LiftMaster SL3000101U Support and Manuals
Get Help and Manuals for this LiftMaster item
View All Support Options Below
Free LiftMaster SL3000101U manuals!
Problems with LiftMaster SL3000101U?
Ask a Question
Free LiftMaster SL3000101U manuals!
Problems with LiftMaster SL3000101U?
Ask a Question
Popular LiftMaster SL3000101U Manual Pages
LiftMaster Gate Operator Feature Chart Manual - Page 1
... Expansion Board
-
3 years
Max. 2016 UL 325 LISTED GATE OPERATOR FEATURE CHART
Model Number
Description
Battery Backup Powers up when the
power's down Security+ 2.0® 3...Code Display2 Digit LED
Wireless Dual-Gate Operation
PosiLock® Feature
Fire Department Compliant
Electronic Limits Expansion Board Included (2) Aux Relays, Quick Close/
Anti-Tailgate Plug-in -class features, see specific...
LiftMaster Gate Operator Feature Chart Manual - Page 2
...Yes
Yes
Yes
Yes
Plug-in -class features, see specific product sell sheets at LiftMaster.com Yes
Yes
Yes
Yes
...lbs. 2016 UL 325 LISTED GATE OPERATOR FEATURE CHART
Model Number
ELITE® SERIES DC COMMERCIAL GATE OPERATORS
... Inputs (Main and 6 Inputs (Main and 6 Inputs (Main and (Color Coded) Expansion Board) Expansion Board) Expansion Board) Expansion Board) Expansion Board) Expansion...
SL3000101U Installation Manual - Page 1
ELITE SERIES COMMERCIAL HIGH-TRAFFIC
AC SLIDE GATE OPERATOR INSTALLATION MANUAL
Model SL3000U
SL3000101U
1 HP Single Phase
SL3000103U
1 HP Three Phase
SL3000501U
1/2 HP Single Phase
• THIS PRODUCT IS TO BE INSTALLED AND SERVICED BY A TRAINED GATE SYSTEMS TECHNICIAN ONLY.
• This model is for use on vehicular passage gates ONLY and not intended for use on...
SL3000101U Installation Manual - Page 2
...
EARTH GROUND ROD 14
POWER WIRING 14
DUAL GATES ONLY 16
INSTALL THE COVER 18
OBSTRUCTION TEST 18
BASIC TROUBLESHOOTING
19
SAFETY
SAFETY SYMBOL AND SIGNAL WORD REVIEW
When you see this manual and follow all safety instructions.
• DO NOT attempt repair or service of Serious Injury or Death if you do not comply with...
SL3000101U Installation Manual - Page 3
...is prevented via supervision by or servicing the general public. Read the owner's manual. RESIDENTIAL VEHICULAR GATE
OPERATOR
I...installer is not moving. • KEEP GATES PROPERLY MAINTAINED. CLASS IV- IMPORTANT SAFETY INFORMATION
To reduce the risk of INJURY or DEATH: • READ AND FOLLOW ALL INSTRUCTIONS... a qualified service person make repairs to gate hardware. • The ...
SL3000101U Installation Manual - Page 5
... the operator requires replacement, shall be upgraded to conform to the provisions of this specification in effect at ...designed, constructed and installed so as not to create an entrapment area between the gate and the supporting structure or other... disabled when a manually operated gate is retrofitted with a powered gate operator.
1.6 A gate latch shall not be installed on an automatically ...
SL3000101U Installation Manual - Page 7
... to 3 photoelectric sensors and up to 140°F) Provided Dual - RPM and Current Sense 3 inputs per board - INTRODUCTION
OPERATOR SPECIFICATIONS
This model is intended for ON + SW (switched) Model SL3000501U 1/2 HP: 1000 lbs. (453.6 kg) Model SL3000101U 1 HP: 2000 lbs. (907.2 kg) 4 feet (1.2 m) 52 feet (15.85 m) 1 foot/second Continuous Continuous Without Heater: -20...
SL3000101U Installation Manual - Page 12
... to the brackets using the eye bolt hardware. Manually open the gate and line up the rear bracket so the chain will require two extra idler pulleys. Route the chain through the operator.
5. INSTALLATION
STEP 3
ATTACH THE CHAIN
DO NOT run the operator until instructed. 1. Remove the pin from the vent plug on...
SL3000101U Installation Manual - Page 13
...in contact with an obstruction while the gate is aware of the Setup and Operation manual). Edge Sensor for Open Cycle
Edge Sensor for Open Cycle
Edge Sensor... in that direction until the obstruction is cleared. Monitored photoelectric sensors MUST be installed to gate movement. Sensors for Open Cycle
Monitored Photoelectric Sensors
ProIpnesridtye
PrOopuetsritdye
Sensors for...
SL3000101U Installation Manual - Page 14
... sensor entrapment protection for more information.
INSTALL ENTRAPMENT PROTECTION
There are for 4 seconds then stop. This input will function.
Additional entrapment protection devices may be wired to OPEN: gate reverses 4 seconds when it hits obstruction Switch set to the specific entrapment protection device manual for the close direction. Close Photoelectric...
SL3000101U Installation Manual - Page 15
... to service.
• Disconnect power at the fuse box BEFORE proceeding. If you install an edge sensor BEFORE proceeding with the operator. Install the earth ground rod within 3 feet of the power disconnect should cut the ground wire too short, break it, or destroy its integrity, replace it with national and local electrical codes. Run...
SL3000101U Installation Manual - Page 17
...
ProInpseirdtye
PrOopuetsritdye
16
WIRELESS DUAL GATES TO ACTIVATE THE WIRELESS FEATURE: 1. Press and release the LEARN button again on the second operator. INSTALLATION
STEP 7
DUAL GATES ONLY
There are set on either operator. Press and release the LEARN button on the primary operator. Press and release the LEARN button again on the...
SL3000101U Installation Manual - Page 18
... secondary control board (Com Link A to Com Link A and
Com Link B to Com Link B). INSTALLATION
STEP 7 continued... Ground the shield of the cable to 200 feet (61 m) 18AWG - 200-1000...local underground utility locating companies. NOTE: We
recommend that all accessories and board configurations are set on the primary gate operator control board. Connect the wires from the shielded twisted pair ...
SL3000101U Installation Manual - Page 19
.... If the gate does not reverse off the solid object, reduce the force setting by turning the force control slightly counter-clockwise. Repeat the test for a short time and then stop the gate. Refer to the Setup and Operation manual provided with a solid object.
4. The gate should have enough force to adjust the...
SL3000101U Installation Manual - Page 20
... Replace defective control board
01-37558
For complete operation and setup information refer to the Operation and Setup Manual ...provided with the operator or go to control board b) Open fuse c) Defective control board
a) Reset button is a normally closed circuit, or put a jumper on . All Rights Reserved
BASIC TROUBLESHOOTING...
LiftMaster SL3000101U Reviews
We have not received any reviews for LiftMaster yet.