KitchenAid KFGC558JSS Support and Manuals
Get Help and Manuals for this KitchenAid item
View All Support Options Below
Free KitchenAid KFGC558JSS manuals!
Problems with KitchenAid KFGC558JSS?
Ask a Question
Free KitchenAid KFGC558JSS manuals!
Problems with KitchenAid KFGC558JSS?
Ask a Question
KitchenAid KFGC558JSS Videos
KitchenAid KFGC558JSS Range
Duration: :36
Total Views: 31
Duration: :36
Total Views: 31
KitchenAid KFGC558JSS Cuisinière
Duration: :35
Total Views: 1
Duration: :35
Total Views: 1
Popular KitchenAid KFGC558JSS Manual Pages
Installation Instructions - Page 5
... codes. Parts Supplied Check that a 585 CFM (993.9 m3/hr) or larger range hood be installed above the range.
■ Follow the range hood or microwave hood combination installation instructions for dimensional clearances above . See "Cabinet Dimensions" in the wall or floor where range is the installer's responsibility to comply with installation clearances specified on griddle models...
Installation Instructions - Page 8
...a shut-off valve: Install a manual gas line shut-off gas...Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft... by a qualified service technician. Do not... (1.3 cm) male pipe thread is factory set for proper operation: Natural Gas: Minimum pressure:...model/serial/rating plate are not sure about the inlet pressure. The parts for elevations up to the...
Installation Instructions - Page 9
... the floor behind range.
Lay a piece of cardboard from range. Set range on top of oven. This surface should be flat and covered... Remove oven racks, and parts package from top of range. a. Kick plate b. Remove Kick Plate 1.
A. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. INSTALLATION INSTRUCTIONS
WARNING
Unpack the Range
2. ...
Installation Instructions - Page 12
...Care Guide.
...to the user instructions located in ...authorized service company...Install Griddle Tray
(On griddle models)
The griddle is plugged into anti-tip bracket.
3. Burner
A B
A. Place drip tray in place of the range and visually check that the gas shut-off valve in the gas line. Lower (simmer) flame
NOTE: Dual Stacked burner shown.
12 Open the manual shut-off valves are set...
Installation Instructions - Page 15
... "LP" are installed, remove them. 2. Open the oven door and remove the two screws on burner ratings and locations. Insert nut driver into the gas ...manual shut-off valve must be disconnected from the gas supply piping system during any pressure testing of 1/2 psi (3.5 kPa). Set gas orifice spud aside. See the "Propane Gas Orifice Spud/Hood Chart". Turn over -tighten.
8. Replace...
Installation Instructions - Page 18
... to help hold the gas orifice spud in plastic parts bag for illustration.
13. B
A
A
A. ... 1/4" (6.4 mm) nut driver to the end of bracket.
10. Bracket
7. Set gas orifice spud aside....driver while changing it. Insert nut driver into the gas opening, and press down on the clip on the electrode bracket. Install the Number 125 oven bake burner orifice spud.
9.
Replace...
Installation Instructions - Page 19
...2. Broil burner orifice hole
4. Replace the broil burner in the hole in plastic parts bag for illustration. Broil burner...driver, remove broil burner screw. Set aside with package containing literature.
6. B
C A. Install the Number 90 oven broil burner orifice spud.
5.
Set gas orifice spud aside. Bake burner cover
Convert Oven Broil Burner (30" [76.2 cm] and 36" [91.4 cm] models...
Installation Instructions - Page 22
...Install anti-tip bracket to remove or replace kick plate. To range B. A
A. NOTE: Do not remove the spring beneath the cap.
22 Refer to "Complete Installation" in order to floor or wall per installation instructions...manual to follow these instructions can tip the range and be removed in the "Installation Instructions...Turn the manual shut-off valve to adjust the "LO" setting for proper...
Installation Instructions - Page 23
...The range and its individual manual shut-off valve must be ...installed, remove them. 2. Replace burner cap. 9. Unplug range or disconnect power. 2. Apply masking tape to the regulator should be as follows for operation and checking the regulator setting...driver while changing it is snug to cooktop, do not have to leave the door open or the control console will not rest in plastic parts...
Installation Instructions - Page 24
...for the
appropriate burner on each burner individually.
7. Wire Tie
D. Flush with a lighter), and set it drop forward into place. Replace the burner grates.
24 Using a 1/8" x 4¼" (3.2 mm x 10.8 cm) flat ... race around the burner, the adjustment is too low and the screw should be lit manually with range top
10.
Low-turndown adjustment screw for the left of the range cooktop...
Installation Instructions - Page 27
... Insert nut driver into place. A
A. A
A
BC
A. Broil burner orifice C. Broil burner orifice hole
4. Replace the broil burner in the hole in plastic parts bag for ...with the hole when a click sounds.
27 Install the Number 148 oven broil burner orifice spud...models and the right oven cavity on 48" [121.9 cm] models)
1. Broil burner electrode hole
BC
7. Using a 1/4" (6.4 mm) nut driver...
Owners Manual - Page 4
... NOT
MOVE THE RANGE WHILE HOT. Do not repair or replace any part of a range - All other servicing should never be seriously injured.
During and after use . I Do Not Leave Children Alone - I Never Leave Surface Units Unattended at High Heat Settings - TO CHECK IF THE DEVICES ARE INSTALLED PROPERLY, SLIDE RANGE FORWARD, LOOK FOR ANTI-TIP...
Owners Manual - Page 16
... cannot be your guide and walk you ... Mode must be scanned or manually added. NOTE: If there ...setting until Sabbath Mode is exited.
Wi-Fi Connectivity and Remote Operation
Models are disabled so that no visible activity takes place when the oven door is opened. The control is capable of Apple Inc.
16 Download the app by using the KitchenAid™ app, available for the SAID code...
Owners Manual - Page 23
...174; Cooktop Cleaner or affresh® Cooktop Cleaning Wipes can also be adjusted, contact a trained repair specialist.
4. Replace burner cap. Use a straight pin. If the burner needs to be used. Burner
2. Clean...Clean clogged burner ports. If the burner still does not light, do not service the sealed burner yourself.
Do not use a wooden toothpick.
Do not enlarge or distort the port.
Owners Manual - Page 30
... blown or a circuit breaker has tripped. The range may help you want. Contact a trained repair specialist.
The range is not the proper size. A Delay Start has been set correctly. The function has not been entered. See the Installation Instructions for disabling.
Close the oven door all the way.
Surface burner flames are clogged.
The...
KitchenAid KFGC558JSS Reviews
We have not received any reviews for KitchenAid yet.