ZyXEL P-2612HNUL-F1F Support and Manuals
Get Help and Manuals for this ZyXEL item
View All Support Options Below
Free ZyXEL P-2612HNUL-F1F manuals!
Problems with ZyXEL P-2612HNUL-F1F?
Ask a Question
Free ZyXEL P-2612HNUL-F1F manuals!
Problems with ZyXEL P-2612HNUL-F1F?
Ask a Question
Popular ZyXEL P-2612HNUL-F1F Manual Pages
User Guide - Page 4
... information ready when you contact an office.
• Product model and serial number. • Warranty Information. • Date that cannot be here. Please have a specific question about ZyXEL products.
• Forum This contains discussions on ZyXEL products. Learn from this link.
Customer Support
Should problems arise that you should contact your experiences as well.
User Guide - Page 24
...24
P-2612HNU(L)-FxF User's Guide Figure 4 USB File Sharing or Print Server Application
A
B
1.2.4 Wireless Connection
By default, the wireless LAN (WLAN) is enabled on your wireless network. Alternatively, you can set up a wireless network with WPS (WiFi Protected Setup) or manually add a client to access network resources.
Chapter 1 Introduction
1.2.3 ZyXEL Device's USB Support
Use...
User Guide - Page 35
...
going through the LAN ports of NAT sessions on the ZyXEL Device.
Firmware Upgrade
Firmware Upgrade
Use this screen to identify problems with the DSL connection. Log Setting Log Setting
Use this screen to select which SIP accounts.
Call Rule
Speed Dial
Use this screen to configure speed dial for network services.
DSL Line
Use this screen to upload...
User Guide - Page 85
A warning message appears if there is a connection problem. P-2612HNU(L)-FxF User's Guide
85
You can also register and unregister SIP accounts.
4.2 The Connection Status Screen
Use this screen to view the network connection status of the ZyXEL Device and clients connected to look at the current status of the device, system resources, interfaces (LAN, WAN...
User Guide - Page 98
... Bit Rate) to 4094) for applications that system default is the maximum rate at the peak rate.
This...identifies a service name, then enter both components exactly as your PPPoE service here.
98
P-2612HNU(L)-FxF User's Guide
Enter the password associated ...higher the priority level.
The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can send cells....
User Guide - Page 99
...Authentication Mode
The ZyXEL Device supports PAP (Password Authentication Protocol)
and CHAP (Challenge Handshake Authentication Protocol).
A static IP address is a network-layer protocol used to have the ZyXEL Device use the DNS server addresses you configure manually. Enter the static IP address provided by this if you select Bridge in the WAN Service Type field.
Select...
User Guide - Page 100
... DNS server address assigned by the ISP.
Select Routing as the encapsulation mode and IPoE as the WAN service type.
100
P-2612HNU(L)-FxF User's Guide IPoE
Click the Add new WAN Interface in the Network Setting > Broadband screen or the Edit icon next to the connection you want to the previous screen.
5.2.1.2 Routing- Apply...
User Guide - Page 104
... field. it is available only when you select Apply as the encapsulation mode. Select Bridge as Default Gateway in the Network Setting > Broadband screen or the Edit icon next to the connection you configure manually.
This is not used to have the ZyXEL Device use the DNS server addresses you want to have the...
User Guide - Page 131
... interface on page 123 for more details about WPS. Apply Back
See Section 6.2.1 on the ZyXEL Device when wireless LAN is associated. P-2612HNU(L)-FxF User's Guide
131
Select this check box to configure security settings manually.
WPS allows you have set the security mode of the SSID1 profile (see Section 6.2 on page 143 for more information...
User Guide - Page 198
Chapter 10 Quality of Service (QoS)
198
P-2612HNU(L)-FxF User's Guide
User Guide - Page 250
... DiffServ Code Points (DSCP) indicating the level of where the traffic is a class of service (CoS) model that marks packets so that sends message waiting status SIP packets as Touch Tone®. Packets are marked with minimum delay, and the networking methods used to give advanced notice of service desired. P-2612HNU(L)-FxF User's Guide Your VoIP service...
User Guide - Page 251
... be marked for different priorities of traffic can define up to be allocated according to the DSCP values and the configured policies. The following services:
• Call Hold • Call Waiting • Making a Second Call • Call Transfer • Three-Way Conference
P-2612HNU(L)-FxF User's Guide
251
are generally available from your VoIP...
User Guide - Page 273
... appears as shown.
Table 77 Maintenance > System > Time Setting
LABEL
DESCRIPTION
Current Date/Time
Current Time
This field displays the time of your ZyXEL Device's time and date, click Maintenance > Time Setting. Use this screen.
Time and Date Setup
P-2612HNU(L)-FxF User's Guide
273 Figure 118 Maintenance > Time Setting
The following table describes the fields in the...
User Guide - Page 277
...Table 79 Maintenance > Firmware Upgrade
LABEL
DESCRIPTION
Current Firmware Version
This is in this screen. Only use to upgrade your device's specific model. Do NOT turn off the ZyXEL Device while firmware upload is the present Firmware version. You can download new firmware releases from your nearest ZyXEL FTP site (or www.zyxel.com) to use firmware for your device's performance...
User Guide - Page 416
...Type of Service, see ToS
224
U
unicast 117
Uniform Resource Identifier 245
Universal Plug and Play, see UPnP
upgrading firmware 289
UPnP...firmware version 90
VID Virtual Circuit (VC) 114 Virtual Local Area Network See VLAN Virtual Local Area Network, see VLAN VLAN 116, 252
group 252 ID 252 ID tags 252 Introduction 116 number of possible VIDs priority frame static
P-2612HNU(L)-FxF User's Guide
ZyXEL P-2612HNUL-F1F Reviews
We have not received any reviews for ZyXEL yet.