Installation Instructions
Page 1
... intruders faster. PrecisionLine RCR-50 Dual Technology Motion Sensor Installation Instructions Description The RCR detector combines range-controlled radar (RCR) technology with a passive infrared (PIR) system to increase false alarm immunity by a UL Listed alarm control panel. Both the RCR and PIR systems must be mounted in a corner or on a stable surface 7 to 9 feet (2.1 to possible false alarm sources such as: - This mode can be used for the Detector The detector can be triggered to set off an alarm, unless...
... intruders faster. PrecisionLine RCR-50 Dual Technology Motion Sensor Installation Instructions Description The RCR detector combines range-controlled radar (RCR) technology with a passive infrared (PIR) system to increase false alarm immunity by a UL Listed alarm control panel. Both the RCR and PIR systems must be mounted in a corner or on a stable surface 7 to 9 feet (2.1 to possible false alarm sources such as: - This mode can be used for the Detector The detector can be triggered to set off an alarm, unless...
Installation Instructions
Page 2
... to the detector location. 2. See Setting the Jumpers. 4. The detector can be free of insulation from the back cover. Strip 1/4 inch (6.4mm) of all static electricity before touching circuit boards or wear a grounding strap. 3. See Figure 3. 8. Line up with one of the base and snap the cover/electronic module firmly down on the circuit board. The green LED should light for safety...
... to the detector location. 2. See Setting the Jumpers. 4. The detector can be free of insulation from the back cover. Strip 1/4 inch (6.4mm) of all static electricity before touching circuit boards or wear a grounding strap. 3. See Figure 3. 8. Line up with one of the base and snap the cover/electronic module firmly down on the circuit board. The green LED should light for safety...
Installation Instructions
Page 3
... . ON = LED enabled (factory default) J4 PIR - Always test the unit after cleaning. Once the cover has been replaced, the green LED will illuminate for 25 seconds while the sensor warms up. After the green LED goes off, wait one minute and walk test the sensor. The detector is available from GE Security. Setting the Jumpers The detector provides jumpers to the sensor. See Figure 4. PrecisionLine RCR-50 In Radar-only mode: LED Status...
... . ON = LED enabled (factory default) J4 PIR - Always test the unit after cleaning. Once the cover has been replaced, the green LED will illuminate for 25 seconds while the sensor warms up. After the green LED goes off, wait one minute and walk test the sensor. The detector is available from GE Security. Setting the Jumpers The detector provides jumpers to the sensor. See Figure 4. PrecisionLine RCR-50 In Radar-only mode: LED Status...
Installation Instructions
Page 4
.... FCC ID: CGGAA2 Product Ordering Model Number RCR-50 Accessories SB01 Description Range-controlled radar, passive infrared detector with Part 15 of the FCC rules. Operation is subject to the following three conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. (3) Changes or modifications not expressly approved by...
.... FCC ID: CGGAA2 Product Ordering Model Number RCR-50 Accessories SB01 Description Range-controlled radar, passive infrared detector with Part 15 of the FCC rules. Operation is subject to the following three conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. (3) Changes or modifications not expressly approved by...