Bosch VDC-455V04-20 Support Question
Bosch VDC-455V04-20 Support Question
Find answers below for this question about Bosch VDC-455V04-20.Need a Bosch VDC-455V04-20 manual? We have 1 online manual for this item!
Question posted by junagonzalez on March 15th, 2013
White Trim Ring For 5 Inch Base Bosch Security Camera.
Do have trim rings to cover wall imperfections in the vicinty of a round 5 inch diameter secuirty camera base?
Current Answers
Related Bosch VDC-455V04-20 Manual Pages
Installation Instructions - Page 3
... radiators, heat registers,
stoves, or other equipment (including amplifiers) that may be of electric shock, do not remove cover (or back).
Keep these instructions. 2. Do not use this equipment near any ventilation openings.
Bosch Security Systems | 2005-11 | V1.0 No user-serviceable parts inside. Do not install near water. 6. Warning
The exclamation mark...
Installation Instructions - Page 4
... fit into the equipment, the equipment has been exposed to qualified service personnel. Warning
To reduce the risk of the polarized or grounding-type plug. Bosch Security Systems | 2005-11 | V1.0
Installation Instructions - Page 5
... can radiate radio frequency energy and, if not installed and used in a residential installation. For additional information or to speak to a representative, please contact the Bosch Security Systems location nearest to operate the equipment. This equipment generates, uses and can be determined by turning the equipment off and on a circuit different from...
Installation Instructions - Page 6
... menu • Bilinx™ bi-directional coaxial communications
The FlexiDomeVF camera is easy to install and ready to a wall or ceiling. Bosch Security Systems | 2005-11 | V1.0
The FlexiDomeVF camera is available in color and monochrome versions. FlexiDomeVF | Installation Manual
EN | 6
Introduction
The FlexiDomeVF camera is mounted to an electrical box or to use, and offers...
Installation Instructions - Page 7
... camera • Mounting hardware kit • Installation manual
Note If equipment appears to have been damaged during shipment, repack it in the original packaging and notify the shipping agent or supplier. Bosch Security ...VDM345V03-20
Varifocal 2.6-6 mm F1.4-360
VDM345V04-20
Varifocal 4-9 mm F1.6-360
Standard Supply voltage
CCD type
CCIR
EIA
24 Vac, 50Hz or 12 Vdc
24 Vac, 60Hz or 12 Vdc
...
Installation Instructions - Page 8
... unit consists of the base.
Bosch Security Systems | 2005-11 | V1.0 FlexiDomeVF | Installation Manual
EN | 8
Caution
Installation should only be handled carefully.
To disasemble the unit proceed as follows: • Rotate the trim ring counterclockwise to release it off of the following parts:
Camera module and mounting base
Inner liner
Trim ring
Dome
Caution
The camera module is...
Installation Instructions - Page 9
... in accordance with the National Electrical Code or applicable local codes. hollow surface
Wires
Strong surface (three pre-drilled 8mm holes)
Three screws (supplied)
Mounting base
Bosch Security Systems | 2005-11 | V1.0 Figure 1 Rear connection - Tips • Refer to the dimensions drawing to
temporarily hang the camera while the connections are made.
Installation Instructions - Page 10
...Solid surface (three pre-drilled 8mm holes)
Three screws (supplied with camera) Three screws (M5, supplied)
Conduit
Wires
Raised mounting base (VDA-445SMB)
Camera unit and base
Bosch Security Systems | 2005-11 | V1.0 FlexiDomeVF | Installation Manual Figure 2 Connection to an electrical box (4S)
EN | 10
S4 Electrical box
Two screws (not supplied)
Mounting base
Figure 3 Surface mounting -
Installation Instructions - Page 11
Bosch Security Systems | 2005-11 | V1.0 With a rear connection, leave the cap in place. • Attach the conduit to the mounting base. • Make the connection inside the mounting case. rear connection
Conduit
EN | 11 Wires
Solid surface
(three pre-drilled
8mm holes)
Cap
Three screws (supplied with camera)
Three screws (M5, supplied)
Surface mounting...
Installation Instructions - Page 12
...a DC supply the polarity is of the camera module to the video coax
cable. • Connect the stripped power wires to the power supply connector. Bosch Security Systems | 2005-11 | V1.0
Be sure...as follows: • Bring the building connections through the surface wire hole. • Secure the mounting base to the surface with male BNC connector) and two stripped low voltage power wires for...
Installation Instructions - Page 14
... are highly sensitive and require special care for tilted ceilings or sidewall
mounting), rotate the base of the lens as necessary to direct sunlight or bright spotlights in the base.
Refocus if necessary. Bosch Security Systems | 2005-11 | V1.0 The camera module position can be adjusted along three axes. Do not rotate more than 340...
Installation Instructions - Page 15
... all adjustments have been made, close the unit. • Place the inner liner in position aligning its fin with the bracket on the
base. • Place the trim ring with dome onto the base. (If necessary clean its
surface with a soft cloth.) • Fix the trim ring onto the camera base by rotating clockwise.
Bosch Security Systems | 2005-11 | V1.0
Installation Instructions - Page 17
Installer
Set focus now Comm Defaults Exit
Defaults
Restore all?
EN | 17
Bosch Security Systems | 2005-11 | V1.0
FlexiDomeVF | Installation Manual
Menu Structure
Main menu
Level Shut/AGC BLC Color Sync Vphase Exit
Shut/AGC
Shutter AGC Auto black NightSense*
COLOR*
White balance R-gain B-gain
* Only for the Color version of the camera.
Installation Instructions - Page 18
Bosch Security Systems | 2005-11 | V1.0 FlexiDomeVF | Installation Manual
Hints for menu navigation
How to use the 5 keys
Camera base
Up key
Left key
EN | 18 Menu/select key
Right key
Down key
• Press the menu/select key to access the menus or to ...
Installation Instructions - Page 20
... camera. • In AUTO mode, the camera automatically inches to change the white point offset for optimal color reproduction. • AWB HOLD: Puts the ATW on hold and saves the color settings.
Note If NightSense™ is only necessary to monochrome in low-light conditions. • In FORCED mode, the camera remains in the picture.
Bosch Security...
Installation Instructions - Page 22
... 1/100000), Flickerless selectable On, Off selectable AGC On (20 dB) or Off selectable Sharpness enhancement BLC On or Off selectable Automatic 2500 - 9000K (with AWB hold mode) Integrated Varifocal with DC iris < 5 W
58 x 66 x 122 mm (HxWxL) 550g -10° to 45° C
OSD with softkey operation
Bosch Security Systems | 2005-11 | V1.0
Installation Instructions - Page 23
FlexiDomeVF | Installation Manual
Dimensions (mm/inches)
57.6
57.6
2.27
2.27
EN | 23
1.31
33.3
2.62
66.5
121 4.77
3.29
83.5
1.26
32
95 3.7
158 6.22
Bosch Security Systems | 2005-11 | V1.0
Installation Instructions - Page 24
FlexiDomeVF | Installation Manual
EN | 24
Dimensions with surface mount box (mm/inch)
53.3 2.1
53.3 2.1
30.8 1.21
1.38
35
121 4.77
4.86
123.5
158 6.22
Bosch Security Systems | 2005-11 | V1.0
Installation Instructions - Page 65
FlexiDomeVF | Installationshandbuch
Menüstruktur
Main
Level Shut/AGC BLC Color Sync Vphase Exit
Shut/AGC
Shutter AGC Auto black NightSense*
COLOR*
White balance R-gain B-gain
* Nur bei dem Farbmodell der Kamera.
DE | 65
Bosch Security Systems | Okt. 2005 | V 1.0 Installer
Set focus now Comm Defaults Exit
Defaults
Restore all?
Installation Instructions - Page 113
Installer
Set focus now Comm Defaults Exit
Defaults
Restore all?
NL | 113
Bosch Security Systems | 2005-10 | V1.0 FlexiDomeVF | Installatiehandleiding
Menustructuur
Menu Main
Level Shut/AGC BLC Kleur Sync Vphase Exit
Shut/AGC
Shutter AGC Auto black NightSense*
COLOR*
White balance R-gain B-gain
* Alleen voor kleurenuitvoering van de camera.
Similar Questions
Firmware Nwc-0495?
Cual es la ultima versión de firmware nwc-0495?
Cual es la ultima versión de firmware nwc-0495?
(Posted by sperezlindo 4 years ago)
How Do I Connect My Nbn-498-11p Cameras To My Divar 7oo?
Can I Use Bosch Nbn-498-11p Camera As A Pure Analog Camera?
Can I Use Bosch Nbn-498-11p Camera As A Pure Analog Camera?
(Posted by sheyeadeniran 7 years ago)
Bosch Nbn Camera 498
problem in recording on BOSCH DLA 1400 of BOSCH camera NBN 498 due to password and username(access d...
problem in recording on BOSCH DLA 1400 of BOSCH camera NBN 498 due to password and username(access d...
(Posted by sheikhraja 10 years ago)
Dual Vga View
Dear Sir, I am using DHR-753. I want to see same camera result on two different LCD's. and want to...
Dear Sir, I am using DHR-753. I want to see same camera result on two different LCD's. and want to...
(Posted by nauman01 11 years ago)
Vdc 455v04-20 Vs Vdc 455v04-10
What is the difference beteen the 2 cameras. We currently have the -10. Is it the vodeo system PAL v...
What is the difference beteen the 2 cameras. We currently have the -10. Is it the vodeo system PAL v...
(Posted by louisnolet 12 years ago)