TRENDnet TL2-E284 Support and Manuals
Get Help and Manuals for this TRENDnet item
View All Support Options Below
Free TRENDnet TL2-E284 manuals!
Problems with TRENDnet TL2-E284?
Ask a Question
Free TRENDnet TL2-E284 manuals!
Problems with TRENDnet TL2-E284?
Ask a Question
Popular TRENDnet TL2-E284 Manual Pages
Datasheet - Page 1
...232) e. Configure the switch using your choice of Service (QoS): Port-based QoS, bandwidth rate control, ...support. RMON (4 groups) = 19" (1U) Rack mount design with :
a. SSH d.
gigabit
24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots TL2-E284(V1.0R)
The 24-Port 10/100Mbps Layer 2 Switch with 4 Gigabit Ports and 2 Shared Mini-GBIC Slots, model TL2-E284...
Datasheet - Page 2
... Database
• 1522 bytes (max.)
• Bandwidth control per port • 802.3x Flow Control for Full-Duplex and back pressure for Half-Duplex • Support TFTP firmware update, TFTP backup and restore, via Web Browser
TL2-E284
rev:11.15.2010
Datasheet - Page 3
...-MGBSX)
Mini-GBIC Multi-Mode Fiber SX Module (TEG-MGBSX)
24-Port Gigabit Layer 2 Switch w/ 4 Shared Mini-GBIC Slots (TL2-G244)
PACKAGE CONTENTS
• TL2-E284 • Multi-Language Quick Installation Guide • CD-ROM (User's Guide) • Power cord (1.8 m / 5.9 ft.) • RS-232 cable (3 m / 9.8 ft.) • Rack mounting kit
RELATED PRODUCTS
TEG-MGBSX TEG-MGBS80...
User's Guide - Page 11
... damage or personal injury.
1-1 Some technologies refer to install and configure the TL2-E284 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots. 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Chapter 1
Preface
About This Guide
This guide provides instructions on how to terms "switch", "bridge" and...
User's Guide - Page 12
... will be restored to the port
2-1
24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Chapter 2
Product Introduction
Product Introduction
The TL2-E284 is no ready
Sequence
Definition
Solid Blinking
Off
100/200Mbps (Half/Full Duplex) Connected (per port)
100/200Mbps (Half/Full Duplex) Data Transmitting/Receiving (per...
User's Guide - Page 20
... Slots
Figure 9 - The name of a contact person. Default is TL2-E284. The duration that ranges from 1 to remove an existed account. Entering the device location description. User Account
This page is 600 seconds. Password of this device. System > System Information
Parameter Hardware Version Firmware Version Device Name Device Contact Device Location
Device Up Time...
User's Guide - Page 85
... first ensure that a valid connection is made through Telnet using your keyboard. User Name
Password
User EXEC Mode
guest
guest123
Privileged EXEC Mode admin
admin
Figure 103 -Connected to an end node via Ethernet cable
Privilege Levels
TL2-E284 support 15 user privilege levels for the Command Line Interface of the Switch and your...
User's Guide - Page 115
...}]
no form deletes the SNMP view. 24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Default Settings Command Modes
passwd priv DES passwd volatile nonvolatile
Authentication password Encryption password Store in volatile memory Store in nonvolatile memory
User
: initial
Authentication Protocol : None
Privacy Protocol
: None
Storage Type
: Non-volatile...
User's Guide - Page 133
...: 87:97:71:61:7f:72:c6:ae Signature Algorithm: sha1WithRSAEncryption Issuer: C=CA, L=Torrance, O=TRENDnet Validity Not Before: Aug 18 12:26:51 2009 GMT Not After : Aug 18 12:26:51 2011 GMT Subject: CN=TL2-E284 Subject Public Key Info: Public Key Algorithm: rsaEncryption RSA Public Key: (1024 bit) Modulus (1024...
User's Guide - Page 291
... on the outside of California.
These codes are responsible for their return policies.
24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
Limited Warranty
TRENDnet warrants its expense, to repair or replace the defective product or part and deliver an equivalent product or part to the customer. TL2-E284 - 3 Years Warranty AC/DC Power...
Quick Installation Guide - Page 3
... ŸTL2-E284 ŸMulti-Language Quick Installation Guide ŸCD-ROM (User's Guide) ŸRS-232 cable (3 m / 9.8 ft.) ŸPower Cord (1.8 m / 5.9 ft.) ŸRack Mount Kit
Installation Requirements
ŸWeb Browser: Internet Explorer (6.0 or higher) ŸA computer with a network adapter properly installed ŸCAT-5e or CAT-6 Network Cable ŸThe surface must support at least...
Quick Installation Guide - Page 4
....
2 Connect a Cat.5e or Cat.6 RJ-45 network cable from the computer to a power outlet.
2. Hardware Installation
Note: Note: The Mini-GBIC slots are disabled.
1. Verify that the following panel lights are on the TL2-E284.
3. When the Mini-GBIC slots are in use, port 25 and 26 Gigabit Ethernet ports are shared...
Quick Installation Guide - Page 7
.... (Refer to Troubleshooting section on your PC.) 2. Using Web Browser
1. By default: User Name: admin Password: admin
3. Before the Switch can be configured, a Static IP address must be assigned to configure TCP/IP settings on how to your web browser, type http://192.168.10.200 in the subnet of configuring the TL2-E284: Web...
Quick Installation Guide - Page 10
... For detailed information regarding the TL2-E284 configuration and advanced settings, please refer to register your product Online at http://www.trendnet.com. 2. Then press the Enter key.
4. Then Enter the Password and then press Enter. By default login : admin Password: admin If you for login.
Enter the User Name for choosing TRENDnet
8 Register Your Product To...
Quick Installation Guide - Page 12
.../ACT lights are the default port settings for configuring the Switch through the console port using HyperTerminal? Flow control: None.
5. Wait 15 seconds then let go to match your network's IP.
4. Windows Vista 1. If you still encounter problems or have any questions regarding the TL2-E284 please contact TRENDnet's Technical Support Department.
10 What are lit...
TRENDnet TL2-E284 Reviews
We have not received any reviews for TRENDnet yet.