NEC JC-1575VMA - MultiSync E500 - 15" CRT Display Support and Manuals
Get Help and Manuals for this NEC item
View All Support Options Below
Free NEC JC-1575VMA manuals!
Problems with NEC JC-1575VMA?
Ask a Question
Free NEC JC-1575VMA manuals!
Problems with NEC JC-1575VMA?
Ask a Question
Popular NEC JC-1575VMA Manual Pages
User Manual - Page 2
... or equivalent to part 15 of this unit has been included.
Use the attached specified cables with the JC-1575VMA and JC-1746UMA color monitors so as not to interfere with radio and television reception.
2. The user may cause harmful interference to provide reasonable protection against harmful interference in accordance with any problems.
Canadian Department of...
User Manual - Page 3
...
Your new NEC Technologies MultiSync® E Series monitor box* should contain the following:
• MultiSync E Series Monitor with tilt/swivel base MultiSync E500™, JC-1575VMA MultiSync E700™, JC-1746UMA
• Power Cord • Captive Signal Cable • User's Manual • Registration Card
Power Cord
NEC Enterprise Series
EMSuelrtiieSsync User's Manual
®®...
User Manual - Page 4
...NEC Technologies at (800) 820-1230. 4. Tighten all screws. Tighten all screws. NOTE: If you have any problems, please refer to the Troubleshooting section of the power cord to the MultiSync E Series monitor... your system, follow these instructions:
1. Connect one end of
this User's Manual. For more information,
refer to the display card manual. 3. Turn on the monitor (Figure D.1) and the ...
User Manual - Page 6
...the curvature or angle of the sides of the image. R, G, B: NEC's AccuColor Control System increases or decreases the monitor's red, green or blue color guns depending upon which is adjusted at the...of the controls. Increases or decreases the tilt of the sides either to the factory setting.
Increases or decreases the curvature of the image.
direction to the background. RESET
Resets ...
User Manual - Page 7
Indicates the frequency setting of the IPM System is demagnetized.
Off: The Off Mode of the monitor. Selecting ALL RESET allows you to reset all stages ...and affect the purity of energy savings are utilized.
Caution: Please allow a minimum of the Degauss Control. Individual settings can be reset by highlighting the control to be reset and pressing the RESET button.
78131861
5
7
5/21/...
User Manual - Page 8
... Maintenance
FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE MULTISYNC® E SERIES COLOR MONITOR:
• DO NOT OPEN THE MONITOR. There are no user serviceable parts inside and opening or removing covers may cause image discoloration. Do not put anything on may expose you to qualified service personnel under the following operating
instructions...
User Manual - Page 9
...monitor regularly. CHECK THE
FOLLOWING WHEN YOU POSITION THE MONITOR:
• Adjust the monitor height so that ceiling lights do not reflect on setting up a healthy work environment, call NEC at (800) 820-1230, NEC...non-abrasive cleaning solution or glass cleaner to minimize dust.
• Adjust the monitor's brightness and contrast controls to enhance readability.
• Use a document holder ...
User Manual - Page 10
..., dark-tint screen, Invar Shadow Mask and OptiClear® screen surface. TTL Level Horizontal sync. Specifications
Monitor Specifications
Picture Tube
Diagonal: Viewable Image Size:
Radius:
Input Signal
Video: Sync:
Display Colors
Analog input:
Synchronization Range
Horizontal: Vertical:
Resolutions Supported Resolution based on display card used.
31 kHz to 69 kHz 55 Hz to 120...
User Manual - Page 11
...frequencies only
Active Display Area (Factory Setting) Active Display Area (Full Scan...Monitor Specifications
Picture Tube
Diagonal: Viewable Image Size:
Radius:
Input Signal
Video: Sync:
Display Colors
Analog input:
Synchronization Range
Horizontal: Vertical:
Resolutions Supported...support
800 x 600 @ 55 to 120 Hz
all modes listed.
832 x 624 @ 55 to 120 Hz
1024 x 768 @ 55 to 100 Hz NEC...
User Manual - Page 12
...setup and installation by NEC Technologies, Inc.
78131861
10
12
5/21/98, 2:23 PM
Reduced Magnetic Field™ Technology: Reduces magnetic and alternating electric field emissions and static electricity, addressing ergonomic concerns regarding potential risks from extended computer monitor... blue) to use .
Phosphors appear elliptical when illuminated, resulting in screen images ...
User Manual - Page 13
... • If possible, position the front of User's Manual for bent or pushed-in pins.
CAUTION: A minimum interval of the monitor and your display card with respect to recommended timings and ...Adjust Brightness and Contrast Controls. • Access the Degauss Control through OSM™ controls. Troubleshooting
No picture • Display card should be completely seated in its slot. • ...
User Manual - Page 14
...; Customer Service/ Technical Support Fax
(800) 632-4662 (508) 635-4298
• Direct Sales
(800) 374-8000
• Electronic Channels:
Internet e-mail: tech-support@nectech.com Internet ftp site: ftp.nectech.com World Wide Web: http://www.nec.com
• FastFacts™ Information (800) 366-0476
INFORMATION
DESCRIPTION
DOCUMENT #
MultiSync® E500™ monitor
Detailed monitor...
User Manual - Page 15
... than a service facility authorized by NECTECH to the instructions contained in the User's Manual. Limited Warranty
NEC Technologies, Inc. (hereinafter "NECTECH"), warrants this Product to be free from defects in material and workmanship and, subject to the conditions set forth below, agrees to repair or replace any part of the enclosed unit which proves defective for a specific purpose or...
User Manual - Page 16
... Energy Star emblem does not represent EPA endorsement of any product or service.
78131861
16
Part No. 78131861 Printed in the U.S.
Responsible Party: NEC Technologies, Inc. No.:
(630) 775-7900
Type of Product: Equipment Classification: Models:
Computer Monitor Class B Peripheral JC-1575VMA and JC-1746UMA
We hereby declare that may cause undesired operation. MultiSync is a registered...
NEC JC-1575VMA Reviews
We have not received any reviews for NEC yet.