GE 60-880-95 - Security Wireless Mirror Optic PIR Motion Sensor Support and Manuals
Get Help and Manuals for this General Electric item
View All Support Options Below
Free GE 60-880-95 manuals!
Problems with GE 60-880-95?
Ask a Question
Free GE 60-880-95 manuals!
Problems with GE 60-880-95?
Ask a Question
Popular GE 60-880-95 Manual Pages
Installation Instructions - Page 1
...Part No. 60-880-95
Document Number: 466-1851 Rev. When this motion is set it on a shelf.
‰ For installations without pets, the required mounting height is free from a body as it in areas where door/window sensors exist. Install...trouble) to the control panel
Included with the sensor is a thin cardboard undercrawl mask and snap-in plastic masks (installed...2001
Installation Instructions
...
Installation Instructions - Page 2
... Hole Locations
Figure 4. Set the front cover aside. Use wall anchors and screws to block any detection pattern directed at the top (see Figure 5). IN G E R
S TE P 2: P U LL A W A Y
Figure 3. Figure 5. Opening the Sensor Housing
3. Re-install as desired after walk testing.
&$87,21
You must be free of all static electricity before touching circuit...
Installation Instructions - Page 3
... test mode, then turn on the sensitivity setting.
A
123 4 567 89
1 2...Installing Masks
After determining the full coverage area and performing the environment test, you may need or want to mask (block) certain parts of the walk test mode may change slightly depending on all static electricity before touching circuit boards or wear a grounding strap. See Figure 7 for initial setup...
Installation Instructions - Page 4
... static electricity before touching circuit boards or wear a grounding strap. 1. Maintenance
At least once a year, the sensor should be determined by removing the sensor cover.
5.
The actual transmitter range can be tested to the specific panel installation instructions for the application. Replace the sensor cover.
3. Replacing Batteries
When battery replacement is correct...
Installation Instructions - Page 5
Install a new battery in the transmitter circuit board, observing polarity (marked in battery bucket). Lithium Battery Disposal
Lithium batteries that location. ‰ If the replacement sensor functions, return the problem
sensor for correct response.
‰ Test a known good sensor at least 3 minutes before activating the walk test mode. Troubleshooting
Use the following guidelines if the...
Installation Instructions - Page 6
Specifications
Specifications
Compatibility: All ITI 319.5 MHz. can void the users' authority to the...176; to 140° F (-40° to 60° C) Operating relative humidity: 5% to 95% non-condensing Storage relative humidity: 95% maximum non-condensing
(up to 6 months) Dimensions: (L) 4.75" x (W) 2.60" x (D) 2.0"
Notices
These devices comply with part 15 of the FCC rules. ITI is a trademark...
GE 60-880-95 Reviews
We have not received any reviews for GE yet.