the system cover. See "Opening the System" in your Hardware Owner's Manual.
4 PowerEdge 1950 systems only: Disconnect and remove the SAS controller daughter card.
Installing a SATA Optical Drive
3...
Installing a SATA Optical Drive - Page 4
...back of the drive into the tray and press the drive down to the optical drive.
The PowerEdge 2900 and 1900 systems do not reuse the interposer board attached to the old drive.
1 Pull ...the drive tray provided with the system is used for the SATA optical drive. The pins on the carrier fit into place. PowerEdge 2970, 2950, and 1950
For PowerEdge 2970 and 2950 systems, the optical drive...
Installing a SATA Optical Drive - Page 9
..." in the optical drive kit and connect one end to the optical drive and the other to the SATA connector on the system board. For a PowerEdge 2900, use the SATA_D connector. For a PowerEdge 2900 system, connect to an available power supply cable.
5 Replace the center fan bracket.
Installing a SATA Optical Drive - Page 10
... 1900
3
2
4
5 1
1 optical drive 3 SATA data cable 5 SATA power connector on SAS
backplane (PowerEdge 2900 only)
2 SATA power cable 4 SATA connector on the system and attached peripherals.
10
Installing a SATA Optical Drive SATA Cable Routing in your Hardware Owner's Manual.
...
Information Update - Page 1
Dell™ PowerEdge™ 2900 Systems
Information Update
Information Update - Page 2
... you make better use of Dell Inc.; Dell Inc. disclaims any manner whatsoever without notice. © 2006-2009 Dell Inc.
Microsoft, Windows, and Windows Server are trademarks of ...used in this document to refer to either trademarks or registered trademarks of Novell Inc.
Other trademarks and trade names may be used in this text: Dell, the DELL logo, and PowerEdge...
Information Update - Page 3
... Setup Program Update 19 Memory Screen 19 CPU Information Screen 20 Integrated Devices Screen 20 System Security Screen 21 Serial Communication Screen 22
Contents
3 Contents
PowerEdge 2900 III - New System Features 5 New Performance Features 5 New I/O and Storage Features 5 New Security Features 5
Optional Internal USB Memory Key 6 Installing the Optional Internal USB Memory...
Information Update - Page 5
... for 10 Gb Ethernet cards. • One internal USB 2.0-compliant connector supporting an optional
bootable USB flash drive or USB memory key. • Support for PowerEdge 2900 II and PowerEdge 2900 III
systems • System board replacement - This document provides updated information for your system on the following topics: • New system features for...
Information Update - Page 6
Optional Internal USB Memory Key
The PowerEdge 2900 III system provides an internal USB connector located on page 20. Internal USB Connector Location
1
2
1 system board
2 internal USB connector location
6
Information Update The USB memory key can be enabled in the Integrated Devices screen of the System Setup program. To use with a USB flash memory...
Information Update - Page 9
Processor Upgrades - PowerEdge 2900 II and PowerEdge 2900 III Systems
• If the front of your system chassis is labeled ... PowerEdge 2900 III systems using the TPM with a "III", your hard drive(s).
If you can access the encrypted files on the latest processor upgrade options for information on your system is labeled with an encryption program, you are using Windows Server®...
Information Update - Page 10
... precautions, working inside the system. Remote Access Controller initialization failure
Ensure that node interleaving cannot be available... The system halted because Remove the PCIe expansion
an invalid PCIe expansion card and install the internal
card is properly installed.
Node Interleaving disabled! Check other system messages for additional information for the PowerEdge 2900 III...
Information Update - Page 14
...: The installed memory configuration is not optimal.
Faulty USB device, USB medium, optical drive assembly, hard drive, or hard-drive subsystem. For information on the PowerEdge 2900 III system and the probable cause for each message.
Information Update - Page 21
... stores the pre-boot measurements (compliant with TPM. Integrated Devices Screen Options (continued)
Option
Description
System Interrupts This field controls the interrupt assignment for the PowerEdge 2900 III system.
System Security Screen
Table 1-6 lists new options for PCI devices in the system. When set to Distributed, interrupt routing is set to On...
Information Update - Page 23
... for Microsoft Windows 2000
If you run the System Build and Update Utility, Microsoft® Windows® 2000 is supported by the PowerEdge 2900 and 2900 II systems, but not by the PowerEdge 2900 III system. Older releases of operating systems on RHEL 3 Update 8 and SLES 9 SP4. This operating system is included in a future RHEL...
Information Update - Page 46
System Security
表 1-6 PowerEdge 2900 III TPM。
TPM Security （TPM TPM。
表 1-6. 新的 System Security
选项
说明
TPM Security
TPM
（TPM Off [
关
]&#...
Information Update - Page 48
Microsoft Windows 2000
System Build and Update Utility Microsoft® Windows® 2000 将位于 Server OS Install PowerEdge 2900 和 2900 II PowerEdge 2900 III
Customize Log output file pathname USB
1-3
48
信息更新
Information Update - Page 116
Memory configuration does not support Node Interleaving.
れかの DIMM
ださい。
116 Node Interleaving disabled! PowerEdge 2900 III 1-1
表 1-1
原因
対応処置
Alert!
Information Update - Page 133
...; cat/sys/devices/system/cpu/cpuxx/cpufreq/scaling_ cur_freq
• RHEL 3 9 Intel Xeon 54xx proc/cpuinfo
RHEL 4
Microsoft Windows 2000
System Build and Update Utility Server OS Install OS OS Microsoft® Windows® 2000 PowerEdge 2900/2900 II OS PowerEdge 2900 III
133
Information Update - Page 146
...
DIMM
!!*** Error: Remote Access Controller initialization failure *** RAC virtual USB devices may not be available... RAC
Invalid PCIe card found in the Internal_Storage slot!
표 1-1 PowerEdge 2900 III
표 1-1
메시지
원인
Alert! Node Interleaving disabled!
Information Update - Page 160
.../cpu/cpuxx/cpufreq/scaling_ cur_freq
• Intel Xeon 54xx RHEL 버전 3 9 proc/cpuinfo
RHEL 4 Update
Microsoft Windows 2000
Microsoft® Windows® 2000 이 Server OS Install(서버 OS PowerEdge 2900 III 대신 PowerEdge 2900 및 2900 II
USB
160
Similar Questions
Dell Server Poweredge R710 Error Message Error 1
hi Good Day,we are having issue with our dell R710 with error message error 1 but we look up in OMSA...
hi Good Day,we are having issue with our dell R710 with error message error 1 but we look up in OMSA...
(Posted by jillustrisimo32 4 years ago)
E161c E1614
I have ben a fail a in message monitor the Server PEdge 2900E1624E161C
I have ben a fail a in message monitor the Server PEdge 2900E1624E161C
(Posted by rmiciano 5 years ago)
How To Get Data From Internal Storage Of The Server Dell 2900
(Posted by 03gstep 10 years ago)
How To Configure Raid In Dell Server Poweredge 710
(Posted by brandaniep 10 years ago)