User Manual (ENGLISH)
Page 69
...quality. • Use cut-sheet paper only. Do not use paper with nonflammable, heatresistant ink that was added after the paper was produced. • Preprinted forms must withstand the printer's fusing temperature of the same high quality as tabs or staples. • Do not attempt...through a photocopier. • Do not use paper with a coloured coating that do not melt, vaporize, or release hazardous emissions when subject to the printer's approximately 400°F (205°C) fusing temperature for 0.1 second. • Store paper in mind: • Attempting to print on damp, ...
...quality. • Use cut-sheet paper only. Do not use paper with nonflammable, heatresistant ink that was added after the paper was produced. • Preprinted forms must withstand the printer's fusing temperature of the same high quality as tabs or staples. • Do not attempt...through a photocopier. • Do not use paper with a coloured coating that do not melt, vaporize, or release hazardous emissions when subject to the printer's approximately 400°F (205°C) fusing temperature for 0.1 second. • Store paper in mind: • Attempting to print on damp, ...
User Manual (ENGLISH)
Page 86
...top of 400 °F (205 °C) for 0.1 second. • Ink on the paper is sent through the printer (paper that the ink on letterheads must be sealed in the figures below. During the fusing process, wet ink can come off preprinted paper. 1 Load letterheads into the tray you load ...to fit the width of the paper stack. Guidelines • Letterheads must be non-flammable and should not adversely affect any printer rollers. • Forms and letterheads should be printed with heat-resistant ink that will not melt, vaporize, or release hazardous emissions when subjected to the...
...top of 400 °F (205 °C) for 0.1 second. • Ink on the paper is sent through the printer (paper that the ink on letterheads must be sealed in the figures below. During the fusing process, wet ink can come off preprinted paper. 1 Load letterheads into the tray you load ...to fit the width of the paper stack. Guidelines • Letterheads must be non-flammable and should not adversely affect any printer rollers. • Forms and letterheads should be printed with heat-resistant ink that will not melt, vaporize, or release hazardous emissions when subjected to the...
User Manual (ENGLISH)
Page 225
... tray 250 sheets of 80 g/m2 bond paper Face-up rear output tray 100 sheet of thermography. • Do not use inks that are compatible with low-temperature inks, such as those used in .) Cut with sharp blades with no visible fray. Must not scorch, melt, offset, or release...temperature (200 °C or 392 °F for 0.1 second. Insure that any coloured paper or preprinted forms use raised or embossed letterhead. • The printer uses heat and pressure to fuse toner to 200 °C (392 °F) for 0.1 second). Paper Specifications Category Acid Content Caliper Curl in Ream Cut ...
... tray 250 sheets of 80 g/m2 bond paper Face-up rear output tray 100 sheet of thermography. • Do not use inks that are compatible with low-temperature inks, such as those used in .) Cut with sharp blades with no visible fray. Must not scorch, melt, offset, or release...temperature (200 °C or 392 °F for 0.1 second. Insure that any coloured paper or preprinted forms use raised or embossed letterhead. • The printer uses heat and pressure to fuse toner to 200 °C (392 °F) for 0.1 second). Paper Specifications Category Acid Content Caliper Curl in Ream Cut ...